参数资料
型号: LTC3851EGN#PBF
厂商: Linear Technology
文件页数: 14/28页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 16-SSOP
产品培训模块: LTC3851 Single Output DC/DC Switching Regulator Controller
特色产品: Wide Input Voltage Range Synchronous Step-Down DC/DC Controller
标准包装: 100
PWM 型: 电流模式
输出数: 1
频率 - 最大: 790kHz
占空比: 99%
电源电压: 4 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
包装: 管件
产品目录页面: 1336 (CN2011-ZH PDF)
LTC3851
APPLICATIONS INFORMATION
The peak-to-peak drive levels are set by the INTV CC voltage.
This voltage is typically 5V during start-up. Consequently,
logic-level threshold MOSFETs must be used in most ap-
plications. The only exception is if low input voltage is ex-
pected (V IN < 5V); then, sub-logic level threshold MOSFETs
(V GS(TH) < 3V) should be used. Pay close attention to the
BV DSS speci?cation for the MOSFETs as well; most of the
logic-level MOSFETs are limited to 30V or less.
Selection criteria for the power MOSFETs include the on-
resistance, R DS(ON) , Miller capacitance, C MILLER , input
voltage and maximum output current. Miller capacitance,
C MILLER , can be approximated from the gate charge curve
usually provided on the MOSFET manufacturers’ data
sheet. C MILLER is equal to the increase in gate charge
along the horizontal axis while the curve is approximately
?at divided by the speci?ed change in V DS . This result is
then multiplied by the ratio of the application applied V DS
to the gate charge curve speci?ed V DS . When the IC is
operating in continuous mode, the duty cycles for the top
and bottom MOSFETs are given by:
Both MOSFETs have I 2 R losses while the topside N-channel
equation includes an additional term for transition losses,
which are highest at high input voltages. For V IN < 20V,
the high current ef?ciency generally improves with larger
MOSFETs, while for V IN > 20V, the transition losses rapidly
increase to the point that the use of a higher R DS(ON) device
with lower C MILLER actually provides higher ef?ciency. The
synchronous MOSFET losses are greatest at high input
voltage when the top switch duty factor is low or during
short-circuit when the synchronous switch is on close to
100% of the period.
The term (1 + δ ) is generally given for a MOSFET in the
form of a normalized R DS(ON) vs Temperature curve, but
δ = 0.005/°C can be used as an approximation for low
voltage MOSFETs.
The optional Schottky diode conducts during the dead time
between the conduction of the two power MOSFETs. This
prevents the body diode of the bottom MOSFET from turn-
ing on, storing charge during the dead time and requiring
a reverse recovery period that could cost as much as 3%
V OUT
Main Switch Duty Cycle =
V IN
Synchronous Switch Duty Cycle =
V IN – V OUT
V IN
in ef?ciency at high V IN . A 1A to 3A Schottky is generally
a good size due to the relatively small average current.
Larger diodes result in additional transition losses due to
their larger junction capacitance.
Soft-Start and Tracking
The MOSFET power dissipations at maximum output
current are given by:
The LTC3851 has the ability to either soft-start by itself
with a capacitor or track the output of another channel
( I MAX ) 2 ( 1 + δ ) R DS(ON) +
( I MAX ) 2 ( 1 + δ ) R DS(ON)
P MAIN =
P SYNC =
V OUT
V IN
? ? 2 ? ?
( V IN ) 2 ? I MAX ? ( R DR ) ( C MILLER ) ?
? ?
? 1 1 ?
? + ? (f)
? V INTVCC – V TH(MIN) V TH(MIN) ?
V IN – V OUT
V IN
or external supply. When the LTC3851 is con?gured to
soft-start by itself, a capacitor should be connected to
the TK/SS pin. The LTC3851 is in the shutdown state if
the RUN pin voltage is below 1.25V. TK/SS pin is actively
pulled to ground in this shutdown state.
Once the RUN pin voltage is above 1.25V, the LTC3851
powers up. A soft-start current of 1μA then starts to charge
its soft-start capacitor. Note that soft-start or tracking is
achieved not by limiting the maximum output current of
the controller but by controlling the output ramp voltage
where δ is the temperature dependency of R DS(ON) and
R DR (approximately 2 Ω ) is the effective driver resistance
according to the ramp rate on the TK/SS pin. Current
foldback is disabled during this phase to ensure smooth
soft-start or tracking. The soft-start or tracking range is
at the MOSFET’s Miller threshold voltage. V TH(MIN) is the
typical MOSFET minimum threshold voltage.
3851fb
14
相关PDF资料
PDF描述
LTC3851EMSE-1#PBF IC REG CTRLR BUCK PWM CM 16-MSOP
LTC3852EUDD#PBF IC REG CTRLR DOUBLER PWM 24-QFN
LTC3853EUJ#PBF IC REG CTRLR BUCK PWM CM 40-QFN
LTC3854EMSE#PBF IC REG CTRLR BUCK PWM CM 12-MSOP
LTC3855IUJ#PBF IC REG CTRLR BUCK PWM CM 40-QFN
相关代理商/技术参数
参数描述
LTC3851EMSE#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3851EMSE#PBF 制造商:Linear Technology 功能描述:Switch Regulator IC 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN REGULATOR CTRL MSOP-16
LTC3851EMSE#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LTC3851EMSE-1#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LTC3851EMSE-1#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)