- 您现在的位置：买卖IC网 > PDF目录14206 > LTC3204BEDC-3.3#TR (Linear Technology)IC REG SWITCHD CAP DBL 3.3V 6DFN PDF资料下载
参数资料
| 型号： | LTC3204BEDC-3.3#TR |
| 厂商： | Linear Technology |
| 文件页数： | 9/12页 |
| 文件大小： | 0K |
| 描述： | IC REG SWITCHD CAP DBL 3.3V 6DFN |
| 标准包装： | 2,500 |
| 类型： | 切换式电容器（充电泵），倍增器 |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 3.3V |
| 输入电压： | 1.8 V ~ 4.5 V |
| PWM 型： | Burst Mode? |
| 频率 - 开关： | 1.2MHz |
| 电流 - 输出： | 50mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 6-DFN-EP（2x2） |
LTC3204-3.3/LTC3204-5/
LTC3204B-3.3/LTC3204B-5
APPLICATIO S I FOR ATIO
2
V IN
2.2μF
0.22μF
GND
R 0 L ( MIN ) =
2 V IN – V OUT 1
WHERE F OSC IS THE OSCILLATOR FREQUENCY (TYPICALLY
1.2MHZ) AND C OUT IS THE VALUE OF OUTPUT CHARGE STORAGE
CAPACITOR.
ALSO, THE VALUE AND STYLE OF THE OUTPUT CAPACITOR CAN SIGNI?-
CANTLY AFFECT THE STABILITY OF THE LTC3204-3.3/LTC3204-5/
LTC3204B-3.3/LTC3204B-5. AS SHOWN IN THE BLOCK
DIAGRAM, THE LTC3204-3.3/LTC3204-5/LTC3204B-
3.3/LTC3204B-5 USE A LINEAR CONTROL LOOP TO ADJUST
THE STRENGTH OF THE CHARGE PUMP TO MATCH THE CURRENT
REQUIRED AT THE OUTPUT. THE ERROR SIGNAL OF THIS LOOP IS
STORED DIRECTLY ON THE OUTPUT STORAGE CAPACITOR. THIS OUT-
PUT CAPACITOR ALSO SERVES TO FORM THE DOMINANT POLE OF
THE CONTROL LOOP. TO PREVENT RINGING OR INSTABILITY ON THE
LTC3204-3.3/LTC3204-5/LTC3204B-3.3/LTC3204B-5,
IT IS IMPORTANT TO MAINTAIN AT LEAST 1μF OF CAPACITANCE OVER
ALL CONDITIONS.
EXCESSIVE ESR ON THE OUTPUT CAPACITOR CAN DEGRADE THE LOOP
STABILITY OF THE LTC3204-3.3/LTC3204-5/LTC3204B-3.3/
LTC3204B-5. THE CLOSED LOOP OUTPUT RESISTANCE OF THE
LTC3204-5 IS DESIGNED TO BE 0.5 Ω . FOR A 100MA LOAD
CURRENT CHANGE, THE OUTPUT VOLTAGE WILL CHANGE BY ABOUT
50MV. IF THE OUTPUT CAPACITOR HAS 0.5 Ω OR MORE OF ESR,
THE CLOSED LOOP FREQUENCY RESPONSE WILL CEASE TO ROLL
OFF IN A SIMPLE ONE-POLE FASHION AND POOR LOAD TRANSIENT
RESPONSE OR INSTABILITY COULD RESULT. CERAMIC CAPACITORS
TYPICALLY HAVE EXCEPTIONAL ESR PERFORMANCE AND COMBINED
WITH A GOOD BOARD LAYOUT SHOULD YIELD VERY GOOD STABILITY
AND LOAD TRANSIENT PERFORMANCE.
AS THE VALUE OF C OUT CONTROLS THE AMOUNT OF OUTPUT RIPPLE,
THE VALUE OF C IN CONTROLS THE AMOUNT OF RIPPLE PRESENT AT
THE INPUT PIN (V IN ). THE INPUT CURRENT TO THE LTC3204-3.3/
LTC3204-5/LTC3204B-3.3/LTC3204B-5 WILL BE RELATIVELY
CONSTANT DURING THE INPUT CHARGING PHASE OR THE OUTPUT
CHARGING PHASE BUT WILL DROP TO ZERO DURING THE NONOVERLAP
TIMES. SINCE THE NONOVERLAP TIME IS SMALL (^25NS), THESE
MISSING NOTCHES WILL RESULT IN ONLY A SMALL PERTURBATION
ON THE INPUT POWER SUPPLY LINE. NOTE THAT A HIGHER ESR
CAPACITOR SUCH AS TANTALUM WILL HAVE HIGHER INPUT NOISE
DUE TO THE VOLTAGE DROP IN THE ESR. THEREFORE, CERAMIC
CAPACITORS ARE AGAIN RECOMMENDED FOR THEIR EXCEPTIONAL
ESR PERFORMANCE.
FURTHER INPUT NOISE REDUCTION CAN BE ACHIEVED BY POWERING
THE LTC3204-3.3/LTC3204-5/LTC3204B-3.3/LTC3204B-5
THROUGH A VERY SMALL SERIES INDUCTOR AS SHOWN IN FIGURE 3.
A 10NH INDUCTOR WILL REJECT THE FAST CURRENT NOTCHES,
THEREBY PRESENTING A NEARLY CONSTANT CURRENT LOAD TO THE
INPUT POWER SUPPLY. FOR ECONOMY, THE 10NH INDUCTOR CAN
BE FABRICATED ON THE PC BOARD WITH ABOUT 1CM (0.4") OF
PC BOARD TRACE.
1cm OF WIRE
10nH
V IN
LTC3204-3.3/
LTC3204-5
1
32005 F03
FIGURE 3. 10NH INDUCTOR USED FOR
ADDITIONAL INPUT NOISE REDUCTION
FLYING CAPACITOR SELECTION
WARNING: A POLARIZED CAPACITOR SUCH AS TANTALUM OR
ALUMINUM SHOULD NEVER BE USED FOR THE ?YING CAPACI-
TOR SINCE ITS VOLTAGE CAN REVERSE UPON START-UP OF THE
LTC3204-3.3/LTC3204-5/LTC3204B-3.3/LTC3204B-5.
LOW ESR CERAMIC CAPACITORS SHOULD ALWAYS BE USED FOR
THE ?YING CAPACITOR.
THE ?YING CAPACITOR CONTROLS THE STRENGTH OF THE CHARGE
PUMP. IN ORDER TO ACHIEVE THE RATED OUTPUT CURRENT, IT IS
NECESSARY TO HAVE AT LEAST 1μF OF CAPACITANCE FOR THE ?Y-
ING CAPACITOR.
FOR VERY LIGHT LOAD APPLICATIONS, THE ?YING CAPACITOR MAY BE
REDUCED TO SAVE SPACE OR COST. FROM THE ?RST ORDER APPROXI-
MATION OF R OL IN THE SECTION “EFFECTIVE OPEN-LOOP OUTPUT
RESISTANCE,” THE THEORETICAL MINIMUM OUTPUT RESISTANCE
OF A VOLTAGE DOUBLING CHARGE PUMP CAN BE EXPRESSED BY
THE FOLLOWING EQUATION:
?
I OUT F OSC ? C FLY
WHERE F OSC IS THE SWITCHING FREQUENCY (1.2MHZ) AND C FLY
IS THE VALUE OF THE ?YING CAPACITOR. THE CHARGE PUMP
WILL TYPICALLY BE WEAKER THAN THE THEORETICAL LIMIT DUE TO
ADDITIONAL SWITCH RESISTANCE. HOWEVER, FOR VERY LIGHT LOAD
APPLICATIONS, THE ABOVE EXPRESSION CAN BE USED AS A GUIDE-
LINE IN DETERMINING A STARTING CAPACITOR VALUE.
3204fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6865UK22D2L+T | IC MPU SUPERVISOR SOT23-5 |
| MAX6865UK22D1S+T | IC MPU SUPERVISOR SOT23-5 |
| LTC3204EDC-5#TRMPBF | IC REG SWITCHED CAP DBL 5V 6DFN |
| MAX6865UK22D1L+T | IC MPU SUPERVISOR SOT23-5 |
| LTC3204BEDC-5#TRM | IC REG SWITCHED CAP DBL 5V 6DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3204BEDC-5 | 制造商:Linear Technology 功能描述:Charge Pump STPUP 5V 150mA 6-Pin DFN EP |
| LTC3204BEDC-5#PBF | 制造商:Linear Technology 功能描述:DC-DC CONV BUCK/BOOST 1.2MHZ 制造商:Linear Technology 功能描述:DC-DC CONV, BUCK/BOOST, 1.2MHZ, 5V, 150mA, DFN-6; Primary Input Voltage:5.5V; No. of Outputs:1; Output Voltage:5V; Output Current:150mA; No. of Pins:6; Operating Temperature Min:85C; Operating Temperature Max:-40C ;RoHS Compliant: Yes |
| LTC3204BEDC-5#TR | 功能描述:IC REG SWITCHED CAP DBL 5V 6DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器（充电泵），反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型，TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR |
| LTC3204BEDC-5#TRM | 功能描述:IC REG SWITCHED CAP DBL 5V 6DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器（充电泵），反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型，TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR |
| LTC3204BEDC-5#TRMPBF | 功能描述:IC REG SWITCHED CAP DBL 5V 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
发布紧急采购，3分钟左右您将得到回复。