- 您现在的位置：买卖IC网 > PDF目录1830 > LTC3527EUD-1#TRPBF (Linear Technology)IC REG BOOST SYNC ADJ DL 16QFN PDF资料下载
参数资料
| 型号： | LTC3527EUD-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/22页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST SYNC ADJ DL 16QFN |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 1.6 V ~ 5.25 V |
| 输入电压： | 0.5 V ~ 5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 1.2MHz，2.2MHz |
| 电流 - 输出： | 400mA，800mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-QFN-EP（3x3） |
LTC3527/LTC3527-1
OPERATION
output until it reaches the nominal regulation value, then
the LTC3527/LTC3527-1 transition to sleep mode where
the outputs are off and the LTC3527/LTC3527-1 consume
only 12μA of quiescent current from the higher of V OUT1 or
V OUT2 . When the output voltage droops slightly, switching
resumes. This maximizes ef?ciency at very light loads by
minimizing switching and quiescent current losses. Burst
Mode output voltage ripple, which is typically 1% peak-to-
peak, can be reduced by using more output capacitance
(10μF or greater), or with a small capacitor (15pF) con-
nected between V OUT1 (V OUT2 ) and FB1 (FB2).
If either load current increases, the LTC3527/LTC3527-1
will automatically leave Burst Mode operation. Note that
larger output capacitor values may cause this transition
to occur at lighter loads. Once the LTC3527/LTC3527-1
have left Burst Mode operation and returned to normal
operation, they will remain there until both output loads
are reduced below the burst threshold current.
Burst Mode operation is inhibited during start-up and soft-
start and until both V OUT1 and V OUT2 are at least 0.24V
greater than V IN if neither channel is in shutdown.
When the MODE pin is high, LTC3527/LTC3527-1 feature
continuous PWM ?xed frequency operation at 1.2MHz
(FSEL = Low) or 2.2MHz (FSEL = High). At very light
loads, the LTC3527/LTC3527-1 will exhibit pulse-skipping
operation.
Single Cell to 5V Step-Up Applications
Due to the high inductor current slew rate in applica-
tions boosting to 5V from a single-cell (alkaline, NiCd
or NiMH), the LTC3527/LTC3527-1 may not enter Burst
Mode operation at input voltages below 1.5V in a 2.2MHz
application (FSEL = high). For a single-cell to 5V appli-
cation requiring Burst Mode 1.2MHz operation, (FSEL =
low) is recommended. Refer to the Typical Performance
Characteristics for the Burst Mode thresholds for different
input and output voltages.
APPLICATIONS INFORMATION
V IN > V OUT Operation
The LTC3527/LTC3527-1 will maintain output voltage
regulation even when the input voltage is above one or
both of the desired output voltages. Note, all V INS must
be common to support this mode of operation. Since
this mode is less ef?cient and will dissipate more power
in the LTC3527/LTC3527-1, the maximum output current
capability is limited in order to maintain an acceptable
junction temperature. When operating with V IN > V OUT
the power is de?ned by:
P OUT = I OUT ?? ( V IN + 1 . 5 ) ? V OUT ??
To maintain a junction temperature below 125°C, the fol-
lowing formula must be adhered to:
( P OUT 1 + P OUT 2 ) 68 ° C / W = 125 ? T A
Short-Circuit Protection
The LTC3527/LTC3527-1 output disconnect feature allows
an output short-circuit while maintaining a maximum in-
ternally set current limit. The converters also incorporate
internal features such as current limit foldback and thermal
shutdown for protection from an excessive overload or
short circuit. To reduce power dissipation under short-
circuit conditions, the peak switch current limit is reduced
to 500mA (typical) for converter 1 and 350mA (typical)
for converter 2 when V OUT is less than 1V.
Schottky Diode
Although it is not required, adding a Schottky diode from
SW1 (SW2) to V OUT1 (V OUT2 ) will improve ef?ciency by
about 2%. Note that this defeats the output disconnect
and short-circuit protection features.
where T A is the ambient temperature.
35271fc
12
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3528EDDB#TRPBF | IC REG BOOST SYNC ADJ 1A 8DFN |
| LTC3529EDCB#TRPBF | IC REG BOOST SYNC 5V 1.5A 8DFN |
| LTC3530EMS#TRPBF | IC REG BUCK BST SYNC 0.6A 10MSOP |
| LTC3531ES6-3.3#TRPBF | IC REG BUCK BST SYNC 3.3V TSOT23 |
| LTC3532EDD#TRPBF | IC REG BUCK BOOST SYNC ADJ 10DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3527EUD-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA/400mA, 1.2MHz/2.2MHz Synchronous Step-Up DC/DC Converters |
| LTC3527EUD-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA/400mA, 1.2MHz/2.2MHz Synchronous Step-Up DC/DC Converters |
| LTC3527EUD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA/400mA, 1.2MHz/2.2MHz Synchronous Step-Up DC/DC Converters |
| LTC3528 | 制造商:LINER 制造商全称:Linear Technology 功能描述:400mA Step-Up DC/DC Converter with Maximum Power Point Control and 250mV Start-Up |
| LTC3528-2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1A, 2MHz Synchronous Step-Up DC/DC Converter in 2mm × 3mm DFN |
发布紧急采购，3分钟左右您将得到回复。