参数资料
型号: LTC3850IGN#PBF
厂商: Linear Technology
文件页数: 22/38页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 28-SSOP
产品培训模块: LTC3850 Dual Output DC/DC Switching Regulator Controller
标准包装: 49
系列: PolyPhase®
PWM 型: 电流模式
输出数: 2
频率 - 最大: 860kHz
占空比: 97.2%
电源电压: 4 V ~ 30 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 28-SSOP(0.154",3.90mm 宽)
包装: 管件
LTC3850/LTC3850-1
APPLICATIONS INFORMATION
? V OUT ≈ I RIPPLE ? ESR +
? I L(SC) = t ON(MIN) ?
I SC =
– ? I L(SC)
V OUT = 0.8V ? ? 1 + B ?
R B C FF
suggested. A 2.2? – 10? resistor placed between C IN
(C1) and the V IN pin provides further isolation between
the two channels.
The selection of C OUT is driven by the effective series
resistance (ESR). Typically, once the ESR requirement
is satisfied, the capacitance is adequate for filtering. The
output ripple (?V OUT ) is approximated by:
? 1 ?
?
? 8fC OUT ?
where f is the operating frequency, C OUT is the output
capacitance and I RIPPLE is the ripple current in the induc-
tor. The output ripple is highest at maximum input voltage
since I RIPPLE increases with input voltage.
Setting Output Voltage
The LTC3850 output voltages are each set by an external
feedback resistive divider carefully placed across the out-
put, as shown in Figure 9. The regulated output voltage
is determined by:
? R ?
? R A ?
To improve the frequency response, a feed-forward ca-
pacitor, C FF , may be used. Great care should be taken to
route the V FB line away from noise sources, such as the
inductor or the SW line.
V OUT
1/2 LTC3850
V FB
R A
38501 F09
Figure 9. Setting Output Voltage
Fault Conditions: Current Limit and Current Foldback
The LTC3850 includes current foldback to help limit load
current when the output is shorted to ground. If the out-
put falls below 50% of its nominal output level, then the
maximum sense voltage is progressively lowered from its
maximum programmed value to one-third of the maximum
value. Foldback current limiting is disabled during the
soft-start or tracking up. Under short-circuit conditions
with very low duty cycles, the LTC3850 will begin cycle
skipping in order to limit the short-circuit current. In this
situation the bottom MOSFET will be dissipating most of
the power but less than in normal operation. The short-
circuit ripple current is determined by the minimum on-
time t ON(MIN) of the LTC3850 (≈ 90ns), the input voltage
and inductor value:
V IN
L
The resulting short-circuit current is:
1/3 V SENSE(MAX) 1
R SENSE 2
Phase-LockedLoopandFrequencySynchronization
The LTC3850 has a phase-locked loop (PLL) comprised of
an internal voltage-controlled oscillator (V CO ) and a phase
detector. This allows the turn-on of the top MOSFET of
controller 1 to be locked to the rising edge of an external
clock signal applied to the MODE/PLLIN pin. The turn-on
of controller 2’s top MOSFET is thus 180 degrees out-
of-phase with the external clock. The phase detector is
an edge sensitive digital type that provides zero degrees
phase shift between the external and internal oscillators.
This type of phase detector does not exhibit false lock to
harmonics of the external clock.
The output of the phase detector is a pair of complemen-
tary current sources that charge or discharge the external
filter network connected to the FREQ/PLLFLTR pin. The
relationship between the voltage on the FREQ/PLLFLTR
pin and operating frequency is shown in Figure 10 and
specified in the Electrical Characteristics table. Note that
the LTC3850 can only be synchronized to an external clock
whose frequency is within range of the LTC3850’s internal
V CO . This is guaranteed to be between 250kHz and 780kHz.
A simplified block diagram is shown in Figure 11.
If no clock is applied to MODE/PLLIN pin, the FREQ/
PLLFLTR pin will be high impedance.
If the external clock frequency is greater than the internal
oscillator’s frequency, f OSC , then current is sourced con-
38501fc
22
相关PDF资料
PDF描述
LTC3851EGN#PBF IC REG CTRLR BUCK PWM CM 16-SSOP
LTC3851EMSE-1#PBF IC REG CTRLR BUCK PWM CM 16-MSOP
LTC3852EUDD#PBF IC REG CTRLR DOUBLER PWM 24-QFN
LTC3853EUJ#PBF IC REG CTRLR BUCK PWM CM 40-QFN
LTC3854EMSE#PBF IC REG CTRLR BUCK PWM CM 12-MSOP
相关代理商/技术参数
参数描述
LTC3850IUF#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3850IUF#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3850IUFD#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC3850IUFD#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3851AEGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR