参数资料
型号: LTC3729EUH#TRPBF
厂商: Linear Technology
文件页数: 18/30页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 2,500
系列: PolyPhase®
PWM 型: 电流模式
输出数: 1
频率 - 最大: 590kHz
占空比: 99.5%
电源电压: 4 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 带卷 (TR)
LTC3729
APPLICATIONS INFORMATION
= ( ) C SS
t DELAY =
1.25s / μ F
C
pulledallthewaytogroundthereisadelaybeforestarting
of approximately:
1.5V
1.2 μ A SS
3.3V OR 5V
D1
V IN
RUN/SS
R SS *
C SS
INTV CC
R SS *
D1*
RUN/SS
The time for the output current to ramp up is then:
C SS
t RAMP =
3V ? 1.5V
1.2 μ A
C SS = ( 1.25s / μ F ) C SS
*OPTIONAL TO DEFEAT OVERCURRENT LATCHOFF
Figure 6. RUN/SS Pin Interfacing
3729 F06
By pulling the RUN/SS pin below 0.8V the LTC3729 is
put into low current shutdown (I Q < 40μA). RUN/SS can
be driven directly from logic as shown in Figure 6. Diode
D1 in Figure 6 reduces the start delay but allows C SS to
ramp up slowly providing the soft?start function. The
RUN/SS pin has an internal 6V zener clamp (see Functional
Diagram).
Fault Conditions: Overcurrent Latchoff
The RUN/SS pin also provides the ability to latch off the
controllers when an overcurrent condition is detected.
The RUN/SS capacitor, C SS , is used initially to limit the
inrush current of both controllers. After the controllers
have been started and been given adequate time to charge
up the output capacitors and provide full load current, the
RUN/SS capacitor is used for a short?circuit timer. If the
output voltage falls to less than 70% of its nominal value
after C SS reaches 4.1V, C SS begins discharging on the as?
sumption that the output is in an overcurrent condition. If
the condition lasts for a long enough period as determined
by the size of C SS , the controller will be shut down until
the RUN/SS pin voltage is recycled. If the overload occurs
during start?up, the time can be approximated by:
t LO1 ≈ (C SS ? 0.6V)/(1.2μA) = 5 ? 10 5 (C SS )
If the overload occurs after start?up, the voltage on C SS
will continue charging and will provide additional time
before latching off:
t LO2 ≈ (C SS ? 3V)/(1.2μA) = 2.5 ? 10 6 (C SS )
This built?in overcurrent latchoff can be overridden by
providing a pull?up resistor, R SS , to the RUN/SS pin as
shown in Figure 6. This resistance shortens the soft?
start period and prevents the discharge of the RUN/SS
capacitor during a severe overcurrent and/or short?circuit
condition. When deriving the 5μA current from V IN as
in the figure, current latchoff is always defeated. Diode?
connecting this pull?up resistor to INTV CC , as in Figure 6,
eliminates any extra supply current during shutdown
while eliminating the INTV CC loading from preventing
controller start?up.
Why should you defeat current latchoff? During the pro?
totyping stage of a design, there may be a problem with
noise pickup or poor layout causing the protection circuit
to latch off the controller. Defeating this feature allows
troubleshooting of the circuit and PC layout. The internal
short?circuit and foldback current limiting still remains
active, thereby protecting the power supply system from
failure. A decision can be made after the design is com?
plete whether to rely solely on foldback current limiting
or to enable the latchoff feature by removing the pull?up
resistor.
The value of the soft?start capacitor C SS may need to
be scaled with output voltage, output capacitance and
load current characteristics. The minimum soft?start
capacitance is given by:
C SS > (C OUT )(V OUT )(10 ?4 )(R SENSE )
The minimum recommended soft?start capacitor of C SS =
0.1μF will be sufficient for most applications.
Phase-Locked Loop and Frequency Synchronization
The LTC3729 has a phase?locked loop comprised of an
internal voltage controlled oscillator and phase detector.
This allows the top MOSFET turn?on to be locked to the
rising edge of an external source. The frequency range
of the voltage controlled oscillator is ± 50% around the
center frequency f O . A voltage applied to the PLLFLTR
pin of 1.2V corresponds to a frequency of approximately
3729fb
18
相关PDF资料
PDF描述
ELL-6PM1R0N COIL PWR CHOKE 1UH 2.7A SMD
LTC3729EUH#TR IC REG CTRLR BUCK PWM CM 32-QFN
SRP1040-R39M INDUCTOR 390NH 24A SMD
SRP1040-R20M INDUCTOR 200NH 32A SMD
SRP1040-8R2M INDUCTOR 8.2UH 5A SMD
相关代理商/技术参数
参数描述
LTC3729LEUH-6 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3729LEUH-6#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3729LEUH-6#TR 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3729LEUH-6#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3730CG 功能描述:IC SW REG CTRLR SYNC BUCK 36SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器,Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN(7x7) 包装:管件