- 您现在的位置：买卖IC网 > PDF目录20898 > LTC3218EDDB#TRMPBF (Linear Technology)IC LED DRVR FLASH TORCH 10DFN PDF资料下载
参数资料
| 型号： | LTC3218EDDB#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/12页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR FLASH TORCH 10DFN |
| 标准包装： | 500 |
| 拓扑： | 升压（升压），切换式电容器（充电泵） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 闪灯/白光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 1MHz |
| 电源电压： | 2.9 V ~ 4.5 V |
| 输出电压： | 5.3V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN-EP（3x2） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
LTC3218
OPERATION
Charge Pump Strength
When the LTC3218 operates in 2x mode, the charge pump
can be modeled as a Thevenin-equivalent circuit to deter-
mine the amount of current available from the effective
input voltage and effective open-loop output resistance,
R OL (Figure 1).
R OL is dependent on a number of factors including the
oscillator frequency, ?ying capacitor values and switch
resistances. From Figure 1, we can see that the output
current is proportional to:
2V IN ? CPO
Mode Switching
The LTC3218 will automatically switch from 1x mode to
2x mode whenever the LED forward voltage approaches
the maximum CPO voltage for that mode. The part will
wait approximately 500μs before switching to the next
mode. This delay allows the LED to warm up and reduce
its forward voltage which may remove the dropout condi-
tion. The part may be reset to 1x mode by bringing the part
into shutdown by setting the ENF and ENT pins low. Once
these pins are low, either one or both may be immediately
brought high to re-enable the part.
R OL
(3)
in 2x mode.
+
–
2V IN
R OL
+
CPO
–
3218 F01
Figure 1. Charge Pump Open-Loop Thevenin-Equivalent Circuit
APPLICATIONS INFORMATION
V RIPPLE ( P ? P ) =
V IN , CPO Capacitor Selection
The value and type of capacitors used with the LTC3218
determine several important parameters such as regulator
control loop stability, output ripple, charge pump strength
and minimum start-up time.
To reduce noise and ripple, it is recommended that low
equivalent series resistance (ESR) ceramic capacitors be
used for both C VIN and C CPO . Tantalum and aluminum ca-
pacitors are not recommended because of their high ESR.
The value of C CPO directly controls the amount of output
ripple for a given load current. Increasing the size of C CPO
will reduce the output ripple at the expense of higher start-
up current. The peak-to-peak output ripple for 2x mode is
approximately given by the expression:
I OUT
2 f OSC ? C CPO
Where f OSC is the LTC3218’s oscillator frequency (typically
1MHz) and C CPO is the output storage capacitor.
Both the style and value of the output capacitor can sig-
ni?cantly affect the stability of the LTC3218. As shown in
the Block Diagram, the LTC3218 uses a control loop to
adjust the strength of the charge pump to match the cur-
rent required at the output. The error signal of this loop
is stored directly on the output charge storage capacitor.
The charge storage capacitor also serves as the dominant
pole for the control loop. To prevent ringing or instability,
it is important for the output capacitor to maintain at least
3μF of actual capacitance over all conditions.
Likewise, excessive ESR on the output capacitor will tend
to degrade the loop stability of the LTC3218. To prevent
poor load transient response and instability, the ESR of the
output capacitor should be kept below 80mΩ. Multilayer
ceramic chip capacitors typically have exceptional ESR
3218fb
8
相关PDF资料 |
PDF描述 |
|---|---|
| P51-100-S-L-I36-20MA-000-000 | SENSOR 100PSIS M10 4-20 MA |
| EBM11DSXN | CONN EDGECARD 22POS DIP .156 SLD |
| REC7.5-1212SRW/H1/A/M/SMD/CTRL | CONV DC/DC 7.5W 9-18VIN 12VOUT |
| REC3-1209SRW/H/B/M/SMD | CONV DC/DC 3W 9-18VIN 09VOUT |
| 5413 AMBER, 1 1/2 IN X 36 | TAPE POLYIMIDE FILM 1.5"X 36YD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3218EDDBTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:400mA Single Wire Camera LED Charge Pump |
| LTC3219 | 制造商:LINER 制造商全称:Linear Technology 功能描述:250mA Universal Nine Channel LED Driver |
| LTC3219EUD#PBF | 功能描述:IC LED DRIVR QVGA DISPLAY 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:60 系列:- 恒定电流:- 恒定电压:- 拓扑:线性（LDO），PWM，升压（升压） 输出数:8 内部驱动器:是 类型 - 主要:背光 类型 - 次要:RGB，白色 LED 频率:500kHz ~ 1.5MHz 电源电压:4.75 V ~ 26 V 输出电压:45V 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* 工作温度:-40°C ~ 85°C |
| LTC3219EUD#TRPBF | 功能描述:IC LED DRIVR QVGA DISPLAY 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LTC3219EUD-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:250mA Universal Nine Channel LED Driver |
发布紧急采购，3分钟左右您将得到回复。