- 您现在的位置：买卖IC网 > PDF目录15323 > LTC3808EDE#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 14-DFN PDF资料下载
参数资料
| 型号： | LTC3808EDE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 22/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 14-DFN |
| 标准包装： | 91 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 825kHz |
| 占空比： | 100% |
| 电源电压： | 2.75 V ~ 9.8 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 14-WFDFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页
LTC3808
APPLICATIO S I FOR ATIO
Checking Transient Response
The regulator loop response can be checked by looking at
the load transient response. Switching regulators take
several cycles to respond to a step in load current. When
a load step occurs, V OUT immediately shifts by an amount
equal to ( ? I LOAD ) ? (ESR), where ESR is the effective series
resistance of C OUT . ? I LOAD also begins to charge or
discharge C OUT generating a feedback error signal used by
the regulator to return V OUT to its steady-state value.
During this recovery time, V OUT can be monitored for
overshoot or ringing that would indicate a stability prob-
lem. OPTI-LOOP compensation allows the transient re-
sponse to be optimized over a wide range of output
capacitance and ESR values.
The I TH series R C -C C filter (see Functional Diagram) sets
the dominant pole-zero loop compensation.
The I TH external components showed in the figure on the
first page of this data sheet will provide adequate compen-
sation for most applications. The values can be modified
slightly (from 0.2 to 5 times their suggested values) to
optimize transient response once the final PC layout is
done and the particular output capacitor type and value
have been determined. The output capacitor needs to be
ponents, including a review of control loop theory, refer to
Application Note 76.
A second, more severe transient is caused by switching in
loads with large (>1 μ F) supply bypass capacitors. The
discharged bypass capacitors are effectively put in parallel
with C OUT , causing a rapid drop in V OUT . No regulator can
deliver enough current to prevent this problem if the load
switch resistance is low and it is driven quickly. The only
solution is to limit the rise time of the switch drive so that
the load rise time is limited to approximately (25) ?
(C LOAD ). Thus a 10 μ F capacitor would be require a 250 μ s
rise time, limiting the charging current to about 200mA.
Design Example
As a design example, assume V IN will be operating from a
maximum of 4.2V down to a minimum of 2.75V (powered
by a single lithium-ion battery). Load current requirement
is a maximum of 2A, but most of the time it will be in a
standby mode requiring only 2mA. Efficiency at both low
and high load currents is important. Burst Mode operation
at light loads is desired. Output voltage is 1.8V. The IPRG
pin will be left floating, so the maximum current sense
threshold ? V SENSE(MAX) is approximately 125mV.
decided upon because the various types and values deter-
mine the loop feedback factor gain and phase. An output
current pulse of 20% to 100% of full load current having
MaximumDuty Cycle =
V OUT
V IN ( MIN )
= 65 . 5 %
a rise time of 1 μ s to 10 μ s will produce output voltage and
I TH pin waveforms that will give a sense of the overall loop
From Figure 1, SF = 82%.
stability. The gain of the loop will be increased by increas-
ing R C and the bandwidth of the loop will be increased by
decreasing C C . The output voltage settling behavior is
R DS ( ON ) MAX =
5
6
? 0 . 9 ? SF ?
? V SENSE ( MAX )
I OUT ( MAX ) ? ρ T
= 0 . 032 ?
related to the stability of the closed-loop system and will
demonstrate the actual overall supply performance. For a
A 0.032 ? P-channel MOSFET in Si7540DP is close to this
value.
detailed explanation of optimizing the compensation com-
3808f
22
相关PDF资料 |
PDF描述 |
|---|---|
| UCA2G220MHD6TN | CAP ALUM 22UF 400V 20% RADIAL |
| ESC28DREH-S13 | CONN EDGECARD 56POS .100 EXTEND |
| LTC690IS8#TR | IC SUPERVISORY CIRCUIT MPU 8SOIC |
| LTC1778EGN-1 | IC REG CTRLR BUCK PWM CM 16-SSOP |
| LTC1778EGN#PBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3808EGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3808EGN#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3809EDD | 功能描述:IC REG CTRLR BUCK PWM CM 10-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3809EDD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3809EDD#TR | 功能描述:IC REG CTRLR BUCK PWM CM 10-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。