- 您现在的位置：买卖IC网 > PDF目录5264 > LTC6256HTS8#TRMPBF (Linear Technology)IC OPAMP DUAL 6.5MHZ TSOT23-8 PDF资料下载
参数资料
| 型号： | LTC6256HTS8#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/24页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP DUAL 6.5MHZ TSOT23-8 |
| 标准包装： | 500 |
| 放大器类型： | 通用 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 1.8 V/µs |
| 增益带宽积： | 6.5MHz |
| -3db带宽： | 4.5MHz |
| 电流 - 输入偏压： | 5nA |
| 电压 - 输入偏移： | 100µV |
| 电流 - 电源： | 65µA |
| 电流 - 输出 / 通道： | 35mA |
| 电压 - 电源，单路/双路(±)： | 1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-8 薄型，TSOT-23-8 |
| 供应商设备封装： | TSOT-23-8 |
| 包装： | 带卷 (TR) |
LTC6255/LTC6256/LTC6257
625567fb
13
operAtion
ApplicAtions inForMAtion
The LTC6255 family input signal range extends beyond
the negative and positive power supplies. The output can
even extend all the way to the negative supply with the
proper external pull-down current source. Figure 1 depicts
a Simplified Schematic of the amplifier. The input stage
is comprised of two differential amplifiers, a PNP stage
Q1/Q2 and NPN stage Q3/Q4 that are active over different
ranges of common mode input voltage. The PNP stage
is active between the negative power supply to approxi-
mately 1V below the positive supply. As the input voltage
approaches the positive supply, transistor Q5 will steer the
tail current I1 to the current mirror Q6/Q7, activating the
NPN differential pair and the PNP pair becomes inactive
for the remaining input common mode range. Also for the
input stage, devices Q17, Q18 and Q19 act to cancel the
bias current of the PNP input pair. When Q1/Q2 is active,
the current in Q16 is controlled to be the same as the
current Q1/Q2. Thus, the base current of Q16 is normally
equal to the base current of the input devices of Q1/Q2.
Similar circuitry (not shown) is used to cancel the base
current of Q3/Q4. The buffer and output bias stage uses
a special compensation technique to take full advantage
of the process technology to drive high capacitive loads.
The common emitter topology of Q14/Q15 enables the
output to swing from rail to rail.
Low Supply Voltage and Low Power Consumption
The LTC6255 family of operational amplifiers can operate
with power supply voltages from 1.8V to 5.25V. Each am-
plifier draws only 65A. The low supply voltage capability
and low supply current are ideal for portable applications.
High Capacitive Load Driving Capability and Wide
Bandwidth
The LTC6255 family is optimized for wide bandwidth
low power applications. They have an extremely high
gain-bandwidth to power ratio and are unity gain stable.
When the load capacitance increases, the increased ca-
pacitance at the output pushed the non-dominant pole
to lower frequency in the open loop frequency response,
worsening the phase and gain margin. They are designed
to directly drive up to 100nF capacitive load in unity gain
configuration (see Typical Performance Characteristics,
Capacitive Load Handling). Higher gain configurations
tend to have better capacitive drive capability than lower
gain configurations due to lower closed loop bandwidth
and hence higher phase margin.
Low Input Referred Noise
The LTC6255 family provides a low input referred noise
of 20nV/√Hz at 1kHz. The noise density will grow slowly
with the frequency in wideband range. The average noise
voltage density over 3MHz range is less than 24nV/√Hz.
The LTC6255 family is ideal for low noise and low power
signal processing applications.
Low Input Offset Voltage
The LTC6255 family has a low offset voltage of 350μV
maximumwhichisessentialforprecisionapplications.The
offset voltage is trimmed with a proprietary trim algorithm
to ensure low offset voltage over the entire common mode
voltage range.
Low Input Bias Current
TheLTC6255familyusesabiascurrentcancellationcircuit
tocompensateforthebasecurrentoftheinputtransistors.
When the input common mode voltage is within 200mV
of either rail, the bias cancellation circuit are no longer ac-
tive. For common mode voltages ranging from 0.2V above
相关PDF资料 |
PDF描述 |
|---|---|
| 0031.8506 | FUSE 200MA 250VAC 5X20 FAST |
| AD8552ARZ-REEL7 | IC OPAMP CHOPPER R-R DUAL 8SOIC |
| 6-1879213-5 | RES 133 OHM 1/16W 0.1% 0402 |
| 0031.8516 | FUSE 2A 250VAC 5X20 FAST |
| 0031.8515 | FUSE 1.6A 250VAC 5X20 FAST |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC6256HTS8-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:6.5MHz, 65??A Power Efficient Rail-to-Rail I/O Op Amps |
| LTC6256IKC | 制造商:Linear Technology 功能描述:OP AMP DUAL 6.5MHZ 8UTDFN 制造商:Linear Technology 功能描述:OP AMP, DUAL, 6.5MHZ, 8UTDFN |
| LTC6256IKC#PBF | 制造商:Linear Technology 功能描述:LTC6256IKC#PBF |
| LTC6256IKC#TRMPBF | 功能描述:IC OP AMP RRIO DUAL 8UTDFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:2pA 电压 - 输入偏移:1000µV 电流 - 电源:85µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):1.8 V ~ 6 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:剪切带 (CT) 产品目录页面:680 (CN2011-ZH PDF) 其它名称:MCP6L04T-E/SLCT |
| LTC6256IKC#TRMPBF-ES | 功能描述:IC OPAMP DUAL 6.5MHZ 8-UTDFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。