- 您现在的位置：买卖IC网 > PDF目录1831 > LTC3616IUDD#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 6A 24QFN PDF资料下载
参数资料
| 型号： | LTC3616IUDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 18/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 6A 24QFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 300kHz ~ 4MHz |
| 电流 - 输出： | 6A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-QFN |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 24-QFN（3x5） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3616
APPLICATIONS INFORMATION
A second, more severe transient is caused by switching
in loads with large (>1μF) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C OUT , causing a rapid drop in V OUT . No regulator can
alter its delivery of current quickly enough to prevent this
sudden step change in output voltage if the load switch
resistance is low and it is driven quickly. More output
capacitance may be required depending on the duty cycle
and load step requirements.
AVP Mode
Fast load transient response, limited board space and low
cost are typical requirements of microprocessor power
supplies. A microprocessor has typical full load step with
very fast slew rate. The voltage at the microprocessor must
be held to about ±0.1V of nominal in spite of these load
current steps. Since the control loop cannot respond this
fast, the output capacitors must supply the load current
until the control loop can respond.
Normally, several capacitors in parallel are required to
meet microprocessor transient requirements. Capacitor
ESR and ESL primarily determine the amount of droop or
overshoot in the output voltage.
Consider the LTC3616 without AVP with a bank of tantalum
output capacitors. If a load step with very fast slew rate
occurs, the voltage excursion will be seen in both direc-
tions, for full load to minimum load transient and for the
minimum load to full load transient.
V OUT
200mV/DIV
I L
1A/DIV
If the ITH pin is tied to SV IN , the active voltage position-
ing (AVP) mode and internal compensation are selected.
AVP mode intentionally compromises load regulation by
reducing the gain of the feedback circuit, resulting in an
output voltage that varies with load current. When the load
current suddenly increases, the output voltage starts from
a level slightly higher than nominal so the output voltage
can droop more and stay within the specified voltage
range. When the load current suddenly decreases the
output voltage starts at a level lower than nominal so the
output voltage can have more overshoot and stay within
the specified voltage range (see Figures 3 and 4).
The benefit is a lower peak-to-peak output voltage deviation
for a given load step without having to increase the output
filter capacitance. Alternatively, the output voltage filter
capacitance can be reduced while maintaining the same
peak to peak transient response. Due to the reduced loop
gain in AVP mode, no external compensation is required.
DDR Mode
The LTC3616 can both source and sink current if the MODE
pin is configured to forced continuous mode.
Current sinking is typically limited to 3A for 1MHz frequency
and a 0.47μH inductor, but can be lower at higher frequen-
cies and low output voltages. If higher ripple current can
be tolerated, smaller inductor values can increase the sink
current limit. See the Typical Performance Characteristics
curves for more information.
V OUT
100mV/DIV
I L
1A/DIV
V IN = 3.3V 50μs/DIV
V OUT = 1.8V
I LOAD = 100mA TO 3A
V MODE = 1.5V
COMPENSATION FIGURE 1
3616 F03
V IN = 3.3V 50μs/DIV
V OUT = 1.8V
I LOAD = 100mA TO 3A
V MODE = 1.5V
V ITH = 3.3V
OUTPUT CAPACITOR VALUE FIGURE 1
3616 F04
Figure 3. Load Step Transient Forced
Continuous Mode (AVP Inactive)
Figure 4. Load Step Transient Forced
Continuous Mode with AVP Mode
18
For more information www.linear.com/LTC3616
3616fb
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3617IUDD#TRPBF | IC REG SYNC 6A BUCK 24QFN |
| LTC3618EFE#PBF | IC REG DUAL SYNC 3A BUCK 24TSSOP |
| LTC3619BIMSE#TRPBF | IC REG BUCK SYNC ADJ DL 10MSOP |
| LTC3620EDC-1#TRPBF | IC REG BUCK SYNC 1.1V 15MA 8DFN |
| LTC3631IMS8E-5#TRPBF | IC REG BUCK SYNC 5V 0.1A 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3616MPUDD#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3616MPUDD#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 6A 24QFN |
| LTC3617EUDD#PBF | 功能描述:IC REG SYNC 6A BUCK 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| LTC3617EUDD#TRPBF | 功能描述:IC REG SYNC 6A BUCK 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3617IUDD#PBF | 功能描述:IC REG SYNC 6A BUCK 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。