参数资料
型号: LTC3828EG#TRPBF
厂商: Linear Technology
文件页数: 11/32页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 28-SSOP
标准包装: 2,000
系列: PolyPhase®
PWM 型: 电流模式
输出数: 2
频率 - 最大: 590kHz
占空比: 99.4%
电源电压: 4.5 V ~ 28 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 28-SSOP(0.209",5.30mm 宽)
包装: 带卷 (TR)
LTC3828
OPERATION (Refer to Functional Diagram)
Frequency Synchronization
The phase-locked loop allows the internal oscillator to be
synchronized to an external source via the FCB/PLLIN pin.
The output of the phase detector at the PLLFLTR pin is
also the DC frequency control input of the oscillator that
operates over a 260kHz to 550kHz range corresponding
to a DC voltage input from 0V to 2.4V. When locked, the
PLL aligns the turn on of the top MOSFET to the rising
edge of the synchronizing signal.
The internal master oscillator runs at a frequency twelve
times that of each phase switching frequency. The PHSMD
pin (UH package only) determines the relative phases
between the internal controllers as well as the CLKOUT
signal as shown in Table 2. The phases tabulated are rela-
tive to zero phase being de?ned as the rising edge of the
top gate (TG1) driver output of controller 1.
Table 2
inductor current) operation over the widest possible output
current range. This constant frequency operation is not
as ef?cient as Burst Mode operation, but does provide a
lower noise, constant frequency operating mode down
to approximately 1% of the designed maximum output
current.
Continuous Current (PWM) Operation
Tying the FCB/PLLIN pin to ground will force continuous
current operation. This is the least ef?cient operating mode,
but may be desirable in certain applications. The output
can source or sink current in this mode. When sinking
current while in forced continuous operation, current will
be forced back into the main power supply potentially
boosting the input supply level.
Output Overvoltage Protection
An overvoltage comparator, OV, guards against transient
V PHSMD
Controller 1
Controller 2
CLKOUT
GND
180°
60°
OPEN
180°
90°
INTV CC
240°
120°
overshoots (>7.5%) as well as other more serious condi-
tions that may overvoltage the output. In this case, the top
MOSFET is turned off and the bottom MOSFET is turned
on until the overvoltage condition is cleared.
The CLKOUT signal can be used to synchronize additional
power stages in a multiphase power supply solution feeding
a single, high current output or separate outputs. Input
capacitance ESR requirements and ef?ciency losses are
substantially reduced because the peak current drawn from
the input capacitor is effectively divided by the number of
phases used and power loss is proportional to the RMS
current squared. A 2-phase, single output voltage imple-
mentation can reduce input path power loss by 75% and
radically reduce the required RMS current rating of the
input capacitor(s).
In the G28 package, CLKOUT is 90° out of phase with
channel 1 and channel 2.
Constant Frequency Operation
When the FCB/PLLIN pin is tied to INTV CC , Burst Mode
operation is disabled and the forced minimum output
current requirement is removed. This provides constant
frequency, discontinuous current (preventing reverse
Power Good (PGOOD) Pin
The PGOOD pin is connected to an open drain of an internal
MOSFET. The MOSFET turns on and pulls the pin down
when the enabled channel’s output is not within ±7.5% of
the nominal output level as determined by the feedback
resistor divider. When the enabled channel’s output meets
the ±7.5% requirement, the MOSFET is turned off within
10μs and the pin is allowed to be pulled up by an external
resistor to source of up to 5.5V. If either channel 1 or chan-
nel 2 is shut down by driving its RUN pin low, PGOOD will
ignore the state of that channel’s ouput.
Foldback Current
Foldback current limiting is activated when the output
voltage falls below 70% of its nominal level. If a short
is present, a safe, low output current is provided due to
internal current foldback and actual power wasted is low
due to the ef?cient nature of the current mode switching
regulator. This function is disabled at start-up.
3828fc
11
相关PDF资料
PDF描述
LTC3780EG#TRPBF IC REG CTRLR BST PWM CM 24-SSOP
LTC3721EUF-1#PBF IC REG CTRLR ISO PWM CM 16-QFN
LTC3721EUF-1 IC REG CTRLR ISO PWM CM 16-QFN
LTC3723EGN-2#PBF IC REG CTRLR FLYBK ISO VM 16SSOP
LTC3723EGN-2 IC REG CTRLR FLYBK ISO VM 16SSOP
相关代理商/技术参数
参数描述
LTC3828EUH 制造商:Linear Technology 功能描述:DC DC Cntrlr Dual-OUT Sync Step Down 4.5V to 28V Input 32-Pin QFN EP
LTC3828EUH#PBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3828EUH#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3829EFE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3829EFE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX