- 您现在的位置：买卖IC网 > PDF目录10090 > LTC487CN (Linear Technology)IC DVR RS485 LOW PWR QUAD 16-DIP PDF资料下载
参数资料
| 型号： | LTC487CN |
| 厂商： | Linear Technology |
| 文件页数： | 11/12页 |
| 文件大小： | 0K |
| 描述： | IC DVR RS485 LOW PWR QUAD 16-DIP |
| 标准包装： | 25 |
| 类型： | 驱动器 |
| 驱动器/接收器数： | 4/0 |
| 规程： | RS422，RS485 |
| 电源电压： | 4.75 V ~ 5.25 V |
| 安装类型： | 通孔 |
| 封装/外壳： | 16-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 16-PDIP |
| 包装： | 管件 |
LTC487
487fc
applicaTions inForMaTion
AC Cable Termination
Cable termination resistors are necessary to prevent un-
wanted reflections, but they consume power. The typical
differential output voltage of the driver is 2V when the
cable is terminated with two 120 resistors, causing
33mA of DC current to flow in the cable when no data is
being sent. This DC current is about 220 times greater than
the supply current of the LTC487. One way to eliminate
the unwanted current is by AC coupling the termination
resistors as shown in Figure 10.
LTC487 TA11
C = LINE LENGTH (FT) 16.3pF
120
RECEIVER
RX
C
Figure 10. AC-Coupled Termination
The coupling capacitor must allow high-frequency energy
to flow to the termination, but block DC and low frequen-
cies. The dividing line between high and low frequency
depends on the length of the cable. The coupling ca-
pacitor must pass frequencies above the point where the
line represents an electrical one-tenth wavelength. The
value of the coupling capacitor should therefore be set at
16.3pF per foot of cable length for 120 cables. With the
coupling capacitors in place, power is consumed only
on the signal edges, and not when the driver output is
idling at a 1 or 0 state. A 100nF capacitor is adequate for
lines up to 4000 feet in length. Be aware that the power
savings start to decrease once the data rate surpasses
1/(120 C).
Receiver Open-Circuit Fail-Safe
Some data encoding schemes require that the output of
the receiver maintains a known state (usually a logic 1)
when the data is finished transmitting and all drivers on
the line are forced into three-state. All LTC RS485 receivers
have a fail-safe feature which guarantees the output to be
in a logic 1 state when the receiver inputs are left floating
(open-circuit). However, when the cable is terminated with
120, the differential inputs to the receiver are shorted
together, not left floating. Because the receiver has about
70mV of hysteresis, the receiver output will maintain the
last data bit received.
If the receiver output must be forced to a known state, the
circuits of Figure 11 can be used.
LTC487 TA12
140
RECEIVER
RX
5V
1.5k
RECEIVER
RX
5V
110
130
110
130
120
RECEIVER
RX
C
5V
100k
1.5k
Figure 11. Forcing ‘0’ When All Drivers Are Off
The termination resistors are used to generate a DC
bias which forces the receiver output to a known state,
in this case a logic 0. The first method consumes about
208mW and the second about 8mW. The lowest power
solution is to use an AC termination with a pull-up resis-
tor. Simply swap the receiver inputs for data protocols
ending in logic 1.
Fault Protection
All of LTC’s RS485 products are protected against ESD
transients up to 2kV using the human body model
(100pF, 1.5k). However, some applications need more
protection. The best protection method is to connect a
bidirectional TransZorb from each line side pin to ground
(Figure 12).
相关PDF资料 |
PDF描述 |
|---|---|
| LTC486CN | IC DVR RS485 LOW PWR QUAD 16-DIP |
| MS27466E11F5S | CONN RCPT 5POS WALL MT W/SCKT |
| MS3100E16-10PW | CONN RCPT 3POS WALL MNT W/PINS |
| LTC1383IN#PBF | IC TXRX 5V RS232 LOW PWR 16-DIP |
| LTC1742CFW#PBF | IC ADC 14BIT 65MSPS 48-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC487CN#PBF | 功能描述:IC DVR RS485 LOW PWR QUAD 16-DIP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1 系列:- 类型:线路收发器 驱动器/接收器数:5/3 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC 包装:Digi-Reel® 产品目录页面:918 (CN2011-ZH PDF) 其它名称:296-25096-6 |
| LTC487CNPBF | 制造商:Linear Technology 功能描述:Quad RS485 line driver,LTC487CN DIP16 |
| LTC487CSW | 功能描述:IC DVR RS485 LOW PWR QUAD 16SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:27 系列:- 类型:收发器 驱动器/接收器数:3/3 规程:RS232，RS485 电源电压:4.75 V ~ 5.25 V 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC 包装:管件 |
| LTC487CSW#PBF | 功能描述:IC DVR RS485 LOW PWR QUAD 16SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:RS-232 & USB Transceiver 标准包装:2,000 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SSOP（0.209"，5.30mm 宽） 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:296-19849-2 |
| LTC487CSW#PBF | 制造商:Linear Technology 功能描述:RS485 Driver IC |
发布紧急采购，3分钟左右您将得到回复。