- 您现在的位置：买卖IC网 > PDF目录44993 > LTC3803IS6-5 (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO6 PDF资料下载
参数资料
| 型号： | LTC3803IS6-5 |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封装： | 1 MM HEIGHT, PLASTIC, MO-193, TSOT-23, 6 PIN |
| 文件页数： | 14/16页 |
| 文件大小： | 162K |
| 代理商： | LTC3803IS6-5 |
LTC3803-5
7
38035fd
OPERATION
The LTC3803-5 is a constant frequency current mode
controller for yback, SEPIC and DC/DC boost converter
applications in a tiny ThinSOT package. The LTC3803-5 is
designed so that none of its pins need to come in contact
with the input or output voltages of the power supply circuit
of which it is a part, allowing the conversion of voltages well
beyond the LTC3803-5’s absolute maximum ratings.
Main Control Loop
Due to space limitations, the basics of current mode DC/DC
conversion will not be discussed here; instead, the reader
is referred to the detailed treatment in Application Note
19, or in texts such as Abraham Pressman’s
Switching
Power Supply Design.
Please refer to the Block Diagram and the Typical Ap-
plication on the front page of this data sheet. An external
resistive voltage divider presents a fraction of the output
voltage to the VFB pin. The divider must be designed so
that when the output is at the desired voltage, the VFB pin
voltage will equal the 800mV from the internal reference.
If the load current increases, the output voltage will de-
crease slightly, causing the VFB pin voltage to fall below
800mV. The error amplier responds by feeding current
into the ITH/RUN pin. If the load current decreases, the
VFB voltage will rise above 800mV and the error amplier
will sink current away from the ITH/RUN pin.
The voltage at the ITH/RUN pin commands the pulse-width
modulator formed by the oscillator, current comparator
and RS latch. Specically, the voltage at the ITH/RUN pin
sets the current comparator’s trip threshold. The current
comparator monitors the voltage across a current sense
resistor in series with the source terminal of the external
MOSFET. The LTC3803-5 turns on the external power
MOSFET when the internal free-running 200kHz oscillator
sets the RS latch. It turns off the MOSFET when the cur-
rent comparator resets the latch or when 80% duty cycle
is reached, whichever happens rst. In this way, the peak
current levels through the yback transformer’s primary
and secondary are controlled by the ITH/RUN voltage.
Since the ITH/RUN voltage is increased by the error ampli-
er whenever the output voltage is below nominal, and
decreased whenever output voltage exceeds nominal, the
voltage regulation loop is closed. For example, whenever
the load current increases, output voltage will decrease
slightly, and sensing this, the error amplier raises the
ITH/RUN voltage by sourcing current into the ITH/RUN pin,
raising the current comparator threshold, thus increasing
the peak currents through the transformer primary and
secondary. This delivers more current to the load, bringing
the output voltage back up.
The ITH/RUN pin serves as the compensation point for
the control loop. Typically, an external series RC network
is connected from ITH/RUN to ground and is chosen for
optimal response to load and line transients. The impedance
of this RC network converts the output
current of the error
amplier to the ITH/RUN voltage which sets the current
comparator threshold and commands considerable inu-
ence over the dynamics of the voltage regulation loop.
Start-Up/Shutdown
The LTC3803-5 has two shutdown mechanisms to disable
and enable operation: an undervoltage lockout on the VCC
supply pin voltage, and a forced shutdown whenever ex-
ternal circuitry drives the ITH/RUN pin low. The LTC3803-5
transitions into and out of shutdown according to the state
diagram (Figure 1).
Figure 1. Start-Up/Shutdown State Diagram
LTC3803-5
SHUT DOWN
VITH/RUN < VITHSHDN
(NOMINALLY 0.28V)
38035 F01
VCC < VTURNOFF
(NOMINALLY 4V)
VITH/RUN > VITHSHDN
AND VCC > VTURNON
(NOMINALLY 4.8V)
LTC3803-5
ENABLED
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3805HMSE-5#TRMPBF | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805EDD-5#TRMPBF | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3805IMSE-5#TRMPBF | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3808EDE | SWITCHING CONTROLLER, PDSO8 |
| LTC3808EGN | SWITCHING CONTROLLER, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3803IS6-5#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Flyback 5V Input 6-Pin TSOT-23 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Sync Flyback 5V Input 6-Pin TSOT-23 Bulk |
| LTC3803IS6-5#TRMPBF | 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3803IS6-5#TRPBF | 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3803IS6TRMPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Flyback 75V TSOT23-6 |
| LTC3803MPS6#TRMPBF | 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。