- 您现在的位置：买卖IC网 > PDF目录15352 > LTC3805EMSE#PBF (Linear Technology)IC REG CTRLR BST FLYBK CM 10MSOP PDF资料下载
参数资料
| 型号： | LTC3805EMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST FLYBK CM 10MSOP |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 700kHz |
| 占空比： | 95% |
| 电源电压： | 3.95 V ~ 75 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 相关产品： | 732-2264-6-ND - TRANS FLYBACK LTC3805 36.3UH 732-2264-1-ND - TRANS FLYBACK LTC3805 36.3UH 732-2264-2-ND - TRANS FLYBACK LTC3805 36.3UH |
LTC3805
APPLICATIONS INFORMATION
? V SENSE =
10μA ? R SLOPE
FeedbackinIsolatedApplications
Isolated applications do not use the FB pin and error
amplifier but control the I TH pin directly using an opto-
isolator driven on the other side of the isolation barrier as
shown in Figure 5. A detailed version is shown in Figure
9. For isolated converters, the FB pin is grounded which
provides pull-up on the I TH pin. This pull-up is not enough
to properly bias the opto-isolator which is typically biased
using a resistor to V CC . Since the I TH pin cannot sink the
opto-isolator bias current, a diode is required to block
it from the I TH pin. A low leakage Schottky diode or low
forward voltage PN junction diode should be used to
ensure that the opto-isolator is able to pull I TH down to
its lower clamp.
Oscillator Synchronization
The oscillator may be synchronized to an external clock
by connecting the synchronization signal to the SYNC
pin. The LTC3805 oscillator and turn-on of the switch are
synchronized to the rising edge of the external clock. The
frequency of the external sync signal must be ±33% with
respect to f OSC (as programmed by R FS ). Additionally,
the value of f SYNC must be between 70kHz and 700kHz.
Current Sense Resistor Considerations
The external current sense resistor (R SENSE in Figure 2)
allows the user to optimize the current limit behavior for
the particular application. As the current sense resistor
is varied from several ohms down to tens of milliohms,
peak switch current goes from a fraction of an ampere
to several amperes. Care must be taken to ensure proper
circuit operation, especially with small current sense
resistor values.
ISOLATION
BARRIER
V CC
LTC3805
I TH
FB
For example, with the peak current sense voltage of 100mV
on the I SENSE pin, a peak switch current of 5A requires
a sense resistor of 0.020Ω. Note that the instantaneous
peak power in the sense resistor is 0.5W and it must be
rated accordingly. The LTC3805 has only a single sense
line to this resistor. Therefore, any parasitic resistance
in the ground side connection of the sense resistor will
increase its apparent value. In the case of a 0.020Ω sense
resistor, one milliohm of parasitic resistance will cause a
5% reduction in peak switch current. So the resistance of
printed circuit copper traces and vias cannot necessarily
be ignored.
Programmable Slope Compensation
The LTC3805 injects a ramping current through its I SENSE
pin into an external slope compensation resistor R SLOPE .
This current ramp starts at zero right after the GATE pin
has been high for the LTC3805’s minimum duty cycle of
6%. The current rises linearly towards a peak of 10μA at
the maximum duty cycle of 80%, shutting off once the
GATE pin goes low. A series resistor R SLOPE connecting the
I SENSE pin to the current sense resistor R SENSE develops a
ramping voltage drop. From the perspective of the I SENSE
pin, this ramping voltage adds to the voltage across the
sense resistor, effectively reducing the current comparator
threshold in proportion to duty cycle. This stabilizes the
control loop against subharmonic oscillation. The amount
of reduction in the current comparator threshold ( ? V SENSE )
can be calculated using the following equation:
DutyCycle ? 6%
80%
Note: LTC3805 enforces 6% < Duty Cycle < 80%. A good
starting value for R SLOPE is 3k, which gives a 30mV drop
in current comparator threshold at 80% duty cycle.
Designs that do not operate at greater than 50% duty cycle
do not need slope compensation and may replace R SLOPE
with a direct connection.
GND
3805 F05
Figure 5. Circuit for Isolated Feedback
3805fg
14
相关PDF资料 |
PDF描述 |
|---|---|
| ADM693AANZ | IC SUPERVISOR MPU 4.4V WD 16DIP |
| ADM693AARWZ | IC SUPERVISOR MPU 4.4V WD 16SOIC |
| DLFL-0147-16D3 | DLFL SATURATION CHOKE 16A |
| GCC22DRAS-S734 | CONN EDGECARD 44POS .100 R/A SLD |
| EBC49DRXN-S734 | CONN EDGECARD 98POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3805HMSE#PBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3805HMSE#TRPBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3805HMSE-5#PBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3805HMSE-5#TRPBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3805IDD#PBF | 功能描述:IC REG CTRLR BST FLYBK PWM 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。