- 您现在的位置：买卖IC网 > PDF目录13969 > LTC3600IDD#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 1.5A 12DFN PDF资料下载
参数资料
| 型号： | LTC3600IDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1.5A 12DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0 V ~ 14.5 V |
| 输入电压： | 4 V ~ 15 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 12-DFN（3x3） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3600
OPERATION
3.6 ? 10 10 (1/ F)
MainControlLoop
The LTC3600 is a current mode monolithic step down
regulator. The accurate 50μA current source on the ISET pin
allows the user to use just one external resistor to program
the output voltage in a unity gain buffer fashion. In normal
operation, the internal top power MOSFET is turned on for
a fixed interval determined by a fixed one-shot timer OST.
When the top power MOSFET turns off, the bottom power
MOSFET turns on until the current comparator I CMP trips,
restarting the one-shot timer and initiating the next cycle.
Inductor current is determined by sensing the voltage
drop across the SW and PGND nodes of the bottom power
MOSFET. The voltage on the ITH pin sets the comparator
threshold corresponding to inductor valley current. The
error amplifier, EA, adjusts this ITH voltage by comparing
the V OUT voltage with the voltage on ISET. If the load current
increases, it causes a drop in the V OUT voltage relative to
V ISET . The ITH voltage then rises until the average inductor
current matches that of the load current.
At low load current, the inductor current can drop to zero
and become negative. This is detected by current rever-
sal comparator, I REV , which then shuts off the bottom
power MOSFET, resulting in discontinuous operation.
Both power MOSFETs will remain off with the output
capacitor supplying the load current until the ITH voltage
rises above the zero current level (0.8V) to initiate another
cycle. Discontinuous mode operation is disabled by tying
the MODE pin to INTV CC , which forces continuous syn-
chronous operation regardless of output load.
The operating frequency is determined by the value of the R T
resistor, which programs the current for the internal oscilla-
tor as well as the current for the internal one-shot timer. An
internal phase-locked loop servos the switching regulator
on-time to track the internal oscillator to force constant
switching frequency. If an external synchronization clock is
present on the MODE/SYNC pin, the regulator on-time and
switching frequency would then track the external clock.
Overvoltage and undervoltage comparators OV and UV
pull the PGOOD output low if the output power good
feedback voltage V PGFB exits a 7.5% window around the
regulation point. Continuous operation is forced during
an OV condition. To defeat the PGOOD function, simply
tie PGFB to INTV CC .
Pulling the RUN pin to ground forces the LTC3600 into
its shutdown state, turning off both power MOSFETs and
all of its internal control circuitry. Bringing the RUN pin
above 0.7V turns on the internal reference only, while still
keeping the power MOSFETs off. Further increasing the
RUN voltage above 1.5V turns on the entire chip.
INTV CC Regulator
An internal low drop out (LDO) regulator produces the
5V supply that powers the drivers and the internal bias
circuitry. The INTV CC can supply up to 50mA RMS and
must be bypassed to ground with a minimum of 1μF ce-
ramic capacitor. Good bypassing is necessary to supply
the high transient currents required by the power MOSFET
gate drivers. Applications with high input voltage and high
switching frequency will increase die temperature because
of the higher power dissipation across the LDO. Connect-
ing a load to the INTV CC pin is not recommended since
it will further push the LDO into its RMS current rating
while increasing power dissipation and die temperature.
V IN Overvoltage Protection
In order to protect the internal power MOSFET devices
against transient voltage spikes, the LTC3600 constantly
monitors the V IN pin for an overvoltage condition. When
V IN rises above 16V, the regulator suspends operation by
shutting off both power MOSFETs and discharges the ISET
pin voltage to ground. Once V IN drops below 15V, the regu-
lator immediately resumes normal switching operation by
first charging up the ISET pin to its programmed voltage.
Programming Switching Frequency
Connecting a resistor from the RT pin to GND programs
the switching frequency from 200kHz to 4MHz according
to the following formula:
Frequency (Hz) =
R T (?)
For ease of use, the RT pin can be connected directly to
the INTV CC pin for 1MHz operation. Do not float the RT pin.
The internal on-time phase-locked loop has a synchroni-
zation range of 30% around its programmed frequency.
Therefore, during external clock synchronization, the proper
3600fc
10
相关PDF资料 |
PDF描述 |
|---|---|
| V110B15C150BF3 | CONVERTER MOD DC/DC 15V 150W |
| LT1172IS8#TRPBF | IC REG MULTI CONFIG ADJ 8SOIC |
| V110B15C150BF2 | CONVERTER MOD DC/DC 15V 150W |
| V110B15C150BF | CONVERTER MOD DC/DC 15V 150W |
| LT1172IS8#TR | IC REG MULTI CONFIG ADJ 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3600IMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 12MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3600IMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 12MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3601EMSE#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3601EMSE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LTC3601EUD#PBF | 功能描述:IC REG BUCK SYNC ADJ 1.5A 16QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
发布紧急采购，3分钟左右您将得到回复。