- 您现在的位置：买卖IC网 > PDF目录16019 > LTC4050EMS-4.2#TRPBF (Linear Technology)IC BATT CHRG CNTRL LI-ION 10MSOP PDF资料下载
参数资料
| 型号： | LTC4050EMS-4.2#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/12页 |
| 文件大小： | 0K |
| 描述： | IC BATT CHRG CNTRL LI-ION 10MSOP |
| 标准包装： | 2,500 |
| 功能： | 充电管理 |
| 电池化学： | 锂离子（Li-Ion） |
| 电源电压： | 4.5 V ~ 10 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 带卷 (TR) |
LTC4050
APPLICATIO N S I N FOR M ATIO N
Charger Conditions
The charger is off when any of the following conditions exist:
the voltage at the V CC pin is below 4V, the voltage at the V CC
pin is greater than 4V but is less than 54mV above V BAT ,
the PROG pin is floating, the timer has timed out or the
thermistor temperature is outside the acceptable range. In
this condition, the DRV pin is pulled to V CC and the internal
resistor divider is disconnected to reduce the current drain
on the battery.
Undervoltage Lockout (UVLO)
An internal undervoltage lockout circuit monitors the input
voltage and keeps the charger in shutdown mode until V CC
rises above the undervoltage lockout threshold of 4V. To
prevent oscillation around V CC = 4V, the UVLO circuit has
built-in hysteresis.
Trickle Charge and Defective Battery Detection
At the beginning of the charging sequence, if the battery
voltage is low (below 2.49V), the charger goes into trickle
mode. In this mode, the charge current is reduced to 10%
of the full-scale current. If the low cell voltage persists for
one quarter of the total charge time, the battery is consid-
ered defective, the charge cycle is terminated and the
CHRG pin output becomes high impedance.
Shutdown
The LTC4050 can be forced into shutdown by floating the
PROG pin and allowing the internal 2.3 μ A current source
to pull the pin above the 3.6V shutdown threshold voltage.
In shutdown, the DRV pin is pulled up to V CC , turning off
the external P-channel MOSFET and resetting the internal
timer.
V +
8
Programming Charge Current
The formula for the battery charge current (see Block
Diagram) is:
I BAT = (I PROG )(800 ? /R SENSE )
= (2.47V/R PROG )(800 ? /R SENSE ) or
R PROG = (2.47V/I BAT )(800 ? /R SENSE )
where R PROG is the total resistance from the PROG pin to
ground.
For example, if 0.5A charge current is needed, select a
value for R SENSE that will drop 100mV at the maximum
charge current. R SENSE = 0.1V/0.5A = 0.2 ? , then calculate:
R PROG = (2.47V/500mA)(800 ? /0.2 ? ) = 19.76k
For best stability over temperature and time, 1% resistors
are recommended. The closest 1% resistor value is 19.6k.
Programming the Timer
The programmable timer terminates the charge cycle.
Typically when charging at a 1C rate, a discharged Li-Ion
battery will become fully charged in 3 hours. For lower
charge current rates, extend the time accordingly. The
length of the timer is programmed by an external capaci-
tor at the TIMER pin. The total charge time is:
Time (Hours) = (3 Hours) ? (C TIMER /0.1 μ F) or
C TIMER = 0.1 μ F ? Time (Hours)/3 Hours
The timer starts when an input voltage greater than 4V is
applied and the program resistor is connected to ground.
After a time-out occurs, the CHRG output will go high
impedance to indicate that charging has stopped. To dis-
able the timer function, short the TIMER pin to GND.
V DD
V CC
LTC4050
CHRG
3
400k
2k
μ PROCESSOR
OUT
IN
4050 F01
Figure 1. Microprocessor Interface
4050f
8
相关PDF资料 |
PDF描述 |
|---|---|
| GCA28DTBH | CONN EDGECARD 56POS R/A .125 SLD |
| GCA28DTBD | CONN EDGECARD 56POS R/A .125 SLD |
| UWZ1E101MCL1GS | CAP ALUM 100UF 25V 20% SMD |
| GCA28DTAN | CONN EDGECARD 56POS R/A .125 SLD |
| UWT1H330MCL1GS | CAP ALUM 33UF 50V 20% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4052 | 制造商:LINER 制造商全称:Linear Technology 功能描述:150mA Standalone Linear Li-Ion Battery Charger in ThinSOT |
| LTC4052-4.2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Lithium-Ion Battery Pulse Charger with Overcurrent Protection |
| LTC4052-42 | 制造商:LINEAR 制造商全称:LINEAR 功能描述:Lithium-Ion Battery Pulse Charger with Overcurrent Protection |
| LTC4052EMS8E-4.2 | 功能描述:IC CHARGER PULSE LI-ION 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:61 系列:- 功能:电源管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:4.35 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:22-WFDFN 裸露焊盘 供应商设备封装:22-DFN（6x3）裸露焊盘 包装:管件 |
| LTC4052EMS8E-4.2#PBF | 功能描述:IC CHARGER PULSE LI-ION 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
发布紧急采购，3分钟左右您将得到回复。