- 您现在的位置：买卖IC网 > PDF目录15291 > LTC3891EFE#TRPBF (Linear Technology)IC REG CTRLR BUCK PWM CM 20TSSOP PDF资料下载
参数资料
| 型号： | LTC3891EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 20TSSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 835kHz |
| 占空比： | 99% |
| 电源电压： | 4 V ~ 60 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3891
PIN FUNCTIONS
(QFN/eTSSOP)
PLLIN/MODE (Pin 1/Pin 3): External Synchronization
Input to Phase Detector and Forced Continuous Mode
Input. When an external clock is applied to this pin, the
phase-locked loop will force the rising TG signal to be
synchronized with the rising edge of the external clock,
and the regulator operates in forced continuous mode.
When not synchronizing to an external clock, this input
determines how the LTC3891 operates at light loads. Pull-
ing this pin to ground selects Burst Mode operation. An
internal 100k resistor to ground also invokes Burst Mode
operation when the pin is floated. Tying this pin to INTV CC
forces continuous inductor current operation. Tying this
pin to a voltage greater than 1.2V and less than INTV CC
–1.3V selects pulse-skipping operation.
SGND (Pins 2, 3, Exposed Pad Pin 21/Pins 4, 5,
Exposed Pad Pin 21): Small-signal ground, must be routed
separately from high current grounds to the common
(–) terminals of the C IN capacitor. Pins 2, 3/4, 5, must
both be electrically connected to small signal ground for
proper operation.The exposed pad must be soldered to
PCB ground for rated thermal performance.
RUN (Pin 4/Pin 6): Digital Run Control Input. Forcing this
pin below 1.16V shuts down the controller. Forcing this
pin below 0.7V shuts down the entire LTC3891, reducing
quiescent current to approximately 14μA.
SENSE – (Pin 5/Pin 7): The (–) Input to the Differential
Current Comparator. When greater than INTV CC – 0.5V, the
SENSE – pin supplies power to the current comparator.
SENSE + (Pin 6/Pin 8): The (+) input to the differential
current comparator is normally connected to DCR sensing
network or current sensing resistor. The ITH pin voltage and
controlled offsets between the SENSE – and SENSE + pins in
conjunction with R SENSE set the current trip threshold.
V FB (Pin 7/Pin 9): Receives the remotely sensed feed-
back voltage from an external resistive divider across
the output.
ITH (Pin 8/Pin 10): Error Amplifier Outputs and Switching
Regulator Compensation Point. The current comparator
trip point increases with this control voltage.
PGOOD (Pin 9/Pin 11): Open-Drain Logic Output. PGOOD
is pulled to ground when the voltage on the V FB pin is not
within 10% of its set point.
TG (Pin 10/Pin 12): High Current Gate Drives for Top
N-channel MOSFET. This is the output of floating driver
with a voltage swing equal to INTV CC superimposed on
the switch node voltage SW.
SW (Pin 11/ Pin 13): Switch Node Connection to Induc-
tor.
BOOST (Pin 12/Pin 14): Bootstrapped Supply to the Top-
side Floating Driver. A capacitor is connected between the
BOOST and SW pin and a Schottky diode is tied between
the BOOST and INTV CC pins. Voltage swing at the BOOST
pin is from INTV CC to (V IN + INTV CC ).
BG (Pin 13/Pin 15): High Current Gate Drive for Bottom
(Synchronous) N-channel MOSFET. Voltage swing at this
pin is from ground to INTV CC .
INTV CC (Pin 14/Pin 16): Output of the Internal Linear
Low Dropout Regulator. The driver and control circuits
are powered from this voltage source. Must be decoupled
to PGND with a minimum of 2.2μF ceramic or other low
ESR capacitor. Do not use the INTV CC pin for any other
purpose.
EXTV CC (Pin 15/Pin 17): External Power Input to an
Internal LDO Connected to INTV CC . This LDO supplies
INTV CC power, bypassing the internal LDO powered from
V IN whenever EXTV CC is higher than 4.7V. See EXTV CC
Connection in the Applications Information section. Do
not float or exceed 14V on this pin.
PGND (Pin 16/Pin 18): Driver Power Ground. Connects to
the source of bottom (synchronous) N-channel MOSFET
and the (–) terminal of C IN .
V IN (Pin 17/Pin 19): Main Supply Pin. A bypass capacitor
should be tied between this pin and the SGND pins.
I LIM (Pin 18/Pin 20): Current Comparator Sense Voltage
Range Inputs. Tying this pin to SGND, FLOAT or INTV CC
sets the maximum current sense threshold to one of three
different levels for the comparator.
3891fa
9
相关PDF资料 |
PDF描述 |
|---|---|
| VI-2WF-EY-F1 | CONVERTER MOD DC/DC 72V 50W |
| VE-B5J-EV-F4 | CONVERTER MOD DC/DC 36V 150W |
| VE-B5J-EV-F3 | CONVERTER MOD DC/DC 36V 150W |
| LTC3856IUH#TRPBF | IC REG CTRLR BUCK PWM CM 38-QFN |
| VI-2WD-EY-F4 | CONVERTER MOD DC/DC 85V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3891EUDC#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3891EUDC#PBF | 制造商:Linear Technology 功能描述:IC DC-DC CONV 900kHz QFN20 |
| LTC3891EUDC#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3891HFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3891HFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。