- 您现在的位置：买卖IC网 > PDF目录13913 > LTC3612IFE#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 3A 20TSSOP PDF资料下载
参数资料
| 型号： | LTC3612IFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A 20TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 300kHz ~ 4MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 20-TSSOP-EP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC3612
PIN FUNCTIONS
(QFN/FE)
DDR (Pin 1/Pin 8): DDR Mode Pin. Tying the DDR pin to
SV IN selects DDR mode and TRACK/SS can be used as
an external reference input. If DDR is tied to SGND, the
internal 0.6V reference will be used.
RT/SYNC (Pin 2/Pin 9): Oscillator Frequency. This pin
provides three ways of setting the constant switching
frequency:
1. Connecting a resistor from RT/SYNC to ground will set
the switching frequency based on the resistor value.
2. Driving the RT/SYNC pin with an external clock signal
will synchronize the LTC3612 to the applied frequency.
The slope compensation is automatically adapted to the
external clock frequency.
3. Tying the RT/SYNC pin to SV IN enables the internal
2.25MHz oscillator frequency.
SGND (Pin 3/Pin 10): Signal Ground. All small-signal and
compensation components should connect to this ground,
which in turn should connect to PGND at a single point.
NC (Pins 4, 7, 10/Pins 11, 13, 18): Can be connected to
ground or left open.
SW (Pins 5, 6, 11, 12/Pins 12, 14, 17, 19): Switch Node.
Connection to the inductor. This pin connects to the drains
of the internal synchronous power MOSFET switches.
PV IN (Pins 8, 9/Pins 15, 16): Power Input Supply. PV IN
connects to the source of the internal P-channel power
MOSFET. This pin is independent of SV IN and may be con-
nected to the same voltage or to a lower voltage supply.
PV IN_DRV (Pin 13/Pin 20): Internal Gate Driver Input Sup-
ply. This pin must be connected to PV IN .
SV IN (Pin 14/Pin 1): Signal Input Supply. This pin pow-
ers the internal control circuitry and is monitored by the
undervoltage lockout comparator.
RUN (Pin 15/Pin 2): Enable Pin. Forcing this pin to ground
shuts down the LTC3612. In shutdown, all functions are
disabled and the chip draws <1μA of supply current.
PGOOD (Pin 16/Pin 3): Power Good. This open-drain
output is pulled down to SGND on start-up and while the
FB voltage is outside the power good voltage window. If
the FB voltage increases and stays inside the power good
window for more than 105μs the PGOOD pin is released.
If the FB voltage leaves the power good window for more
than 105μs the PGOOD pin is pulled down.
In DDR mode (DDR = V IN ), the power good window moves
in relation to the actual TRACK/SS pin voltage. During
up/down tracking the PGOOD pin is always pulled down.
In shutdown the PGOOD output will actively pull down
and may be used to discharge the output capacitors via
an external resistor.
MODE (Pin 17/Pin 4): Mode Selection. Tying the MODE
pin to SV IN or SGND enables pulse-skipping mode or Burst
Mode operation (with an internal Burst Mode clamp),
respectively. If this pin is held at slightly higher than half
of SV IN , forced continuous mode is selected. Connecting
this pin to an external voltage selects Burst Mode opera-
tion with the burst clamp set to the pin voltage. See the
Operation section for more details.
V FB (Pin 18/Pin 5): Voltage Feedback Input Pin. Senses
the feedback voltage from the external resistive divider
across the output.
ITH (Pin 19/Pin 6): Error Amplifier Compensation. The
current comparator’s threshold increases with this control
voltage. Tying this pin to SV IN enables internal compensa-
tion and AVP mode.
TRACK/SS (Pin 20/Pin 7): Track/External Soft-Start/
External Reference. Start-up behavior is programmable
with the TRACK/SS pin:
1. Tying this pin to SV IN selects the internal soft-start
circuit.
2. External soft-start timing can be programmed with a
capacitor to ground and a resistor to SV IN .
3. TRACK/SS can be used to force the LTC3612 to track
the start-up behavior of another supply.
The pin can also be used as external reference input. See
the Applications Information section for more information.
PGND (Pin 21/Pin 21): Power Ground. The exposed pad
connects to the source of the internal N-channel power
MOSFET. This pin should be connected close to the (–)
terminal of C IN and C OUT and soldered to PCB ground for
rated thermal performance.
3612fb
10
For more information www.linear.com/LTC3612
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3603IMSE#TRPBF | IC REG BUCK SYNC ADJ 2.5A 16MSOP |
| LT1374CFE#TRPBF | IC REG BUCK ADJ 4.5A 16TSSOP |
| HM77-14004LFTR | LOW PROFILE INDUCTORS |
| EBM36DCCN-S189 | CONN EDGECARD 72POS R/A .156 SLD |
| V300B5C150BG3 | CONVERTER MOD DC/DC 5V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3612IUDC#PBF | 功能描述:IC REG BUCK SYNC ADJ 3A 20QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3612IUDC#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 3A 20QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3613EWKH#PBF | 功能描述:IC REG BUCK SYNC ADJ 15A 56-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3613EWKH#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 15A 56QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3613IWKH#PBF | 功能描述:IC REG BUCK SYNC ADJ 15A 56QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。