参数资料
型号: LTC3788EUH#TRPBF
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
封装: 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32
文件页数: 6/32页
文件大小: 386K
代理商: LTC3788EUH#TRPBF
LTC3788
14
3788fb
operaTion
The typical input clock thresholds on the PLLIN/MODE
pin are 1.6V (rising) and 1.2V (falling).
PolyPhase Applications (CLKOUT and PHASMD Pins)
The LTC3788 features two pins (CLKOUT and PHASMD)
that allow other controller ICs to be daisychained with the
LTC3788 in PolyPhase applications. The clock output
signal on the CLKOUT pin can be used to synchronize
additional power stages in a multiphase power supply
solution feeding a single, high current output or multiple
separate outputs. The PHASMD pin is used to adjust the
phase of the CLKOUT signal as well as the relative phases
between the two internal controllers, as summarized in
Table 1. The phases are calculated relative to the zero
degrees phase being defined as the rising edge of the
bottom gate driver output of controller 1 (BG1).
Table 1.
VPHASMD
CONTROLLER 2
PHASE (°C)
CLKOUT
PHASE (°C)
GND
180
60
Floating
180
90
INTVCC
240
120
CLKOUT is disabled when one of the channels is in sleep
mode and another channel is either in shutdown or in
sleep mode.
Operation When VIN > VOUT
When VIN rises above the regulated VOUT voltage, the
boost controller can behave differently depending on the
mode, inductor current and VIN voltage. In forced con-
tinuous mode, the loop works to keep the top MOSFET
on continuously once VIN rises above VOUT. The internal
charge pump delivers current to the boost capacitor to
maintain a sufficiently high TG voltage.
In pulse-skipping mode, if VIN is between 100% and
110% of the regulated VOUT voltage, TG turns on if the
inductor current rises above a certain threshold and turns
off if the inductor current falls below this threshold. This
threshold current is set to approximately 6%, 4% or
3% of the maximum ILIM current when the ILIM pin is
grounded, floating or tied to INTVCC, respectively. If the
controller is programmed to Burst Mode operation under
this same VIN window, then TG remains off regardless of
the inductor current.
If VIN rises above 110% of the regulated VOUT voltage in
any mode, the controller turns on TG regardless of the
inductor current. In Burst Mode operation, however, the
internal charge pump turns off if the entire chip is asleep
(theotherchannelisasleeporshutdown).Withthecharge
pump off, there would be nothing to prevent the boost
capacitor from discharging, resulting in an insufficient TG
voltage needed to keep the top MOSFET completely on.
To prevent excessive power dissipation across the body
diode of the top MOSFET in this situation, the chip can be
switched over to forced continuous mode to enable the
charge pump, or a Schottky diode can also be placed in
parallel to the top MOSFET.
Power Good
The PGOOD1, 2 pin is connected to an open-drain of an
internal N-channel MOSFET. The MOSFET turns on and
pulls the PGOOD1, 2 pin low when the corresponding
VFB1, 2 pin voltage is not within ±10% of the 1.2V refer-
ence voltage. The PGOOD1, 2 pin is also pulled low when
the corresponding RUN1, 2 pin is low (shut down). When
the VFB1, 2 pin voltage is within the ±10% requirement,
the MOSFET is turned off and the pin is allowed to be
pulled up by an external resistor to a source of up to 6V.
Operation at Low SENSE Pin Common Voltage
ThecurrentcomparatorintheLTC3788ispowereddirectly
from the SENSE+ pin. This enables the common mode
voltage of SENSE+ and SENSEpins to operate at as
low as 2.5V, which is below the UVLO threshold. The
figure on the first page shows a typical application when
the controller’s VBIAS is powered from VOUT while VIN
supply can go as low as 2.5V. If the voltage on SENSE+
drops below 2.5V, the SS pin will be held low. When the
SENSE voltage returns to the normal operating range, the
SS pin will be released, initiating a new soft-start cycle.
BOOST Supply Refresh and Internal Charge Pump
Each top MOSFET driver is biased from the floating
bootstrap capacitor CB, which normally recharges during
each cycle through an external diode when the bottom
相关PDF资料
PDF描述
LTC3788EUH#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
LTC3788IUH#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32
LTC3788IGN-1#PBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28
LTC3788EGN-1#TRPBF DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO28
LTC3789EGN#TRPBF 0.1 A SWITCHING CONTROLLER, 710 kHz SWITCHING FREQ-MAX, PDSO28
相关代理商/技术参数
参数描述
LTC3788IGN-1#PBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3788IGN-1#TRPBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3788IUH#PBF 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3788IUH#TRPBF 功能描述:IC REG CTRLR BST PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3789EGN#PBF 功能描述:IC REG CTRLR BST PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX