- 您现在的位置：买卖IC网 > PDF目录11620 > LTC4315CDE#PBF (Linear Technology)IC 2WIRE BUS BUFFER 12DFN PDF资料下载
参数资料
| 型号： | LTC4315CDE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 2/20页 |
| 文件大小： | 0K |
| 描述： | IC 2WIRE BUS BUFFER 12DFN |
| 标准包装： | 91 |
| 类型： | 2线总线缓冲器 |
| Tx/Rx类型： | I²C Logic |
| 电容 - 输入： | 10pF |
| 电源电压： | 2.9 V ~ 5.5 V |
| 电流 - 电源： | 8.1mA |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 供应商设备封装： | 12-DFN（4x3） |
| 包装： | 管件 |
LTC4315
10
4315f
If VCC2 is tied low, output RTAs are disabled independent of
the state of the ACC pin. Using a combination of the ACC pin
and the VCC2 voltage, the input and output side RTAs can
be controlled independently. The RTAs are also internally
disabled during power up, VCC2 transitions described in
the Operation section and during a bus stuck low event.
The RTAs when activated pull the bus up to
0.9 VCC and 0.9 VCC2 on the input and output sides of
the SDA and SCL pins. Independent supply voltages VCC
and VCC2 maximize acceleration range on both inputs and
outputs by allowing the RTA turn-off voltage to be set inde-
pendently on the two sides. In order to prevent bus overdrive
by the RTA, the bus supplies on the input and output sides
of the LTC4315 must be greater than or equal to 0.9 VCC
and 0.9 VCC2respectively.AnexampleisshowninFigure3
where the input bus voltage is greater than VCC. During a
rising edge, the input bus rise rate will be accelerated by
the RTA up to a voltage of 2.97V after which the bus rise
rate will reduce to a value that is determined by the bus
current and bus capacitance. The RTA turn-off voltage is
less than the bus supply and the bus is not over driven.
This can also be accomplished by tying VCC to the input
bus supply and VCC2 to the output bus supply as shown
in Figure 4. In this case the input and output busses are
accelerated to 2.97V and 2.25V respectively
APPLICATIONS INFORMATION
PULL-UP RESISTOR VALUE SELECTION
To guarantee that the RTAs are activated during a rising
edge, the bus must rise on its own with a positive slew
rate of at least 0.4V/μs. To achieve this, choose a maximum
RBUS using the formula:
RBUS ≤
VDD,BUS(MIN) – VRTA(TH)
(
)
0.4
V
s
CBUS
(1)
RBUS is the bus pull-up resistor, VDD,BUS(MIN) is the
minimum bus pull-up supply voltage, VRTA(TH) is the
maximum voltage at which the RTA turns on and CBUS is
the equivalent bus capacitance. RBUS must also be large
enough to guarantee that:
R
BUS ≥
V
DD,BUS(MAX) – 0.4V
(
)
4mA
(2)
This criterion ensures that the maximum bus current is
less than 4mA.
Figure 3. Level Shift Application Where the SDAIN, SCLIN Bus
Pull-Up Supply Voltages are Higher Than the Supply Voltages of
the LTC4315
Figure 4. Level Shift Application Where the LTC4315 VCC and
VCC2 Pins are Connected to the Bus Pull-Up Supply Voltages
LTC4315
GND
VCC
VCC2
4315 F03
READY
SCLOUT
SDAOUT
FAULT
DISCEN
ENABLE
SCL1
SDA1
R2
10k
R5
10k
R6
10k
R4
10k
R3
10k
R1
10k
C1
0.01μF
3.3V
READY
SCL2
SDA2
FAULT
5V
SCLIN
SDAIN
ACC
LTC4315
GND
VCC
VCC2
4315 F04
READY
SCLOUT
SDAOUT
FAULT
DISCEN
ENABLE
SCLIN
SDAIN
ACC
SCL1
SDA1
R2
10k
R5
10k
R6
10k
R4
10k
R3
10k
R1
10k
C1
0.01μF
3.3V
READY
SCL2
SDA2
FAULT
2.5V
C2
0.01μF
相关PDF资料 |
PDF描述 |
|---|---|
| PT08E-14-19P | CONN PLUG 19 POS R/A W/PINS |
| VI-J6R-IZ-B1 | CONVERTER MOD DC/DC 7.5V 25W |
| D38999/20KE99SN | CONN RCPT 23POS WALL MNT W/SCKT |
| VI-J6R-IY-F4 | CONVERTER MOD DC/DC 7.5V 50W |
| LTC4313CDD-2#PBF | IC 2WIRE BUS BUFFER 8DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4315CMS#PBF | 功能描述:IC 2WIRE BUS BUFFER 12MSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4315CMS#TRPBF | 功能描述:IC 2WIRE BUS BUFFER 12MSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4315IDE#PBF | 功能描述:IC 2WIRE BUS BUFFER 12DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4315IDE#TRPBF | 功能描述:IC 2WIRE BUS BUFFER 12DFN RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
| LTC4315IMS#PBF | 功能描述:IC 2WIRE BUS BUFFER 12MSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 信号缓冲器，中继器，分配器 系列:- 标准包装:160 系列:- 类型:转发器 Tx/Rx类型:以太网 延迟时间:- 电容 - 输入:- 电源电压:2.37 V ~ 2.63 V 电流 - 电源:60mA 安装类型:表面贴装 封装/外壳:64-TQFP 裸露焊盘 供应商设备封装:64-TQFP-EP（10x10） 包装:托盘 其它名称:Q5134101 |
发布紧急采购，3分钟左右您将得到回复。