参数资料
型号: LTC3803IS6#TRMPBF
厂商: Linear Technology
文件页数: 9/16页
文件大小: 0K
描述: IC REG CTRLR FLYBK PWM TSOT23-6
标准包装: 500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 240kHz
占空比: 90%
电源电压: 5.7 V ~ 8 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: SOT-23-6 细型,TSOT-23-6
包装: 带卷 (TR)
相关产品: 732-2263-6-ND - TRANS FLYBACK LTC3803 16.9UH
732-2263-1-ND - TRANS FLYBACK LTC3803 16.9UH
732-2263-2-ND - TRANS FLYBACK LTC3803 16.9UH
其它名称: LTC3803IS6#PBF
LTC3803IS6#PBF-ND

LTC3803
APPLICATIONS INFORMATION
Many LTC3803 application circuits can be derived from
the topology shown in Figure 2.
The LTC3803 itself imposes no limits on allowed power
output, input voltage V IN or desired regulated output voltage
V OUT ; these are all determined by the ratings on the external
power components. The key factors are: Q1’s maximum
drain-source voltage (BV DSS ), on-resistance (R DS(ON) )
and maximum drain current, T1’s saturation ?ux level and
winding insulation breakdown voltages, C IN and C OUT ’s
maximum working voltage, ESR, and maximum ripple
current ratings, and D1 and R SENSE ’s power ratings.
T1
TRANSFORMER DESIGN CONSIDERATIONS
Transformer speci?cation and design is perhaps the
most critical part of applying the LTC3803 successfully.
In addition to the usual list of caveats dealing with high
frequency power transformer design, the following should
prove useful.
Turns Ratios
Due to the use of the external feedback resistor divider
ratio to set output voltage, the user has relative freedom
in selecting transformer turns ratio to suit a given appli-
cation. Simple ratios of small integers, e.g., 1:1, 2:1, 3:2,
etc. can be employed which yield more freedom in setting
C VCC
D2
R3
1
V IN
R START
5
V CC
I TH /RUN NGATE
L BIAS
C IN L PRI
6
?
?
Q1
?
D1
L SEC
C OUT
V OUT
total turns and mutual inductance. Simple integer turns
ratios also facilitate the use of “off-the-shelf” con?gu-
rable transformers such as the Coiltronics VERSA-PAC?
series in applications with high input to output voltage
ratios. For example, if a 6-winding VERSA-PAC is used
with three windings in series on the primary and three
windings in parallel on the secondary, a 3:1 turns ratio
will be achieved.
C C
2
LTC3803
GND SENSE
4
R SL
Turns ratio can be chosen on the basis of desired duty
V FB
R SENSE
cycle. However, remember that the input supply voltage
R1
3
R2
plus the secondary-to-primary referred version of the
V OUT – 0.8V
3803 F02
Figure 2. Typical LTC3803 Application Circuit
SELECTING FEEDBACK RESISTOR DIVIDER VALUES
The regulated output voltage is determined by the resistor
divider across V OUT (R1 and R2 in Figure 2). The ratio
of R2 to R1 needed to produce a desired V OUT can be
calculated:
R2 = ? R1
0.8V
Choose resistance values for R1 and R2 to be as large as
possible in order to minimize any ef?ciency loss due to
the static current drawn from V OUT , but just small enough
so that when V OUT is in regulation, the error caused by
the nonzero input current to the V FB pin is less than 1%.
A good rule of thumb is to choose R1 to be 80k or less.
?yback pulse (including leakage spike) must not exceed
the allowed external MOSFET breakdown rating.
Leakage Inductance
Transformer leakage inductance (on either the primary
or secondary) causes a voltage spike to occur after the
output switch (Q1) turn-off. This is increasingly prominent
at higher load currents, where more stored energy must
be dissipated. In some cases a “snubber” circuit will be
required to avoid overvoltage breakdown at the MOSFET’s
drain node. Application Note 19 is a good reference on
snubber design.
A bi?lar or similar winding technique is a good way to
minimize troublesome leakage inductances. However,
remember that this will limit the primary-to-secondary
breakdown voltage, so bi?lar winding is not always
practical.
3803fc
9
相关PDF资料
PDF描述
ADM697ARZ-REEL IC SUPERVISOR MPU 16SOIC
VI-2WY-EX-B1 CONVERTER MOD DC/DC 3.3V 49.5W
LTC3873ETS8-5#TRMPBF IC REG CTRLR BST FLYBK TSOT23-8
EMC18DRXS CONN EDGECARD 36POS DIP .100 SLD
H2BBT-10104-W4-ND JUMPER-H1500TR/A2015W/H1500TR 4"
相关代理商/技术参数
参数描述
LTC3803MPS6#TRMPBF 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3803MPS6#TRPBF 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3803MPS6-3#TRMPBF 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3803MPS6-3#TRPBF 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3803MPS6-5#TRMPBF 功能描述:IC REG CTRLR FLYBK PWM TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX