- 您现在的位置：买卖IC网 > PDF目录44993 > LTC3803MPS6#TR (LINEAR TECHNOLOGY CORP) 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO6 PDF资料下载
参数资料
| 型号： | LTC3803MPS6#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封装： | PLASTIC, MO-193, TSOT-23, 6 PIN |
| 文件页数： | 16/16页 |
| 文件大小： | 164K |
| 代理商： | LTC3803MPS6#TR |
LTC3803
9
3803fc
APPLICATIONS INFORMATION
Many LTC3803 application circuits can be derived from
the topology shown in Figure 2.
The LTC3803 itself imposes no limits on allowed power
output, input voltage VINordesiredregulatedoutputvoltage
VOUT; these are all determined by the ratings on the external
power components. The key factors are: Q1’s maximum
drain-source voltage (BVDSS), on-resistance (RDS(ON))
and maximum drain current, T1’s saturation ux level and
winding insulation breakdown voltages, CIN and COUT’s
maximum working voltage, ESR, and maximum ripple
current ratings, and D1 and RSENSE’s power ratings.
TRANSFORMER DESIGN CONSIDERATIONS
Transformer specication and design is perhaps the
most critical part of applying the LTC3803 successfully.
In addition to the usual list of caveats dealing with high
frequency power transformer design, the following should
prove useful.
Turns Ratios
Due to the use of the external feedback resistor divider
ratio to set output voltage, the user has relative freedom
in selecting transformer turns ratio to suit a given appli-
cation. Simple ratios of small integers, e.g., 1:1, 2:1, 3:2,
etc. can be employed which yield more freedom in setting
total turns and mutual inductance. Simple integer turns
ratios also facilitate the use of “off-the-shelf” congu-
rable transformers such as the Coiltronics VERSA-PAC
series in applications with high input to output voltage
ratios. For example, if a 6-winding VERSA-PAC is used
with three windings in series on the primary and three
windings in parallel on the secondary, a 3:1 turns ratio
will be achieved.
Turns ratio can be chosen on the basis of desired duty
cycle. However, remember that the input supply voltage
plus the secondary-to-primary referred version of the
yback pulse (including leakage spike) must not exceed
the allowed external MOSFET breakdown rating.
Leakage Inductance
Transformer leakage inductance (on either the primary
or secondary) causes a voltage spike to occur after the
output switch (Q1) turn-off. This is increasingly prominent
at higher load currents, where more stored energy must
be dissipated. In some cases a “snubber” circuit will be
required to avoid overvoltage breakdown at the MOSFET’s
drain node. Application Note 19 is a good reference on
snubber design.
A bilar or similar winding technique is a good way to
minimize troublesome leakage inductances. However,
remember that this will limit the primary-to-secondary
breakdown voltage, so bilar winding is not always
practical.
SELECTING FEEDBACK RESISTOR DIVIDER VALUES
The regulated output voltage is determined by the resistor
divider across VOUT (R1 and R2 in Figure 2). The ratio
of R2 to R1 needed to produce a desired VOUT can be
calculated:
R2 =
V
OUT – 0.8V
0.8V
R1
Choose resistance values for R1 and R2 to be as large as
possible in order to minimize any efciency loss due to
the static current drawn from VOUT, but just small enough
so that when VOUT is in regulation, the error caused by
the nonzero input current to the VFB pin is less than 1%.
A good rule of thumb is to choose R1 to be 80k or less.
Figure 2. Typical LTC3803 Application Circuit
VCC
ITH/RUN
LTC3803
GND
NGATE
SENSE
VFB
5
R3
6
4
1
2
3
D1
D2
COUT
CIN
LSEC
LPRI
LBIAS
CVCC
CC
VOUT
3803 F02
RSENSE
RSL
R1
RSTART
R2
Q1
T1
VIN
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3803HS6#TR | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803MPS6#PBF | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803MPS6#TRMPBF | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803MPS6#TRM | 1 A SWITCHING CONTROLLER, 240 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3803IS6-5#PBF | 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3805EDD#PBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3805EDD#TRPBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3805EDD-5#PBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3805EDD-5#PBF | 制造商:Linear Technology 功能描述:IC, FLYBACK/ BOOST/SEPIC CTRL, DFN-10 |
| LTC3805EDD-5#TRPBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。