- 您现在的位置：买卖IC网 > PDF目录13814 > LTC3613IWKH#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 15A 56QFN PDF资料下载
参数资料
| 型号： | LTC3613IWKH#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 23/36页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 15A 56QFN |
| 标准包装： | 2,000 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 4.5 V ~ 24 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 200kHz ~ 1MHz |
| 电流 - 输出： | 15A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 56-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 56-QFN 多焊盘（7x9） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC3613
APPLICATIONS INFORMATION
V OUT
+ ? Δ I L
Minimum On-Time, Minimum Off-Time
and Dropout Operation
The minimum on-time is the smallest duration of time in
which the LTC3613 can keep its top power MOSFET in its
on state. This minimum on-time is 65ns for the LTC3613
and is achieved when the V OUT pin is tied to its minimum
value of 0.6V while the PV IN is tied to its maximum value
of 24V. For larger values of V OUT or smaller values of
PV IN , the minimum on-time achievable will be longer than
65ns. The minimum on-time will have a dependency on
the operating conditions of the switching regulator, but is
intended to be smaller for high step-down ratio applica-
tions that will require low on-times.
In continuous mode operation, the minimum on-time limit
imposes a minimum duty cycle of:
D MIN = f ? t ON(MIN)
where t ON(MIN) is the minimum on-time for the switching
regulator. As the equation shows, reducing the operating
frequency will alleviate the minimum duty cycle constraint.
If the application requires a smaller than minimum duty
cycle, the output voltage will still remain in regulation, but
the switching frequency will decrease from its programmed
value or lose frequency synchronization if using an external
clock. Depending on the application, this may not be of
critical importance.
The minimum off-time is the smallest duration of time
that the top power MOSFET can be turned off and then
immediately turned back on. The minimum off-time that
the LTC3613 can achieve is 105ns.
The minimum off-time limit imposes a maximum duty
cycle of:
D MAX = 1 – f ? t OFF(MIN)
where t OFF(MIN) is the minimum off-time of the switching
regulator. Reducing the operating frequency alleviates the
maximum duty cycle constraint. If the maximum duty cycle
is reached, due to a drooping input voltage for example,
then the output will drop out of regulation. The minimum
input voltage to avoid dropout is:
V IN(MIN) =
D MAX
At the onset of dropout, there is a region of PV IN about
500mV that generates two discrete off-times, one being
the minimum off-time and the other being an off-time that
is about 40ns to 60ns larger than the minimum off-time.
This secondary off-time is due to the longer delay in trip-
ping the internal current comparator. The two off-times
average out to the required duty cycle to keep the output
in regulation with the output ripple remaining the same.
However, there is higher SW node jitter, especially appar-
ent when synchronized to an external clock. Depending
on the application, this may not be of critical importance.
Fault Conditions: Current Limiting and Overvoltage
The maximum inductor current is inherently limited in a
current mode controller by the maximum sense voltage.
In the LTC3613, the maximum sense voltage is controlled
by the voltage on the V RNG pin. With valley current mode
control, the maximum sense voltage and the sense re-
sistance determine the maximum allowed inductor valley
current. The corresponding output current limit is:
V SENSE(MAX) 1
I LIMIT =
R SENSE 2
The current limit value should be checked to ensure that
I LIMIT(MIN) > I OUT(MAX) . The current limit value should
be greater than the inductor current required to produce
maximum output power at the worst-case efficiency.
Worst-case efficiency typically occurs at the highest PV IN
and highest ambient temperature.
3613fa
23
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3613IWKH#PBF | IC REG BUCK SYNC ADJ 15A 56QFN |
| 35PX220MEFCT78X11.5 | CAP ALUM 220UF 35V 20% RADIAL |
| 35PX220MEFCTA8X11.5 | CAP ALUM 220UF 35V 20% RADIAL |
| UVR1C471MPD1TD | CAP ALUM 470UF 16V 20% RADIAL |
| 10ML470MEFCT78X9 | CAP ALUM 470UF 10V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3614EUDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LTC3614EUDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LTC3614IUDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3614IUDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3614MPUDD#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN |
发布紧急采购，3分钟左右您将得到回复。