参数资料
型号: LTC6248CMS#PBF
厂商: Linear Technology
文件页数: 9/24页
文件大小: 0K
描述: IC OPAMP RRIO 180MHZ QUAD 16MSOP
标准包装: 37
放大器类型: 通用
电路数: 4
输出类型: 满摆幅
转换速率: 90 V/µs
增益带宽积: 180MHz
-3db带宽: 120MHz
电流 - 输入偏压: 400nA
电压 - 输入偏移: 100µV
电流 - 电源: 1.25mA
电流 - 输出 / 通道: 100mA
电压 - 电源,单路/双路(±): 2.5 V ~ 5.25 V,±1.25 V ~ 2.625 V
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 16-TFSOP(0.118",3.00mm 宽)
供应商设备封装: 16-MSOP
包装: 管件
LTC6246/LTC6247/LTC6248
624678fa
Thisisnotthelowestnoiseconfigurationforatransistor,as
downstream noise sources appear at the input completely
unattenuated. At low frequency, this is not a concern for a
transimpedance amplifier because the noise gain is 1 and
theoutputnoiseisdominatedbythe130nV/√Hzofthe1MΩ
R1. However, at increasing frequencies the capacitance
of the photodiode comes into play and the circuit noise
gain rises as the 1MΩ feedback looks back into lower and
lower impedance. But capacitor C2 comes to the rescue.
In addition to the obvious quenching of noise source R3,
capacitor C2 increases the JFET gain to about 30 at high
frequency effectively attenuating the downstream noise
contributions of R2 and the op amp input noise. Thus the
circuit achieves low input voltage noise at high frequency
where it is most needed. Amplifier LT6003 is used to
buffer the output voltage of the photodiode and R7 and
C4 are used to filter out the voltage noise of the LT6003.
Bandwidth to 700kHz was achieved with this circuit, with
integrated output noise being 160VRMSupto1MHz.Total
supply current was a very low 2.2mA.
Typical applicaTions
60dB 5.5MHz Gain Block
Figure 6 shows the LTC6247 configured as a low power
high gain high bandwidth block. Two amplifiers each
configured with a gain of 31V/V, are cascaded in series. A
660nF capacitor is used to limit the DC gain of the block
to around 30dB to minimize output offset voltage. Figure 7
shows the frequency response of the block. Mid-band
voltage gain is approximately 60dB with a –3dB frequency
of 5.5MHz, thus resulting in a gain-bandwidth product of
5.5GHz with only 1.9mA of quiescent supply current.
Single 2.7V Supply 4MHz 4th Order Butterworth Filter
Benefitting from low voltage operation and rail-to-rail
output, a low power filter that is suitable for antialiasing
can be built as shown in Figure 8. On a 2.7V supply the
filter has a passband of approximately 4MHz with 2VP-P
inputsignalandastopbandattenuationthatisgreaterthan
–75dB at 43MHz as shown in Figure 9. The resistor and
capacitor values can be scaled to reduce noise at the cost
of large signal power consumption and distortion.
624678 F06
+
1k
2.5V
–2.5V
2.5V
–2.5V
VIN
1/2LTC6247
50
1.5k
+
1/2LTC6247
660nF
VOUT
30k
Figure 6. 60dB 5.5MHz Gain Block
FREQUENCY (kHz)
10k
GAIN
(dB)
65
60
50
40
30
55
45
35
25
20
1M
100k
10M
624678 F07
VS = ±2.5V
VIN = 4.5mVP-P
RL = 1k
DC GAIN = 30dB
(DUE TO 660nF DC BLOCKING CAP)
OUTPUT OFFSET = 4mV
Figure 7
Figure 8. Single 2.7V Supply 4MHz
4th Order Butterworth Filter
624678 F08
56pF
+
VIN
1.1k
2.3k
1/2LTC6247
12pF
2.7k
2.7V
1.2V
910
+
1/2LTC6247
120pF
2.7V
VOUT
5.6pF
1.1k
FREQUENCY (kHz)
10k
GAIN
(dB)
10
–10
–30
–50
–70
–20
–40
–60
–80
–90
0
–100
100k
10M
1M
624678 F09
100M
VS = 2.7V, 0V
VIN = 2VP-P
RL = 1k to 0V
Figure 9
相关PDF资料
PDF描述
TMM-109-01-S-D-SM CONN HEADER 18POS DUAL 2MM SMD
RC0805FR-071M2L RES 1.20M OHM 1/8W 1% 0805 SMD
TLW-132-06-T-D CONN HEADER .100" 64POS DUAL TIN
69192-106HLF BERGSTIK II DR STRAIGHT RET
0034.3128 FUSE 12.5A 250V 5X20 T-LAG GLASS
相关代理商/技术参数
参数描述
LTC6248HMS#PBF 功能描述:IC OPAMP RRIO 180MHZ QUAD 16MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源,单路/双路(±):3 V ~ 32 V,±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP(0.173",4.40mm 宽) 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR
LTC6248HMS#TRPBF 功能描述:IC OPAMP RRIO 180MHZ QUAD 16MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:13 V/µs 增益带宽积:3MHz -3db带宽:- 电流 - 输入偏压:65pA 电压 - 输入偏移:3000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):7 V ~ 36 V,±3.5 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 供应商设备封装:8-PDIP 包装:管件
LTC6248IMS#PBF 功能描述:IC OPAMP R-R 120MHZ QUAD 16MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:3.5 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:30pA 电压 - 输入偏移:2000µV 电流 - 电源:200µA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):7 V ~ 36 V,±3.5 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 供应商设备封装:8-PDIP 包装:管件
LTC6248IMS#PBF 制造商:Linear Technology 功能描述:IC OP-AMP 180MHZ 90V/ MSOP-16
LTC6248IMS#TRPBF 功能描述:IC OPAMP RRIO 180MHZ QUAD 16MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:73 系列:Over-The-Top® 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.07 V/µs 增益带宽积:200kHz -3db带宽:- 电流 - 输入偏压:1nA 电压 - 输入偏移:285µV 电流 - 电源:50µA 电流 - 输出 / 通道:25mA 电压 - 电源,单路/双路(±):2 V ~ 44 V,±1 V ~ 22 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-WFDFN 裸露焊盘 供应商设备封装:16-DFN-EP(5x3) 包装:管件