参数资料
| 型号： | LTC2871IUHF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/36页 |
| 文件大小： | 0K |
| 描述： | IC TXRX RS485/RS422 38-QFN |
| 产品培训模块： | LTC2870 and LTC2871 Multi-Protocol Transceivers |
| 标准包装： | 52 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 3/3 |
| 规程： | RS232，RS422，RS485 |
| 电源电压： | 3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 管件 |
| 配用： | DC1786A-ND - BOARD DEMO LTC2871 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC2870/LTC2871
19
28701f
Overview
The LTC2870 and LTC2871 are flexible multiprotocol trans-
ceivers supporting RS485/RS422 and RS232 protocols.
These parts can be powered from a single 3V to 5.5V
supply with optional logic interface supply as low as 1.7V.
An integrated DC/DC converter provides the positive and
negative supply rails needed for RS232 operation. Auto-
matically selected integrated termination resistors for both
RS232 and RS485 protocols are included, eliminating the
need for external components and switching relays. Both
parts include loopback control for self-test and debug as
well as logically-switchable half- and full-duplex control
of the RS485 bus interface.
The LTC2870 offers a single port that can be configured
as either two RS232 receivers and drivers or one RS485/
RS422 receiver and driver depending on the state of the
485/232 pin. Control inputs DXEN and RXEN provide
independent control of driver and receiver operation for
either RS232 or RS485 transceivers, depending on the
selected operating protocol.
The LTC2871 separates the RS232 and RS485 transceivers
into independent I/Os allowing simultaneous operation
of two RS232 transceivers and one RS485 transceiver.
Independent control over driver and receiver mode for
each protocol is provided with logic inputs DX232, RX232,
DX485, RX485. Single channel RS232 operation is possible
via the CH2 control pin. The disabled channel maintains a
Hi-Z state on the receiver input and driver output, allowing
these lines to be shared with other transceivers.
Both parts feature rugged operation with ESD ratings
of ±26kV (LTC2870) and ±16kV (LTC2871) HBM on the
RS232 and RS485 receiver inputs and driver outputs, both
unpowered and powered. All other pins offer protection
exceeding ±4kV.
DC/DC Converter
The on-chip DC/DC converter operates from the VCC input,
generating a 7V VDD supply and a charge pumped –6.3V
VEE supply, as shown in Figure 13. VDD and VEE power
the output stage of the RS232 drivers and are regulated
to levels that guarantee greater than ±5V output swing.
The DC/DC converter requires a 10μH inductor (L1) and a
bypass capacitor (C4) of 2.2μF. The charge pump capacitor
(C1) is 220nF and the storage capacitors (C2 and C3) are
1μF. Larger storage capacitors up to 4.7μF may be used if
C1 and C4 are scaled proportionately. Locate C1–C4 close
to their associated pins.
Up to two LTC2870 or LTC2871 devices can be powered
from one of the devices; see Figure 48 in the Typical Ap-
plications section.
Inductor Selection
A 10μH inductor with a saturation current (ISAT) rating
of at least 220mA and a DCR (copper wire resistance) of
less than 1.3Ω is required. Some small inductors meeting
these requirements are listed in Table 12.
Table 12. Recommended Inductors
PART NUMBER
ISAT
(mA)
MAX
DCR (Ω)
SIZE(mm)
MANUFACTURER
LBC2016T100K
CBC2016T100M
245
380
1.07
2 × 1.6 × 1.6
Taiyo Yuden
www.t-yuden.com
FSLB2520-100K
220
1.1
2.5 × 2 × 1.6
Toko
www.tokoam.com
Capacitor Selection
The small size of ceramic capacitors makes them ideal
for the LTC2870 and LTC2871. Use X5R or X7R dielectric
types; their ESR is low and they retain their capacitance
over relatively wide voltage and temperature ranges. Use
a voltage rating of at least 10V.
APPLICATIONS INFORMATION
Figure 13. DC/DC Converter
28701 F13
3V TO 5.5V
C1
220nF
L1
10μH
C4
2.2μF
VCC
VDD
VEE
SW
CAP
C2
1μF
C3
1μF
PULSE-SKIPPING
BOOST
REGULATOR
f = 1.2MHz
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4213IDDB#TRPBF | IC CIRC BREAK ELEC 8-DFN |
| LTC4258CGW#TRPBF | IC POE 802.3AF QUAD 36-SSOP |
| LTC4259ACGW#TR | IC CTRLR POE QUAD AC DISC 36SSOP |
| LTC4264IDE#TRPBF | IC CNTRLR PD INTERFACE 12-DFN |
| LTC4266IGW#PBF | IC CTRLR IEEE 802.3AT 36-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC2872CUHF#PBF | 功能描述:IC LINEAR OP AMP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:* 产品培训模块:RS-232 & USB Transceiver 标准包装:2,000 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SSOP（0.209"，5.30mm 宽） 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:296-19849-2 |
| LTC2872CUHF#TRPBF | 功能描述:IC LINEAR OP AMP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:* 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2872IUHF#PBF | 功能描述:IC TRANSCEIVER RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:* 产品培训模块:RS-232 & USB Transceiver 标准包装:2,000 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SSOP（0.209"，5.30mm 宽） 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:296-19849-2 |
| LTC2872IUHF#TRPBF | 功能描述:IC RS232 TRANSCEIVER RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:* 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| LTC2874IFE#PBF | 制造商:Linear Technology 功能描述:IC CONTROLLER HOT SWAP 38TSSOP |
发布紧急采购，3分钟左右您将得到回复。