- 您现在的位置：买卖IC网 > PDF目录13130 > LTC3816EFE#PBF (Linear Technology)IC DC-DC CTLR S-PHASE 38TSSOP PDF资料下载
参数资料
| 型号： | LTC3816EFE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 28/44页 |
| 文件大小： | 0K |
| 描述： | IC DC-DC CTLR S-PHASE 38TSSOP |
| 标准包装： | 50 |
| 应用： | 控制器，Intel IMVP-6，IMVP-6.5? |
| 输入电压： | 4.5 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.013 V ~ 1.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-TFSOP （0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 38-TSSOP 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
LTC3816
APPLICATIONS INFORMATION
drops, which further improves efficiency by minimizing
gate charge losses.
t ON ( MIN ) =
V OUT
100mV/DIV
VID5
1V/DIV
DPRSLPVR
5V/DIV
3816 F15
V IN = 12V 0.1ms/DIV
V OUT = 0.75V TO 1.15V
C SLEW = 47pF
IMVP-6 CONFIGURATION
Figure 15. Programmable VID Slew Rate
the controller reduces the I CSLEW pull-up current from 40μA
to 10μA (deeper sleep mode). This effectively reduces the
VID DAC slew rate to 1/4 of its original value. If IMVP-6.5
is selected, the slow slew rate function is disabled.
PULSE-SKIPPING AND FORCED CONTINUOUS MODE
OPERATION
The LTC3816 can operate in one of two modes select-
able with the MODE/SYNC pin: pulse-skipping mode
or forced continuous mode. Shorting the MODE/SYNC
pin to INTV CC selects pulse-skipping mode. Pulse-skip-
ping mode is selected when high efficiency at very light
loads is desired. In this mode, when the inductor current
reverses, the bottom MOSFET turns off to minimize the
efficiency loss due to reverse current flow. This reduces
the conduction loss and slightly improves the efficiency.
As the load reduces, the top gate duty cycle shrinks to
maintain regulation. The LTC3816 is capable of operating
at extremely low duty cycles; hence, TG will continue to
run at a constant switching frequency until the top gate
on-time is less than 40ns to 50ns. When the load decreases
beyond this point, the LTC3816 TG begins to skip cycles
to maintain regulation. The driver switching frequency
Forcing the MODE/SYNC pin low enables forced continuous
mode operation. In forced continuous mode, the bottom
MOSFET is always on when the top MOSFET is off, allowing
the inductor current to reverse at low currents. This mode
is less efficient due to conduction and switching losses,
but has the advantage of better transient response at low
currents, constant frequency operation, and the ability to
maintain regulation when sinking current.
During soft-start, the LTC3816 forces the controller to
operate in pulse-skipping mode until the switcher output
voltage reaches its V BOOT power good threshold. During
VID code transitions, however, the controller always oper-
ates in forced continuous mode to allow the switcher to
sink current.
OPERATING FREQUENCY/FREQUENCY
SYNCHRONIZATION
The selection of switching frequency is a trade-off between
efficiency and component size. Low frequency operation
increases efficiency by reducing MOSFET switching losses,
but requires a larger inductance and/or capacitance to
maintain low output voltage ripple. For converters with
high step-down V IN -to-V OUT ratios, another consideration
is the minimum on-time of the converter.
V OUT
V IN ( MAX ) ? f OSC
If the MODE/SYNC pin is not driven by an external clock,
the RFREQ pin voltage configures the LTC3816 free-run-
ning switching frequency. Floating or shorting the RFREQ
pin to INTV CC allows the controller to run at the nominal
400kHz frequency. Connecting the RFREQ pin to GND
selects 210kHz. Tying RFREQ to a potential between 2.5V
and 3.5V selects 580kHz. The RFREQ pin has an internal
3816f
相关PDF资料 |
PDF描述 |
|---|---|
| MIC809JYC3 | IC RESET GEN 4.00V VTH SC70 |
| VI-JNP-EX-F3 | CONVERTER MOD DC/DC 13.8V 75W |
| LT1183CS | IC SW REG CCFL/LCD CONTRST16SOIC |
| FMC06DRYH-S13 | CONN EDGECARD 12POS .100 EXTEND |
| GMM15DTBT-S273 | CONN EDGECARD 30POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3816EUHF#PBF | 功能描述:IC DC-DC CTLR S-PHASE 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| LTC3816EUHF#TRPBF | 功能描述:IC CONTROLLER S-PHASE 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3816IFE#PBF | 功能描述:IC CONTROLLER S-PHASE 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3816IFE#TRPBF | 功能描述:IC CONTROLLER S-PHASE 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3816IUHF#PBF | 功能描述:IC CONTROLLER S-PHASE 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。