- 您现在的位置：买卖IC网 > PDF目录15288 > LTC3862IGN#TRPBF (Linear Technology)IC REG CTRLR BST PWM CM 24-SSOP PDF资料下载
参数资料
| 型号： | LTC3862IGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/42页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM 24-SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 500kHz |
| 占空比： | 96% |
| 电源电压： | 4 V ~ 36 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 24-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
LTC3862
OPERATION
To prevent the maximum junction temperature from be-
ing exceeded, the input supply current to the IC should
be checked when operating in continuous mode (heavy
load) at maximum V IN . A tradeoff between the operating
frequency and the size of the power MOSFETs may need
to be made in order to maintain a reliable junction tem-
perature. Finally, it is important to verify the calculations
by performing a thermal analysis of the final PCB using
an infrared camera or thermal probe. As an option, an
external regulator shown in Figure 3 can be used to reduce
the total power dissipation on the IC.
Thermal Shutdown Protection
In the event of an overtemperature condition (external
or internal), an internal thermal monitor will shut down
the gate drivers and reset the soft-start capacitor if the
die temperature exceeds 170°C. This thermal sensor has
a hysteresis of 10°C to prevent erratic behavior at hot
temperatures. The LTC3862’s internal thermal sensor is
intended to protect the device during momentary over-
temperature conditions. Continuous operation above
the specified maximum operating junction temperature,
however, may result in device degradation.
Operation at Low Supply Voltage
If the input voltage V IN is low enough for the INTV CC LDO
to be in dropout, then the minimum gate drive supply
voltage is:
V INTVCC = V IN(MIN) – V DROPOUT
The LDO dropout voltage is a function of the total gate
drive current and the quiescent current of the IC (typically
3mA). A curve of dropout voltage vs output current for the
LDO is shown in Figure 2. The temperature coefficient of
the LDO dropout voltage is approximately 6000ppm/°C.
The total Q-current (I Q(TOT) ) flowing in the LDO is the sum
of the controller quiescent current (3mA) and the total gate
charge drive current.
I Q(TOT) = I Q + Q G(TOT) ? f
After the calculations have been completed, it is important
to measure the gate drive waveforms and the gate driv-
er supply voltage (INTV CC to PGND) over all operating
conditions (low V IN , nominal V IN and high V IN , as well
as from light load to full load) to ensure adequate power
MOSFET enhancement. Consult the power MOSFET data
sheet to determine the actual R DS(ON) for the measured
V GS , and verify your thermal calculations by measuring
the component temperatures using an infrared camera
or thermal probe.
The LTC3862 has a minimum input voltage of 4V, making it
a good choice for applications that experience low supply
conditions. The gate driver for the LTC3862 consists of
PMOS pull-up and NMOS pull-down devices, allowing
the full INTV CC voltage to be applied to the gates during
power MOSFET switching. Nonetheless, care should be
taken to determine the minimum gate drive supply voltage
(INTV CC ) in order to choose the optimum power MOSFETs.
Important parameters that can affect the minimum gate
drive voltage are the minimum input voltage (V IN(MIN) ),
the LDO dropout voltage, the Q G of the power MOSFETs,
and the operating frequency.
1600
1400
1200
1000
800
600
400
200
0
0
10
125°C
20 30
INTV CC LOAD (mA)
150°C
85°C
25°C
–40°C
40 50
3862 F02
Figure 2. INTV CC LDO Dropout Voltage vs Current
3862fc
14
For more information www.linear.com/LTC3862
相关PDF资料 |
PDF描述 |
|---|---|
| H2AAT-10102-Y8-ND | JUMPER-H1502TR/A3048Y/H1502TR 2" |
| LTC3785EUF-1#PBF | IC REG CTRLR BST PWM VM 24-QFN |
| RLB9012-391KL | INDUCTOR HI CURRENT RADIAL 390UH |
| LTC1735IGN-1#TRPBF | IC REG CTRLR BUCK PWM CM 16-SSOP |
| RBA31DCBS | CONN EDGECARD 62POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3862IUH#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3862IUH#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3862IUH-1#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3862IUH-1#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3862IUH-2#PBF | 功能描述:IC REG CTRLR BST PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。