- 您现在的位置：买卖IC网 > PDF目录15351 > LTC3805IMSE#PBF (Linear Technology)IC REG CTRLR BST FLYBK CM 10MSOP PDF资料下载
参数资料
| 型号： | LTC3805IMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST FLYBK CM 10MSOP |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 700kHz |
| 占空比： | 95% |
| 电源电压： | 3.95 V ~ 75 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 相关产品： | 732-2264-6-ND - TRANS FLYBACK LTC3805 36.3UH 732-2264-1-ND - TRANS FLYBACK LTC3805 36.3UH 732-2264-2-ND - TRANS FLYBACK LTC3805 36.3UH |
LTC3805
APPLICATIONS INFORMATION
N BIAS = N SEC
C VCC ischargedtoV TURNON .Atthispoint,assumingV RUN
> V RUNON , the converter begins switching the external
MOSFET and ramps up the converter output voltage at
a rate set by the capacitor C SS on the SSFLT pin. Since
R START cannot supply enough current to operate the ex-
ternal MOSFET, C VCC begins discharging and V CC drops.
The soft-start must be fast enough and the discharge of
C VCC slow enough so that the output voltage reaches its
target value of 5V before V CC drops to V TURNOFF or the
converter would fail to start.
The typical application circuit in Figure 9 shows a different
flyback converter bias power strategy for a case in which
neither the input or output voltage is suitable for provid-
ing bias power to the LTC3805. A small NPN preregulator
transistor and a Zener diode are used to accelerate the
rise of V CC and reduce the value of the V CC bias capacitor.
The flyback transformer has an additional bias winding to
provide bias power. Note that this topology is very power-
ful because, by appropriate choice of transformer turns
ratio, the output voltage can be chosen without regard to
the value of the input voltage or the V CC bias power for
the LTC3805. The number of turns in the bias winding is
chosen according to
V CC + V D4
V OUT ? V D1
where N BIAS is the number of turns in the bias winding,
N SEC is the number of turns in the secondary winding,
V CC is the desired voltage to power the LTC3805, V OUT is
the converter output voltage, V D1 is the forward voltage
drop of D1 and V D4 is the forward voltage drop of D4.
Note that since V OUT is regulated by the converter control
loop, V CC is also regulated although not as precisely. The
value of V CC is often constrained since N BIAS and N SEC are
often a limited range of small integer numbers. For proper
operation, the value of V CC must be between V TURNON and
V TURNOFF . Since the ratio of V TURNON to V TURNOFF is over
two to one, this requirement is relatively easy to satisfy.
Figure 9 shows a similar low power nonisolated telecom
converter using a trickle charger.
Transformer Design Considerations
Transformer specification and design is perhaps the
most critical part of applying the LTC3805 successfully.
In addition to the usual list of caveats dealing with high
frequency power transformer design, the following should
prove useful.
Turns Ratios
Due to the use of the external feedback resistor divider
ratio to set output voltage, the user has relative freedom
in selecting transformer turns ratio to suit a given ap-
plication. Simple ratios of small integers, e.g., 1:1, 2:1,
3:2, etc. can be employed which yield more freedom in
setting total turns and transformer inductance. Simple
integer turns ratios also facilitate the use of “off-the-shelf”
configurable transformers. Turns ratio can be chosen on
the basis of desired duty cycle. However, remember that
the input supply voltage plus the secondary-to-primary
referred version of the flyback pulse (including leakage
spike) must not exceed the allowed external MOSFET
breakdown rating.
3805fg
12
相关PDF资料 |
PDF描述 |
|---|---|
| ECA43DRMH | CONN EDGECARD 86POS .125 SQ WW |
| B43086A2226M | 22UF 200V 10X20 SINGLE END |
| SXR152M016ST | CAP ALUM 1500UF 16V 20% RADIAL |
| ECA43DRMD | CONN EDGECARD 86POS .125 SQ WW |
| B41043A6157M | 150UF 50V 10X20 SINGLE END |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3805MPMSE#PBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3805MPMSE#TRPBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3805MPMSE-5#PBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3805MPMSE-5#TRPBF | 功能描述:IC REG CTRLR BST FLYBK CM 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3806EDE | 功能描述:IC REG CTRLR FLYBACK PWM 12-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。