- 您现在的位置：买卖IC网 > PDF目录15356 > LTC3873ETS8#TRMPBF (Linear Technology)IC REG CTRLR BST FLYBK TSOT23-8 PDF资料下载
参数资料
| 型号： | LTC3873ETS8#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/16页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST FLYBK TSOT23-8 |
| 标准包装： | 500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 240kHz |
| 占空比： | 84% |
| 电源电压： | 8.8 V ~ 75 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SOT-23-8 薄型，TSOT-23-8 |
| 包装： | 带卷 (TR) |
LTC3873
APPLICATIONS INFORMATION
plus the secondary-to-primary referred voltage of the
?yback pulse (including leakage spike) must not exceed
the allowed external MOSFET breakdown rating.
Leakage Inductance
Transformer leakage inductance (on either the primary
or secondary) causes a voltage spike to occur after the
output switch (Q1) turn-off. This is increasingly prominent
Output Capacitors
The output capacitor is normally chosen by its effective
series resistance (ESR), which determines output ripple
voltage and affects ef?ciency. Low ESR ceramic capaci-
tors are often used to minimize the output ripple. Boost
regulators have large RMS ripple current in the output
capacitor that must be rated to handle the current. The
output ripple current (RMS) is:
at higher load currents where more stored energy must
be dissipated. In some cases a “snubber” circuit will be
required to avoid overvoltage breakdown at the MOSFET’s
I RMS ( COUT ) ≈ I OUT ( MAX ) ?
V OUT – V IN ( MIN )
V IN ( MIN )
drain node. Application Note 19 is a good reference on
snubber design. A bi?lar or similar winding technique is a
good way to minimize troublesome leakage inductances.
However, remember that this will limit the primary-to-
secondary breakdown voltage, so bi?lar winding is not
always practical.
Output ripple is then simply:
V OUT = R ESR ( Δ I L(RMS) )
The output capacitor for ?yback converter should have a
ripple current rating greater than:
Power MOSFET Selection
The power MOSFET serves two purposes in the LTC3873:
I RMS = I OUT ?
D MAX
1 – D MAX
it represents the main switching element in the power path
and its R DS(ON) represents the current sensing element
for the control loop. Important parameters for the power
MOSFET include the drain-to-source breakdown voltage
(BV DSS ), the threshold voltage (V GS(TH) ), the on-resistance
(R DS(ON) ) versus gate-to-source voltage, the gate-to-source
and gate-to-drain charges (Q GS and Q GD , respectively),
the maximum drain current (I D(MAX) ) and the MOSFET’s
thermal resistances (R TH(JC) and R TH(JA) ).
For boost applications with R DS(ON) sensing, refer to
Input Capacitors
The input capacitor of a boost converter is less critical due
to the fact that the input current waveform is triangular, and
does not contain large square wave currents as found in
the output capacitor. The input voltage source impedance
determines the size of the capacitor that is typically 10μF to
100μF. A low ESR is recommended although not as critical
as the output capacitor can be on the order of 0.3 Ω .
The RMS input ripple current for a boost converter is:
the LTC3872 data sheet for the selection of MOSFET
R DS(ON) .
MOSFETs have conduction losses (I 2 R) and switching
I RMS ( CIN ) = 0 . 3 ?
V IN ( MIN )
L ? f
? D MAX
losses. For V DS < 20V, high current ef?ciency generally
improves with large MOSFETs with low R DS(ON) , while
for V DS > 20V the transition losses rapidly increase to the
point that the use of a higher R DS(ON) device with lower
reverse transfer capacitance, C RSS , actually provides
Please note that the input capacitor can see a very high
surge current when a battery is suddenly connected to the
input of the converter and solid tantalum capacitors can
fail catastrophically under these conditions.
higher ef?ciency.
3873fa
11
相关PDF资料 |
PDF描述 |
|---|---|
| ESC19DRAN | CONN EDGECARD 38POS R/A .100 SLD |
| H2BBT-10104-S4-ND | JUMPER-H1500TR/A2015S/H1500TR 4" |
| VI-B14-EV-F2 | CONVERTER MOD DC/DC 48V 150W |
| LTC3873EDDB-5#TRMPBF | IC REG CTRLR BST FLYBK PWM 8-DFN |
| H2BBT-10104-R4-ND | JUMPER-H1500TR/A2015R/H1500TR 4" |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3873IDDB-5#PBF | 制造商:Linear Technology 功能描述:DP-SWREG/Isolated, Cut Tape No Rsense Constant Frequency Current Mode Boost/Flyb |
| LTC3873IDDB-5#TRMPBF | 功能描述:IC REG CTRLR BST FLYBK PWM 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3873IDDB-5#TRPBF | 功能描述:IC REG CTRLR BST FLYBK PWM 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3873ITS8-5#PBF | 制造商:Linear Technology 功能描述:DP-SWREG/Isolated, Cut Tape No Rsense Constant Frequency Current Mode Boost/Flyb |
| LTC3873ITS8-5#TRMPBF | 功能描述:IC REG CTRLR BST FLYBK TSOT23-8 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。