- 您现在的位置：买卖IC网 > PDF目录15347 > LTC3854EDDB#TRMPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 12-DFN PDF资料下载
参数资料
| 型号： | LTC3854EDDB#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 12-DFN |
| 标准包装： | 500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 440kHz |
| 占空比： | 98% |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3854
APPLICATIONS INFORMATION
ESR ≤
L ( ? I )
2 ( ? V ) V OUT
V OUT = 0.8 ? 1 + B ?
R B
C FF
TherequiredESRduetoaloadcurrentstepis:
? V
? I
where ? I is the change in current from full load to zero load
(or minimum load) and ? V is the allowed voltage devia-
tion (not including any droop due to finite capacitance).
The amount of capacitance needed is determined by the
maximum energy stored in the inductor. The capacitance
must be sufficient to absorb the change in inductor current
when a high current to low current transition occurs. The
opposite load current transition is generally determined by
the control loop OPTI-LOOP components, so make sure
not to over compensate and slow down the response. The
minimum capacitance to assure the inductors’ energy is
adequately absorbed is:
2
C OUT >
Manufacturers such as Nichicon, United Chemi-Con
and Sanyo should be considered for high performance
through-hole capacitors. The OS-CON semiconductor
electrolyte capacitor available from Sanyo has the lowest
(ESR)(size) product of any aluminum electrolytic at a
somewhat higher price. An additional ceramic capacitor
in parallel with OS-CON capacitors is recommended to
reduce the inductive effects.
In surface mount applications, ESR, RMS current handling
and load step specifications may require multiple capaci-
tors in parallel. Aluminum electrolytic, dry tantalum and
special polymer capacitors are available in surface mount
packages. Special polymer surface mount capacitors offer
very low ESR but have much lower capacitive density per
unit volume than other capacitor types. These capacitors
offer a very cost-effective output capacitor solution and are
an ideal choice when combined with a controller having
high loop bandwidth. Tantalum capacitors offer the highest
capacitance density and are often used as output capaci-
tors for switching regulators having controlled soft-start.
Several excellent surge-tested choices are the AVX TPS,
AVX TPSV or the KEMET T51 0 series of surface mount
tantalums, available in case heights ranging from 1.5mm
to 4.1mm. Aluminum electrolytic capacitors can be used
in cost-driven applications, provided that consideration is
given to ripple current ratings, temperature and long-term
reliability. A typical application will require several alumi-
num electrolytic capacitors in parallel. A combination of the
above mentioned capacitors will often result in maximizing
performance and minimizing overall cost. Other capacitor
types include Nichicon PL series, NEC Neocap, Panasonic
SP and Sprague 595D series. Consult manufacturers for
other specific recommendations.
Like all components, capacitors are not ideal. Each
capacitor has its own benefits and limitations. Combina-
tions of different capacitor types have proven to be a very
cost effective solution. Remember also to include high
frequency decoupling capacitors. They should be placed
as close as possible to the power pins of the load. Any
inductance present in the circuit board traces negates
their usefulness.
Setting Output Voltage
The LTC3854 output voltage is set by an external feed-
back resistive divider carefully placed across the output,
as shown in Figure 3. The regulated output voltage is
determined by:
? R ?
? R A ?
V OUT
LTC3854
FB
R A
3854 F03
Figure 3. Feed-Forward Capacitor on FB Pin
To improve the frequency response, a feed-forward ca-
pacitor, C FF , may be used. Great care should be taken to
route the V FB line away from noise sources, such as the
inductor or the SW line.
Fault Conditions: Current Foldback
The LTC3854 includes current foldback to help limit load
current when the output is shorted to ground. If the output
falls below 40% of its nominal output level, the maximum
3854fb
15
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1622CS8#TR | IC REG CTRLR BUCK PWM CM 8-SOIC |
| LTC1872ES6#TR | IC REG CTRLR BST PWM CM SOT23-6 |
| LTC1872ES6#TRPBF | IC REG CTRLR BST PWM CM SOT23-6 |
| LTC1872ES6#TRM | IC REG CTRLR BST PWM CM SOT23-6 |
| UVY1C332MHD | CAP ALUM 3300UF 16V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3854EMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3854EMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3854IDDB#PBF | 制造商:Linear Technology 功能描述:DP-SWREG/Controller, Cut Tape Small Footprint, Low Pin Count Synchronous Step-Do |
| LTC3854IDDB#TRMPBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3854IDDB#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。