- 您现在的位置：买卖IC网 > PDF目录20631 > LTC3700EMS#PBF (Linear Technology)IC REG DL BUCK/LINEAR 10MSOP PDF资料下载
参数资料
| 型号： | LTC3700EMS#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/16页 |
| 文件大小： | 215K |
| 描述： | IC REG DL BUCK/LINEAR 10MSOP |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 50 |
| 拓扑： | 降压（降压）（1），线性（LDO）（1） |
| 功能： | 任何功能 |
| 输出数： | 2 |
| 频率 - 开关： | 550kHz |
| 电压/电流 - 输出 1： | 可调至0.8V，5A |
| 电压/电流 - 输出 2： | 可调至0.8V，150mA |
| 带 LED 驱动器： | 无 |
| 带监控器： | 无 |
| 带序列发生器： | 无 |
| 电源电压： | 2.4 V ~ 9.8 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 管件 |
8
LTC3700
3700f
OPERATIO
(Refer to Functional Diagram)
Main Control Loop (Buck Controller)
The LTC3700 is a constant frequency current mode switch-
ing regulator. During normal operation, the external
P-channel power MOSFET is turned on each cycle when
the oscillator sets the RS latch (RS1) and turned off when
the current comparator (ICMP) resets the latch. The peak
inductor current at which ICMP resets the RS latch is
controlled by the voltage on the I
TH
/RUN pin, which is the
output of the error amplifier EAMP. An external resistive
divider connected between V
OUT
and ground allows the
EAMP to receive an output feedback voltage V
FB
. When the
load current increases, it causes a slight decrease in V
FB
relative to the 0.8V reference, which in turn causes the
I
TH
/RUN voltage to increase until the average inductor
current matches the new load current.
The main control loop is shut down by pulling the I
TH
/RUN
pin low. Releasing I
TH
/RUN allows an internal 0.5礎
current source to charge up the external compensation
network. When the I
TH
/RUN pin reaches 0.3V, the main
control loop is enabled with the I
TH
/RUN voltage then
pulled up to its zero current level of approximately 0.7V.
As the external compensation network continues to charge
up, the corresponding output current trip level follows,
allowing normal operation.
Comparator OVP guards against transient overshoots
>7.5% by turning off the external P-channel power
MOSFET and keeping it off until the fault is removed.
Burst Mode Operation
The buck enters Burst Mode operation at low load cur-
rents. In this mode, the peak current of the inductor is set
as if V
ITH
/RUN = 1V (at low duty cycles) even though the
voltage at the I
TH
/RUN pin is at a lower value. If the
inductors average current is greater than the load require-
ment, the voltage at the I
TH
/RUN pin will drop. When the
I
TH
/RUN voltage goes below 0.85V, the sleep signal goes
high, turning off the external MOSFET. The sleep signal
goes low when the I
TH
/RUN voltage goes above 0.925V
and the buck resumes normal operation. The next oscilla-
tor cycle will turn the external MOSFET on and the switch-
ing cycle repeats.
Dropout Operation
When the input supply voltage decreases towards the
output voltage, the rate of change of inductor current
during the ON cycle decreases. This reduction means that
the external P-channel MOSFET will remain on for more
than one oscillator cycle since the inductor current has not
ramped up to the threshold set by EAMP. Further reduc-
tion in input supply voltage will eventually cause the
P-channel MOSFET to be turned on 100%, i.e., DC. The
output voltage will then be determined by the input voltage
minus the voltage drop across the MOSFET, the sense
resistor and the inductor.
Undervoltage Lockout
To prevent operation of the P-channel MOSFET below safe
input voltage levels, an undervoltage lockout is incorpo-
rated into the buck input supply. When the input supply
voltage drops below approximately 2.1V, the P-channel
MOSFET and all circuitry is turned off except the under-
voltage block, which draws only several microamperes.
Short-Circuit Protection
When the output is shorted to ground, the frequency of the
oscillator will be reduced to about 110kHz. This lower
frequency allows the inductor current to safely discharge,
thereby preventing current runaway. The oscillators fre-
quency will gradually increase to its designed rate when
the feedback voltage again approaches 0.8V.
Overvoltage Protection
As a further protection, the overvoltage comparator in the
buck will turn the external MOSFET off when the feedback
voltage has risen 7.5% above the reference voltage of
0.8V. This comparator has a typical hysteresis of 20mV.
Slope Compensation and Inductors Peak Current
The inductors peak current is determined by:
I
V
R
PK
ITH
SENSE
=
(
)
.
07
10
相关PDF资料 |
PDF描述 |
|---|---|
| RCM06DTBI-S189 | CONN EDGECARD 12POS R/A .156 SLD |
| EBM08DSAN | CONN EDGECARD 16POS R/A .156 SLD |
| RW2-2412D/H3/SMD | CONV DC/DC 2W 18-36VIN +/-12VOUT |
| AMM25DSEN-S13 | CONN EDGECARD 50POS .156 EXTEND |
| RS-2405DZ/H3 | CONV DC/DC 2W 9-36VIN +/-05VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3701EGN | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3701EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3701EGN#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3701EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3701EGNPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Dual Step-Dn 10V SSOP16 |
发布紧急采购，3分钟左右您将得到回复。