- 您现在的位置：买卖IC网 > PDF目录44990 > LTC3406BES5-1.2#PBF (LINEAR TECHNOLOGY CORP) 1.3 A SWITCHING REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PDSO5 PDF资料下载
参数资料
| 型号： | LTC3406BES5-1.2#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1.3 A SWITCHING REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PDSO5 |
| 封装： | PLASTIC, MO-193, TSOT-23, 5 PIN |
| 文件页数： | 12/12页 |
| 文件大小： | 264K |
| 代理商： | LTC3406BES5-1.2#PBF |
9
LTC3406B-1.2
sn3406b12 3406b12fs
APPLICATIO S I FOR ATIO
WU
UU
1. The VIN quiescent current is due to two components:
the DC bias current as given in the electrical character-
istics and the internal main switch and synchronous
switch gate charge currents. The gate charge current
results from switching the gate capacitance of the
internal power MOSFET switches. Each time the gate is
switched from high to low to high again, a packet of
charge, dQ, moves from VIN to ground. The resulting
dQ/dt is the current out of VINthat is typically larger than
the DC bias current. In continuous mode, IGATECHG =
f(QT + QB) where QT and QB are the gate charges of the
internal top and bottom switches. Both the DC bias and
gate charge losses are proportional to VIN and thus
their effects will be more pronounced at higher supply
voltages.
2. I2R losses are calculated from the resistances of the
internal switches, RSW, and external inductor RL. In
continuous mode, the average output current flowing
through inductor L is “chopped” between the main
switch and the synchronous switch. Thus, the series
resistance looking into the SW pin is a function of both
top and bottom MOSFET RDS(ON) and the duty cycle
(DC) as follows:
RSW = (RDS(ON)TOP)(DC) + (RDS(ON)BOT)(1 – DC) (2)
The RDS(ON) for both the top and bottom MOSFETs can
be obtained from the Typical Performance Charateristics
curves. Thus, to obtain I2R losses, simply add RSW to
RL and multiply the result by the square of the average
output current.
Other losses including CIN and COUT ESR dissipative
losses and inductor core losses generally account for less
than 2% total additional loss.
Thermal Considerations
In most applications the LTC3406B-1.2 does not dissi-
pate much heat due to its high efficiency. But, in applica-
tions where the LTC3406B-1.2 is running at high ambient
temperature with low supply voltage, the heat dissipated
may exceed the maximum junction temperature of the
part. If the junction temperature reaches approximately
150°C, both power switches will be turned off and the SW
node will become high impedance.
To avoid the LTC3406B-1.2 from exceeding the maximum
junction temperature, the user will need to do some
thermal analysis. The goal of the thermal analysis is to
determine whether the power dissipated exceeds the
maximum junction temperature of the part. The tempera-
ture rise is given by:
TR = (PD)(θJA)
where PD is the power dissipated by the regulator and θJA
is the thermal resistance from the junction of the die to the
ambient temperature.
The junction temperature, TJ, is given by:
TJ = TA + TR
where TA is the ambient temperature.
As an example, consider the LTC3406B-1.2 with an input
voltage of 2.7V, a load current of 600mA and an ambient
temperature of 70°C. From the typical performance graph
of switch resistance, the RDS(ON) at 70°C is approximately
0.52 for the P-channel switch and 0.42 for the
N-channel switch. Using equation (2) to find the series
resistance looking into the SW pin gives:
RSW = 0.52(0.44) + 0.42(0.56) = 0.46
Therefore, power dissipated by the part is:
PD = ILOAD2 RSW = 165.6mW
For the SOT-23 package, the θJA is 250°C/ W. Thus, the
junction temperature of the regulator is:
TJ = 70°C + (0.1656)(250) = 111.4°C
which is below the maximum junction temperature of
125°C.
Note that at higher supply voltages, the junction tempera-
ture is lower due to reduced switch resistance (RSW).
Checking Transient Response
The regulator loop response can be checked by looking at
the load transient response. Switching regulators take
several cycles to respond to a step in load current. When
a load step occurs, VOUT immediately shifts by an amount
equal to (ILOAD ESR), where ESR is the effective series
resistance of COUT. ILOAD also begins to charge or
discharge COUT, which generates a feedback error signal.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3407AEMSE#TR | 1.25 A DUAL SWITCHING CONTROLLER, 1800 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3407AEDD#TR | 1.25 A DUAL SWITCHING CONTROLLER, 1800 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3410ESC6-1.8 | 0.63 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3410ESC6-1.5 | 0.63 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3410ESC6-1.65 | 0.63 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3406BES5TRMPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 5.5V TSOT23-5 |
| LTC3406ES5 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.5V to 5.5V 5-Pin TSOT-23 |
| LTC3406ES5#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.5V to 5.5V 5-Pin TSOT-23 制造商:Linear Technology 功能描述:IC DC-DC CONV 1.5 MHz 5-SOT-23 制造商:Linear Technology 功能描述:BUCK 5.5VIN 1.5MHZ 0.6A 5TSOT23 制造商:Linear Technology 功能描述:BUCK, 5.5VIN, 1.5MHZ, 0.6A, 5TSOT23 制造商:Linear Technology 功能描述:IC, DC-DC CONV, 1.5 MHz, 5-SOT-23; Primary Input Voltage:5.5V; No. of Outputs:1; Output Voltage:600mV; Output Current:600mA; No. of Pins:5; Operating Temperature Min:-40C; Operating Temperature Max:85C; Package / Case:5-SOT-23 ;RoHS Compliant: Yes |
| LTC3406ES5#TR | 功能描述:IC REG BUCK SYNC ADJ TSOT23-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3406ES5#TRM | 功能描述:IC REG BUCK SYNC ADJ TSOT23-5 RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。