- 您现在的位置：买卖IC网 > Datasheet目录338 > LTC3452EUF#TRPBF (Linear Technology)IC LED DRIVER PHOTO FLASH 20-QFN Datasheet资料下载
参数资料
| 型号： | LTC3452EUF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVER PHOTO FLASH 20-QFN |
| 标准包装： | 2,500 |
| 拓扑： | PWM，降压（降压），升压（升压） |
| 输出数： | 7 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光，闪灯/白光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 900kHz ~ 1.1MHz |
| 电源电压： | 2.7 V ~ 5.5 V |
| 输出电压： | 4.5V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-WFQFN 裸露焊盘 |
| 供应商设备封装： | 20-QFN 裸露焊盘（4x4） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
LTC3452
OPERATIO
duty cycle DC 4SW . The input voltage V IN where the four
switch region begins is given by:
Overtemperature Protection
If the junction temperature of the LTC3452 exceeds 130 ° C
V IN =
V OUT
1 – ( 150 ns ? f )
for any reason, all four switches are shut off immediately.
The overtemperature protection circuit has a typical hys-
teresis of 11 ° C.
and the input voltage V IN where the four switch region
ends is given by:
V IN = V OUT ? [ 1 – ( 150 ns ? f ) ]
Boost Mode (V IN < V OUT )
In boost mode, switch A is always on and switch B is
always off. Referring to Figure 2, when the control voltage
V C is above voltage V3, switches C and D will alternate
conducting similar to a typical synchronous boost regula-
tor. The maximum duty cycle of the converter is limited to
88% typical and is reached when V C is above V4.
Forward Current Limit
If the current delivered from V IN through PMOS switch A
exceeds 1600mA (typical), switch A is shut off immedi-
ately. Switches B and D are turned on for the remainder of
the cycle in order to safely discharge the forward inductor
current at the maximum rate possible.
Reverse Current Limit
If the current delivered from V OUT backwards through
PMOS switch D exceeds 200mA (typical), switch D is shut
off immediately. Switches A and C are turned on for the
remainder of the cycle in order to safely discharge the
reverse inductor current at the maximum rate possible.
Undervoltage Lockout
To prevent operation of the power switches at high R DS(ON) ,
an undervoltage lockout is incorporated on the LTC3452.
When the input supply voltage drops below approximately
1.9V, the four power switches and all control circuitry are
Soft-Start
The LTC3452 includes an internally fixed soft-start which
is active when powering up or coming out of shutdown.
The soft-start works by clamping the voltage on the V C
node and gradually releasing it such that it requires 650 μ s
to linearly slew from 0.9V to 2.1V. This has the effect of
limiting the rate of duty cycle change as V C transitions
from the buck region through the buck-boost region into
the boost region. Once the soft-start times out, it can only
be reset by entering shutdown, or by an undervoltage or
overtemperature condition.
Main Error Amp
The main error amplifier is a transconductance amplifier
with source and sink capability. The output of the main
error amplifier drives a capacitor to GND at the V C pin. This
capacitor sets the dominant pole for the regulation loop.
(See the Applications Information section for selecting the
capacitor value.) The error amp gets its feedback signal
from a proprietary circuit which monitors all 7 LED current
sources to determine which LED to close the regulation
loop on.
Safety Error Amp
The safety error amplifier is a transconductance amplifier
with sink only capability. In normal operation, it has no
effect on the loop regulation. However, if any of the LED
pins open-circuits, the output voltage will keep rising, and
safety error amp will eventually take over control of the
regulation loop to prevent V OUT runaway. The V OUT thresh-
old at which this occurs is approximately 4.5V.
turned off except for the undervoltage block, which draws
only a few microamperes.
3452f
9
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3453EUF#TRPBF | IC LED DRIVER PHOTO FLASH 16-QFN |
| LTC3454EDD#TRPBF | IC LED DRIVER PHOTO FLASH 10-DFN |
| LTC3490EDD#PBF | IC LED DRIVER PHOTO FLASH 8-DFN |
| LTC3783EFE#PBF | IC LED DRVR PWM CONTROL 16-TSSOP |
| LV5026MC-AH | IC LED DRIVER 1CH HV 10SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3453 | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump |
| LTC3453EUF | 制造商:Linear Technology 功能描述:LED DRVR 4Segment 3.3V/5V 16-Pin QFN EP |
| LTC3453EUF#PBF | 功能描述:IC LED DRIVER PHOTO FLASH 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LTC3453EUF#TRPBF | 功能描述:IC LED DRIVER PHOTO FLASH 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LTC3454 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1A Synchronous Buck-Boost High Current LED Driver |
发布紧急采购，3分钟左右您将得到回复。