- 您现在的位置：买卖IC网 > PDF目录79878 > LTC3869IGN-2#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, PDSO28 PDF资料下载
参数资料
| 型号： | LTC3869IGN-2#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO28 |
| 封装： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-28 |
| 文件页数： | 3/40页 |
| 文件大小： | 2705K |
| 代理商： | LTC3869IGN-2#TRPBF |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
LTC3869/LTC3869-2
11
3869f
Light Load Current Operation (Burst Mode Operation,
Pulse-Skipping, or Continuous Conduction)
The LTC3869 can be enabled to enter high efficiency Burst
Modeoperation,constant-frequencypulse-skippingmode,
or forced continuous conduction mode. To select forced
continuous operation, tie the MODE/PLLIN pin to a DC
voltage below 0.6V (e.g., SGND). To select pulse-skipping
mode of operation, tie the MODE/PLLIN pin to INTVCC. To
select Burst Mode operation, float the MODE/PLLIN pin.
When a controller is enabled for Burst Mode operation,
the peak current in the inductor is set to approximately
one-third of the maximum sense voltage even though the
voltageontheITHpinindicatesalowervalue.Iftheaverage
inductor current is higher than the load current, the error
amplifier EA will decrease the voltage on the ITH pin. When
the ITH voltage drops below 0.5V, the internal sleep signal
goes high (enabling sleep mode) and the top MOSFET is
turned off immediately, but the bottom MOSFET is turned
off when the inductor current reaches zero.
In sleep mode, the load current is supplied by the output
capacitor. As the output voltage decreases, the EA’s output
begins to rise. When the output voltage drops enough, the
sleep signal goes low, and the controller resumes normal
operation by turning on the top external MOSFET on the
next cycle of the internal oscillator. When a controller is
enabled for Burst Mode operation, the inductor current is
not allowed to reverse. The reverse current comparator
(IREV) turns off the bottom external MOSFET just before
the inductor current reaches zero, preventing it from
reversing and going negative. Thus, the controller oper-
ates in discontinuous operation. In forced continuous
operation, the inductor current is allowed to reverse at
light loads or under large transient conditions. The peak
inductor current is determined by the voltage on the ITH
pin. In this mode, the efficiency at light loads is lower than
in Burst Mode operation. However, continuous mode has
theadvantagesofloweroutputrippleandlessinterference
with audio circuitry.
When the MODE/PLLIN pin is connected to INTVCC, the
LTC3869 operates in PWM pulse-skipping mode at light
loads.Atverylight loads,thecurrentcomparatorICMPmay
remain tripped for several cycles and force the external top
MOSFET to stay off for the same number of cycles (i.e.,
skipping pulses). The inductor current is not allowed to
reverse (discontinuous operation). This mode, like forced
continuous operation, exhibits low output ripple as well as
low audio noise and reduced RF interference as compared
to Burst Mode operation. It provides higher low current
efficiency than forced continuous mode, but not nearly as
high as Burst Mode operation.
Single Output Multiphase Operation
The LTC3869 can be used for single output multiphase
converters by making these connections
Tie all of the ITH pins together.
Tie all of the VFB pins together.
Tie all of the TK/SS pins together.
Tie all of the RUN pins together.
LTC3869 has excellent current matching performance
between channels to ensure that there are equal thermal
stress for both channels.
Frequency Selection and Phase-Locked Loop
(FREQ and MODE/PLLIN Pins)
Theselectionofswitchingfrequencyisatrade-offbetween
efficiency and component size. Low frequency operation
increasesefficiencybyreducingMOSFETswitchinglosses,
butrequireslargerinductanceand/orcapacitancetomain-
tain low output ripple voltage. The switching frequency of
theLTC3869controllercanbeselectedusingtheFREQpin.
If the MODE/PLLIN pin is not being driven by an external
clock source, the FREQ pin can be used to program the
controller’s operating frequency from 250kHz to 780kHz.
There is a precision 10A current flowing out of the FREQ
pin, so the user can program the controller’s switching
frequency with a single resistor to SGND. A curve is
provided later in the application section showing the
relationship between the voltage on the FREQ pin and
switching frequency.
OPERATION
相关PDF资料 |
PDF描述 |
|---|---|
| LX1661CDT | 1.5 A SWITCHING CONTROLLER, PDSO16 |
| LS4001-9PV2TB1 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LH3020-2D5 | 3-OUTPUT AC-DC UNREG PWR SUPPLY MODULE |
| LK1001-7ERD6TB1 | 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE |
| LT1029MZ | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, PBCY3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3869IUFD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3869IUFD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3872EDDB#PBF | 制造商:Linear Technology 功能描述:DC DC Cntrlr Single-OUT Step Up 2.75V to 9.8V Input 8-Pin DFN EP 制造商:Linear Technology 功能描述:BOOST 2.75 - 9.8V 550KHZ 8D 制造商:Linear Technology 功能描述:BOOST, 2.75 - 9.8V, 550KHZ, 8DFN |
| LTC3872EDDB#TRMPBF | 功能描述:IC REG CTRLR BST PWM CM 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3872EDDB#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。