参数资料
| 型号： | LTC3610IWP#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 12A 64QFN |
| 标准包装： | 40 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 24 V |
| 输入电压： | 4 V ~ 24 V |
| PWM 型： | 电流模式 |
| 电流 - 输出： | 12A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-VFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 64-QFN（9x9） |
LTC3610
PIN FUNCTIONS
PGND (Pins 1, 2, 3, 56, 57, 58, 59, 60, 61, 62, 63, 64,
65): Power Ground. Connect this pin closely to the (–)
terminal of C VCC and the (–) terminal of C IN .
SW (Pins 4, 5, 6, 7, 8, 9, 10, 11, 26, 55, 66): Switch
Node Connection to the Inductor. The (–) terminal of the
bootstrap capacitor C B also connects here. This pin swings
from a diode voltage drop below ground up to V IN .
PV IN (Pins 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22,
23, 24, 25, 67): Main Input Supply. Decouple this pin to
power PGND with the input capacitance C IN .
NC (Pin 27): No Connection.
SGND (Pins 28, 31, 32, 33, 34, 40, 42, 45, 46, 47, 48,
49, 50, 68): Signal Ground. All small-signal components
and compensation components should connect to this
ground, which in turn connects to PGND at one point.
BOOST (Pin 29): Boosted Floating Driver Supply. The
(+) terminal of the bootstrap capacitor C B connects here.
This pin swings from a diode voltage drop below INTV CC
up to V IN + INTV CC .
RUN/SS (Pin 30): Run Control and Soft-Start Input. A
capacitor to ground at this pin sets the ramp time to full
output current (approximately 3s/μF) and the time delay
for overcurrent latchoff (see Applications Information).
Forcing this pin below 0.8V shuts down the device.
V ON (Pin 35): On-Time Voltage Input. Voltage trip point for
the on-time comparator. Tying this pin to the output volt-
age or an external resistive divider from the output makes
the on-time proportional to V OUT . The comparator input
defaults to 0.7V when the pin is grounded and defaults to
2.4V when the pin is tied to INTV CC . Tie this pin to INTV CC
in high V OUT applications to use a lower R ON value.
PGOOD (Pin 36): Power Good Output. Open-drain logic
output that is pulled to ground when the output voltage
is not within ± 10% of the regulation point.
V RNG (Pin 37): Current Limit Range Input. The voltage at
this pin adjusts maximum valley current and can be set
from 0.5V to 0.7V by a resistive divider from INTV CC . It
defaults to 0.7V if the V RNG pin is tied to ground which
results in a typical 19A current limit.
I TH (Pin 38): Current Control Threshold and Error Amplifier
Compensation Point. The current comparator threshold
increases with this control voltage. The voltage ranges
from 0V to 2.4V with 0.8V corresponding to zero sense
voltage (zero current).
FCB (Pin 39): Forced Continuous Input. Tie this pin to
ground to force continuous synchronous operation at low
load, to INTV CC to enable discontinuous mode operation at
low load or to a resistive divider from a secondary output
when using a secondary winding.
I ON (Pin 41): On-Time Current Input. Tie a resistor from V IN
to this pin to set the one-shot timer current and thereby
set the switching frequency.
V FB (Pin 43): Error Amplifier Feedback Input. This pin
connects the error amplifier input to an external resistive
divider from V OUT .
EXTV CC (Pin 44): External V CC Input. When EXTV CC exceeds
4.7V, an internal switch connects this pin to INTV CC and
shuts down the internal regulator so that controller and
gate drive power is drawn from EXTV CC . Do not exceed
7V at this pin and ensure that EXTV CC < V IN .
SV IN (Pins 51, 52): Supply Pin for Internal PWM
Controller.
INTV CC (Pins 53, 54): Internal 5V Regulator Output. The
driver and control circuits are powered from this voltage.
Decouple this pin to power ground with a minimum of
4.7μF low ESR tantalum or ceramic capacitor.
3610ff
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3611IWP#TRPBF | IC REG BUCK SYNC ADJ 10A 64QFN |
| LTC3612EFE#PBF | IC REG BUCK SYNC ADJ 3A 20TSSOP |
| LTC3613EWKH#PBF | IC REG BUCK SYNC ADJ 15A 56-QFN |
| LTC3614IUDD#TRPBF | IC REG BUCK SYNC ADJ 4A 24QFN |
| LTC3615EFE#PBF | IC REG BUCK SYNC ADJ 3A 24TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3611EWP#PBF | 功能描述:IC REG BUCK SYNC ADJ 10A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3611EWP#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 10A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3611IWP#PBF | 功能描述:IC REG BUCK SYNC ADJ 10A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3611IWP#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 10A 64QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3612EFE#PBF | 功能描述:IC REG BUCK SYNC ADJ 3A 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。