参数资料
型号: LTC3589EUJ#PBF
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: SWITCHING REGULATOR, 2600 kHz SWITCHING FREQ-MAX, PQCC40
封装: 6 X 6 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-40
文件页数: 24/46页
文件大小: 570K
代理商: LTC3589EUJ#PBF
LTC3589/LTC3589-1
30
3589fc
Figure12showsthestart-uptimingfortheapplicationshown
in Figure 11. There is a 200μs (typical) delay between the
enable pin and the internal enable signal to each regulator.
Depending on settings in I2C system control register 2
(SCR2), a regulator’s output must discharge to less than
300mV before it will respond to its enable. The output
discharge feature is to guarantee proper start-up sequenc-
ing. This feature and the 2.5k pull-down resistors may be
overridden by bit settings in command register SCR2.
OPERATION
Figure 11. Pin-Strap Start-Up Sequence Application Circuit
3589 F11
EN1
EN2
EN3
EN4
EN_LDO2
EN_LDO34
ON
PWR_ON
LTC3589
PWR_ON
WAKE
SW1
SW2
SW3
BB_OUT
LDO2
LDO3
LDO4
1V TO 1.2V
1.8V
0.8V TO 1V
3.3V
1.2V
1.8V
2.8V
ON(PB)
PBSTAT
FAULT
WAKE
PWR_ON
CLIRQ
IRQ
3589 F10
μC/μP CONTROL
<1 SEC
Figure 10. Hard Reset Due to a Fault Condition
ENABLE AND POWER-ON SEQUENCING
Enable Input Pin Operation
The regulator enable input pins facilitate pin-strapping an
output rail to the enable pin of the next regulator in the
desired sequence. The regulator enable inputs normally
have a 0.8V (typical) input threshold. If any enable is driven
HIGH, the remaining enable input thresholds switch to a
more accurate 500mV (typical) threshold.
Figure 11 shows an application circuit for a typical pin-
strapped start-up sequence. Holding ON LOW for 400ms
brings up the WAKE pin that is tied to EN1 and EN3 to en-
able step-down switching regulators 1 and 3. The output of
regulator 1 is tied to EN2 and EN4 that enables step-down
switchingregulator2andthebuck-boostswitchingregulator
4. The output of step-down switching regulator 2 is tied to
EN_LDO2 and EN_LDO3 to enable LDO2, LDO3 and LDO4.
WithinfivesecondsofWAKEgoingHIGH,themicroprocessor
ormicrocontrollermustdrivePWR_ONHIGHtotellLTC3589
that rails are good and to stay in the power-on state.
Figure 6. Power-Up Using the Pushbutton
PBSTAT
WAKE
PWR_ON
3589 F06
ON(PB)
μC/μP CONTROL
400ms
<5 SEC
PBSTAT
WAKE
PWR_ON
3589 F07
ON(PB)
μC/μP CONTROL
50ms - LTC3589
2ms - LTC3589-1
50ms
<5 SEC
PBSTAT
WAKE
PWR_ON
3589 F08
ON(PB)
μC/μP CONTROL
50ms
5 SEC
50ms - LTC3589
2ms - LTC3589-1
Figure 9. Hard Reset Using the Pushbutton
PBSTAT
WAKE
PWR_ON
RSTO
3589 F09
ON(PB)
μC/μP CONTROL
50ms
1 SEC
5 SEC
Figure 7. Power Down Using Pushbutton
Figure 8. Power-Up and Down Using PWR_ON Pin
相关PDF资料
PDF描述
LS5540-9PDDTB1 2-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE
LQN-1.5/50-D12H DC-DC REG PWR SUPPLY MODULE
LSN-3.3/10-D12BH DC-DC REG PWR SUPPLY MODULE
LSN-3.3/10-D12B DC-DC REG PWR SUPPLY MODULE
LTC3554EPD#TRPBF 0.6 A BATTERY CHARGE CONTROLLER, 2590 kHz SWITCHING FREQ-MAX, PQCC20
相关代理商/技术参数
参数描述
LTC3589EUJ-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:8-Output Regulator with Sequencing and I2C
LTC3589HUJ#PBF 功能描述:IC DC/DC CONV 8-OUTPUT 40QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 应用:热电冷却器 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SOIC(0.173",4.40mm 宽)裸露焊盘 供应商设备封装:28-TSSOP 裸露焊盘 包装:管件 产品目录页面:1410 (CN2011-ZH PDF)
LTC3589HUJ#TRPBF 功能描述:IC DC/DC CONV 8-OUTPUT 40QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP(4x4) 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR
LTC3589HUJ-1#PBF 功能描述:IC CONV DC/DC 8-OUTPUT 40QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP(4x4) 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR
LTC3589HUJ-1#TRPBF 功能描述:IC CONV DC/DC 8-OUTPUT 40QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP(4x4) 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR