参数资料
| 型号： | LTC4000IGN#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 25/40页 |
| 文件大小： | 0K |
| 描述： | IC CHARGER BATTERY 28-SSOP |
| 产品培训模块： | LTC4000 60V Battery Charging Controller and Power Management |
| 标准包装： | 2,500 |
| 系列： | PowerPath™ |
| 功能： | 充电管理，电源管理 |
| 电池化学： | 多化学 |
| 电源电压： | 3 V ~ 60 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 28-SSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
LTC4000
APPLICATIONS INFORMATION
GENERATOR OUTPUT
REGULATOR OUTPUT
WITH LARGE C C , SMALL R C
WITH REDUCED C C , SMALL R C
EFFECT OF INCREASED R C
FURTHER REDUCTION IN C C
MAY BE POSSIBLE
IMPROPER VALUES WILL
CAUSE OSCILLATIONS
4000 F13
Figure 13. Typical Output Transient Response at Various
Stability Level
If the regulator response is under damped with the initial
large value of C C , R C should be increased immediately before
larger values of C C are tried. This will normally bring about
the over damped starting condition for further iteration.
The optimum values for R C and C C normally means the
smallest value for C C and the largest value for R C which
still guarantee well damped response, and which result in
the largest loop bandwidth and hence loop settling that is
as rapid as possible. The reason for this approach is that
it minimizes the variations in output voltage caused by
input ripple voltage and output load transients.
A switching regulator which is grossly over damped will
never oscillate, but it may have unacceptably large output
transients following sudden changes in input voltage or
output loading. It may also suffer from excessive overshoot
problems on startup or short circuit recovery. To guarantee
acceptable loop stability under all conditions, the initial
values chosen for R C and C C should be checked under all
conditions of input voltage and load current. The simplest
way of accomplishing this is to apply load currents of
minimum, maximum and several points in between. At
each load current, input voltage is varied from minimum
to maximum while observing the settling waveform.
If large temperature variations are expected for the system,
stability checks should also be done at the temperature
extremes. There can be significant temperature varia-
tions in several key component parameters which affect
stability; in particular, input and output capacitor value
and their ESR, and inductor permeability. The external
converter parametric variations also need some consid-
eration especially the transfer function from the ITH/VC
pin voltage to the output variable (voltage or current). The
LTC4000 parameters that vary with temperature include
the transconductance and the output resistance of the
error amplifiers (A4-A7). For modest temperature varia-
tions, conservative over damping under worst-case room
temperature conditions is usually sufficient to guarantee
adequate stability at all temperatures.
One measure of stability margin is to vary the selected
values of both R C and C C by 2:1 in all four possible com-
binations. If the regulator response remains reasonably
well damped under all conditions, the regulator can be
considered fairly tolerant of parametric variations. Any
tendency towards an under damped (ringing) response
indicates that a more conservative compensation may
be needed.
4000fb
For more information www.linear.com/LTC4000
25
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4001EUF#TRPBF | IC CHARGER LI-ION BUCK 16-QFN |
| LTC4002EDD-8.4#TRPBF | IC CHARGER BATTERY LI-ION 10-DFN |
| LTC4006EGN-6#TRPBF | IC CHARGER BATTERY 4A 16-SSOP |
| LTC4007EGN#TRPBF | IC BATT CHARGER CTRLR 4A 24SSOP |
| LTC4008EGN#TRPBF | IC BATT CHARGER CTRLR 4A 20SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4000IUFD#PBF | 功能描述:IC CHARGER BATTERY 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:PowerPath™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4000IUFD#TRPBF | 功能描述:IC CHARGER BATTERY 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:PowerPath™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4000IUFD-1#PBF | 功能描述:IC BATT CHRGR MULTI-CHEM 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:PowerPath™ 标准包装:2,000 系列:Impedance Track™ 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.4 V ~ 2.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:带卷 (TR) 产品目录页面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名称:296-21665-2 |
| LTC4000IUFD-1#TRPBF | 功能描述:IC CHARGE MGMT MULTI CHEM 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:PowerPath™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4001 | 制造商:LINER 制造商全称:Linear Technology 功能描述:2A Synchronous Buck Li-Ion Charger |
发布紧急采购，3分钟左右您将得到回复。