- 您现在的位置：买卖IC网 > PDF目录15338 > LTC3878IGN#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SSOP PDF资料下载
参数资料
| 型号： | LTC3878IGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/26页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 2MHz |
| 占空比： | 90% |
| 电源电压： | 4 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
LTC3878
APPLICATIONS INFORMATION
I LIMIT =
V SNS ( MAX ) 1
R DS ( ON ) ? ρ T
+ ? ? I L
(
)
t DELAY =
? C SS = 1 . 3 s / μF C SS
1 . 2 μA
( RUN / SS – 0 . 6 V ) – 0 . 8 V
I LIMIT ( SS ) = I LIMIT ?
2 . 4 V – 0 . 8 V
Fault Conditions: Current Limit and Foldback
The maximum inductor current is inherently limited in a
current mode controller by the maximum sense voltage.
In the LTC3878, the maximum sense voltage is controlled
by the voltage on the V RNG pin. With valley current mode
control, the maximum sense voltage and the sense re-
sistance determine the maximum allowed inductor valley
current. The corresponding output current limit is:
2
The current limit value should be checked to ensure that
I LIMIT(MIN) > I OUT(MAX) . The current limit value should
be greater than the inductor current required to produce
maximum output power at the worst-case efficiency.
Worst-case efficiency typically occurs at the highest V IN
and highest ambient temperature. It is important to check
for consistency between the assumed MOSFET junction
temperatures and the resulting value of I LIMIT which heats
the MOSFET switches.
Caution should be used when setting the current limit based
on the R DS(ON) of the MOSFETs. The maximum current
limit is determined by the minimum MOSFET on-resistance.
Data sheets typically specify nominal and maximum values
for R DS(ON) but not a minimum. A reasonable assumption
is that the minimum R DS(ON) lies the same amount below
the typical value as the maximum lies above it. Consult the
MOSFET manufacturer for further guidelines.
To further limit current in the event of a short circuit to
ground, the LTC3878 includes foldback current limiting.
If the output falls by more than 50%, then the maximum
sense voltage is progressively lowered to about one-sixth
of its full value.
INTV CC Regulator
An internal P-channel low dropout regulator produces the
5.3V supply that powers the drivers and internal circuitry
within the LTC3878. The INTV CC pin can supply up to 50mA
RMS and must be bypassed to ground with a minimum of
1μF low ESR tantalum or ceramic capacitor (10V, X5R or
X7R). Output capacitance greater than 10μF is discouraged.
Good bypassing is necessary to supply the high transient
currents required by the MOSFET gate drivers.
Applications using large MOSFETs with a high input voltage
and high frequency of operation may cause the LTC3878
to exceed its maximum junction temperature rating or
RMS current rating. In continuous mode operation, this
current is I GATECHG = f OP (Q g(TOP) + Q g(BOT) ). The junction
temperature can be estimated from the equations given
in Note 2 of the Electrical Characteristics. For example,
with a 30V input supply, the LTC3878 is limited to less
than 16.5mA:
T J = 70°C + (16.5mA)(30)(110°C/W) = 125°C
Using the INTV CC regulator to supply external loads greater
than 5mA is discouraged. INTV CC is designed to supply
the LTC3878 with minimal external loading. When using
the regulator to supply larger external loads, carefully
consider all operating load conditions. During load steps
and soft-start, transient current requirements significantly
exceed the RMS values. Additional loading on INTV CC takes
away from the drive available to source gate charge during
high frequency transient load steps.
Soft-Start with the RUN/SS Pin
The RUN/SS pin both enables the LTC3878 and provides a
means of programmable current limited soft-start. Pulling
the RUN/SS pin below 0.7V puts the LTC3878 into a low
quiescent current shutdown (I Q < 15μA). Releasing the
pin allows an internal 1.2μA current source to charge up
the external timing capacitor C SS . If RUN/SS has been
pulled all the way to ground, there is a delay before start-
ing. This delay is created by charging C SS from ground
to 1.5V through a 1.2μA current source.
1 . 5 V
When the voltage on RUN/SS reaches 1.5V, the LTC3878
begins to switch. I TH is clamped to be no greater than
RUN/SS – 0.6V, and the device begins switching when
I TH exceeds 0.9V. As the RUN/SS voltage rises to 3V, the
clamp on I TH increases until it reaches the full-scale 2.4V
limit after an additional delay of 1.3s/μF. During this time,
the soft-start current limit is set to:
3878fa
相关PDF资料 |
PDF描述 |
|---|---|
| LD2-100-R | INDUCTOR PWR METL DRUM CORE 10UH |
| LTC3851IMSE-1#TRPBF | IC REG CTRLR BUCK PWM CM 16-MSOP |
| VI-2W1-EW-F4 | CONVERTER MOD DC/DC 12V 100W |
| LTC3851IMSE#TRPBF | IC REG CTRLR BUCK PWM CM 16-MSOP |
| EBA43DTAN | CONN EDGECARD 86POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3879EMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879EMSE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879EUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879EUD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3879IMSE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。