- 您现在的位置：买卖IC网 > PDF目录179918 > LTC2847CUHF#TR (LINEAR TECHNOLOGY CORP) Software-Selectable Multiprotocol Transceiver with Termination and 3.3V Digital Interface; Package: QFN; No of Pins: 38; Temperature Range: 0°C to +70°C PDF资料下载
参数资料
| 型号： | LTC2847CUHF#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | Buffer和线驱动 |
| 英文描述： | Software-Selectable Multiprotocol Transceiver with Termination and 3.3V Digital Interface; Package: QFN; No of Pins: 38; Temperature Range: 0°C to +70°C |
| 中文描述： | TRIPLE LINE TRANSCEIVER, PQCC38 |
| 封装： | 7 X 5 MM, PLASTIC, QFN-38 |
| 文件页数： | 6/20页 |
| 文件大小： | 239K |
| 代理商： | LTC2847CUHF#TR |
14
LTC2847
sn2847 2847fs
Figure 28. Charge Pump
Figure 27. V.35 Receiver Configuration
Figure 26. Typical V.35 Interface
APPLICATIO S I FOR ATIO
WU
UU
In V.28 mode, S3 is closed inside the LTC2847/LTC2845
which connects a 6k (R8) impedance to ground in parallel
with 20k (R5) plus 10k (R6) for a combined impedance of
5k as shown in Figure 25. Proper termination is only pro-
vided when the B input of the receivers is floating, since S1
of the LTC2847’s R2 and R3 receivers remains on in V.28
mode1. The noninverting input is disconnected inside the
LTC2847/LTC2845 receiver and connected to a TTL level
reference voltage to give a 1.4V receiver trip point.
V.35 Interface
A typical V.35 balanced interface is shown in Figure 26. A
V.35 differential generator with outputs A and B and
ground C is connected to a differential receiver with input
A
' connected to A, input B' connected to B, and ground C'
connected via the signal return to ground C. The V.35
interface requires a T or delta network termination at the
receiver end and the generator end. The receiver differen-
tial impedance measured at the connector must be
100
±10, and the impedance between shorted termi-
nals (A
' and B') and ground (C') must be 150
±15.
A
'
B
C
B
'
C
'
GENERATOR
BALANCED
INTERCONNECTING
CABLE
LOAD
CABLE
TERMINATION
RECEIVER
2847 F26
50
125
50
50
125
50
R3
124
R5
20k
LTC2847
RECEIVER
2847 F27
A
'
B
'
C
'
R1
51.5
R8
6k
S2
S3
R2
51.5
R6
10k
R7
10k
GND
R4
20k
S1
In V.35 mode, both switches S1 and S2 inside the LTC2847
are on, connecting a T network impedance as shown in
Figure 27. The 30k input impedance of the receiver is
placed in parallel with the T network termination, but does
not affect the overall input impedance significantly.
The generator differential impedance must be 50
to
150
and the impedance between shorted terminals (A
and B) and ground (C) must be 150
±15.
No-Cable Mode
The no-cable mode (M0 = M1 = M2 = 1) is intended for
the case when the cable is disconnected from the con-
nector. The charge pump, bias circuitry, drivers and
receivers are turned off, the driver outputs are forced into
a high impedance state, and the VCC supply current to the
transceiver drops to less than 300
A while its VIN supply
current drops to less than 10
A. Note that the LTC2847’s
R2 and R3 receivers continue to be terminated by a 103
differential impedance.
Charge Pump
The LTC2847 uses an internal capacitive charge pump to
generate VDD and VEE as shown in Figure 28. A voltage
doubler generates about 8V on VDD and a voltage inverter
generates about – 7.5V on VEE. Four 1F surface mounted
tantalum or ceramic capacitors are required for C1, C2, C3
and C5. The VEE capacitor C4 should be a minimum of
3.3
F.Allcapacitorsare16Vandshouldbeplacedasclose
as possible to the LTC2847 to reduce EMI.
Receiver Fail-Safe
All LTC2847/LTC2845 receivers feature fail-safe opera-
tion in all modes. If the receiver inputs are left floating or
are shorted together by a termination resistor, the receiver
output will always be forced to a logic high.
2847 F28
C3
1
F
C5
1
F
5V
C1
1
F
C2
1
F
C4
3.3
F
LTC2847
VDD
C1+
C1–
VCC
C2+
C2–
VEE
GND
+
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4252-2CMS#TRPBF | Negative Voltage Hot Swap Controllers; Package: MSOP; No of Pins: 10; Temperature Range: 0°C to +70°C |
| LTC4252-2IMS#PBF | Negative Voltage Hot Swap Controllers; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +85°C |
| LTC4252-2IMS#TRPBF | Negative Voltage Hot Swap Controllers; Package: MSOP; No of Pins: 10; Temperature Range: -40°C to +85°C |
| LTC4252A-1CMS#PBF | Negative Voltage Hot Swap Controllers; Package: MSOP; No of Pins: 10; Temperature Range: 0°C to +70°C |
| LTC4252A-1CMS#TRPBF | Negative Voltage Hot Swap Controllers; Package: MSOP; No of Pins: 10; Temperature Range: 0°C to +70°C |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2847IUHF | 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2847IUHF#PBF | 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1 系列:- 类型:线路收发器 驱动器/接收器数:5/3 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC 包装:Digi-Reel® 产品目录页面:918 (CN2011-ZH PDF) 其它名称:296-25096-6 |
| LTC2847IUHF#TR | 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2847IUHF#TRPBF | 功能描述:IC TXRX MULTIPROTOCOL 38-QFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2850CDD#PBF | 功能描述:IC TXRX RS485/RS422 8-DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:RS-232 & USB Transceiver 标准包装:2,000 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SSOP（0.209"，5.30mm 宽） 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:296-19849-2 |
发布紧急采购，3分钟左右您将得到回复。