- 您现在的位置：买卖IC网 > PDF目录15310 > LTC3866EUF#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 24-QFN PDF资料下载
参数资料
| 型号： | LTC3866EUF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/36页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 24-QFN |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 850kHz |
| 占空比： | 95% |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC3866
APPLICATIONS INFORMATION
R ITEMP :
20 R S = 22.6k
R P = 90.9k
R O = 100k
T O = 25°C
5
R NTC
50
45
40
CORRECTED
35 I MAX
30
25
UNCORRECTED
15 NTC THERMISTOR: I MAX
10
B = 4334
NOMINAL I MAX = 30A
0
–50 –25 0 25 50 75 100 125 150
INDUCTOR TEMPERATURE (°C)
3866 F05
Figure 5. Worst-Case I MAX Versus Inductor Temperature Curve
with and without NTC Temperature Compensation
V OUT
L1
SW1
3867 F08
Figure 6. Thermistor Location. Place the Thermistor Next to
the Inductor for Accurate Sensing of the Inductor Temperature,
But Keep the ITEMP Pin Away from the Switch Nodes and Gate
Drive Traces
For the most accurate temperature detection, place the
thermistor next to the output inductor as shown in Figure?6.
Care should be taken to keep the ITEMP sense line away
from switch nodes.
Pre-Biased Output Start-Up
There may be situations that require the power supply to
start up with a pre-bias on the output capacitors. In this
case, it is desirable to start up without discharging that
output pre-bias. The LTC3866 can safely power up into a
pre-biased output without discharging it.
The LTC3866 accomplishes this by disabling both TG and
BG until the TK/SS pin voltage and the internal soft-start
voltage are above the V FB pin voltage. When V FB is higher
than TK/SS or the internal soft-start voltage, the error amp
output is railed low. The control loop would like to turn
BG on, which would discharge the output. Disabling BG
and TG prevents the pre-biased output voltage from being
discharged. When TK/SS and the internal soft-start both
cross 500mV or V FB , whichever is lower, TG and BG are
enabled. If the pre-bias is higher than the OV threshold,
the bottom gate is turned on immediately to pull the output
back into the regulation window.
Overcurrent Fault Recovery
When the output of the power supply is loaded beyond
its preset current limit, the regulated output voltage
will collapse depending on the load. The output may be
shorted to ground through a very low impedance path or
it may be a resistive short, in which case the output will
collapse partially, until the load current equals the preset
current limit. The controller will continue to source current
into the short. The amount of current sourced depends
on the ILIM pin setting and the V FB voltage as shown in
the Current Foldback graph in the Typical Performance
Characteristics section.
Upon removal of the short, the output soft starts using
the internal soft-start, thus reducing output overshoot. In
the absence of this feature, the output capacitors would
have been charged at current limit, and in applications
with minimal output capacitance this may have resulted
in output overshoot. Current limit foldback is not disabled
during an overcurrent recovery. The load must step below
the folded back current limit threshold in order to restart
from a hard short.
Thermal Protection
Excessive ambient temperatures, loads and inadequate
airflow or heat sinking can subject the chip, inductor,
FETs etc. to high temperatures. This thermal stress re-
duces component life and if severe enough, can result
in immediate catastrophic failure (Note 4). To protect the
power supply from undue thermal stress, the LTC3866
has a fixed chip temperature-based thermal shutdown.
The internal thermal shutdown is set for approximately
160°C with 10°C of hysteresis. When the chip reaches
160°C, both TG and BG are disabled until the chip cools
down below 150°C.
3866fb
17
相关PDF资料 |
PDF描述 |
|---|---|
| LT3759HMSE#PBF | IC REG CTRLR BST INV PWM 12-MSOP |
| LT1725CGN#TR | IC REG CTRLR FLYBK ISO CM 16SSOP |
| UCA2V330MHD1TN | CAP ALUM 33UF 350V 20% RADIAL |
| B41042A3827M | 820UF 10V 10X20 SINGLE END |
| LT3757HMSE#TRPBF | IC REG CTRLR PWM CM 10-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3866IFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3866IFE#PBF | 制造商:Linear Technology 功能描述:BUCK REGULATOR CURRENT MODE SYNC TSSOP |
| LTC3866IFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3866IUF#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3866IUF#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。