参数资料
| 型号： | LTC6404IUD-4#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/28页 |
| 文件大小： | 0K |
| 描述： | IC AMP/DRIVER DIFF 16-QFN |
| 标准包装： | 2,500 |
| 类型： | ADC 驱动器 |
| 应用： | 数据采集 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 供应商设备封装： | 16-QFN-EP（3x3） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC6404
19
6404f
APPLICATIONS INFORMATION
Functional Description
The LTC6404 is a small outline, wide band, low noise,
and low distortion fully-differential amplier with accurate
output phase balancing. The LTC6404 is optimized to drive
low voltage, single-supply, differential input 14-bit to 18-bit
analog-to-digital converters (ADCs). The LTC6404’s output
is capable of swinging rail-to-rail on supplies as low as
2.7V, which makes the amplier ideal for converting ground
referenced, single-ended signals into DC level-shifted
differential signals in preparation for driving low voltage,
single-supply, differential input ADCs. Unlike traditional
op amps which have a single output, the LTC6404 has
two outputs to process signals differentially. This allows
for two times the signal swing in low voltage systems
when compared to single-ended output ampliers. The
balanced differential nature of the amplier also provides
even-order harmonic distortion cancellation, and less
susceptibility to common mode noise (e.g., power supply
noise). The LTC6404 can be used as a single-ended input
to differential output amplier, or as a differential input to
differential output amplier.
The LTC6404’s output common mode voltage, dened
as the average of the two output voltages, is independent
of the input common mode voltage, and is adjusted by
applying a voltage on the VOCM pin. If the pin is left open,
there is an internal resistive voltage divider that develops
a potential halfway between the V+ and V– pins. Whenever
this pin is not hard tied to a low impedance ground plane,
it is recommended that a high quality ceramic capacitor is
used to bypass the VOCM pin to a low impedance ground
plane (See Layout Considerations in this document). The
LTC6404’s internal common mode feedback path forces
accurate output phase balancing to reduce even order
harmonics, and centers each individual output about the
potential set by the VOCM pin.
VV
OUTCM
OCM
OUT
==
+
–
2
The outputs (OUT+ and OUT–) of the LTC6404 are capable
of swinging rail-to-rail. They can source or sink up to ap-
proximately 65mA of current.
Additional outputs (OUTF+ and OUTF–) are available that
provide ltered versions of the OUT+ and OUT– outputs. An
on-chip single pole RC passive lter band limits the ltered
outputs to a –3dB frequency of 88.5MHz. The user has a
choice of using the unltered outputs, the ltered outputs,
or modifying the ltered outputs to adjust the frequency
response by adding additional components.
In applications where the full bandwidth of the LTC6404 is
desired, the unltered outputs (OUT+ and OUT–) should be
used. The unltered outputs OUT+ and OUT– are designed
to drive 10pF to ground (or 5pF differentially). Capacitances
greater than 10pF will produce excess peaking, and can
be mitigated by placing at least 25
Ω in series with each
output pin.
Input Pin Protection
The LTC6404’s input stage is protected against differential
input voltages which exceed 1.4V by two pairs of back-
to-back diodes connected in anti-parallel series between
IN+ and IN– (Pins 6 and 15). In addition, the input pins
have steering diodes to either power supply. If the input
pair is overdriven, the current should be limited to under
10mA to prevent damage to the IC. The LTC6404 also has
steering diodes to either power supply on the VOCM and
SHDN pins (Pins 4 and 1), and if forced to voltages which
exceed either supply, they too, should be current-limited
to under 10mA.
SHDN Pin
If the SHDN pin (Pin 1) is pulled 2.1V below the posi-
tive supply, circuitry is activated which powers down
the LTC6404. The pin will have the Thevenin equivalent
impedance of approximately 66k
Ω to V+. If the pin is left
unconnected, an internal pull-up resistor of 150k will
keep the part in normal active operation. Care should
be taken to control leakage currents at this pin to under
1μA to prevent inadvertently putting the LTC6404 into
shutdown. In shutdown, all biasing current sources are
shut off, and the output pins, OUT+ and OUT–, will each
appear as open collectors with a non-linear capacitor in
parallel and steering diodes to either supply. Because of
the non-linear capacitance, the outputs still have the ability
to sink and source small amounts of transient current if
driven by signicant voltage transients. The inputs (IN+,
and IN–) appear as anti-parallel diodes which can conduct
相关PDF资料 |
PDF描述 |
|---|---|
| VE-24M-IV-F4 | CONVERTER MOD DC/DC 10V 150W |
| VE-24M-IV-F3 | CONVERTER MOD DC/DC 10V 150W |
| LTC6404IUD-2#TRPBF | IC AMP/DRIVER DIFF 16-QFN |
| LTC6404IUD-1#TRPBF | IC AMP/DRIVER DIFF 16-QFN |
| AD8138ARZ-RL | IC AMP DIFF LDIST LP 95MA 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC6405 | 制造商:LINER 制造商全称:Linear Technology 功能描述:2.7GHz, 5V, Low Noise, Rail-to-Rail Input Differential Amplifi er/Driver |
| LTC6405CMS8E | 制造商:LINER 制造商全称:Linear Technology 功能描述:2.7GHz, 5V, Low Noise,Rail-to-Rail Input Differential Amplifier/Driver |
| LTC6405CMS8E#PBF | 功能描述:IC AMP/DRVR DIFF R-R 5V 8-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 放大器 - 专用 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:60 系列:- 类型:可变增益放大器 应用:CATV 安装类型:表面贴装 封装/外壳:20-WQFN 裸露焊盘 供应商设备封装:20-TQFN-EP（5x5） 包装:托盘 |
| LTC6405CMS8E#TR | 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 2.7GHZ, 690V/US, MSOP-8, No. of Amplifiers:1, Input Offset Voltage:6mV, Bandwidth:2.7GHz, Amplifier Case Style:MSOP, No. of Pins:8, Supply Voltage Range:4.5V to 5.25V, Slew Rate:690V/s, Supply Current:18mA, MSL:- , RoHS Compliant: No |
| LTC6405CMS8E#TRPBF | 功能描述:IC AMP/DVR DIFF R-R 5V 8-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 放大器 - 专用 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:60 系列:- 类型:可变增益放大器 应用:CATV 安装类型:表面贴装 封装/外壳:20-WQFN 裸露焊盘 供应商设备封装:20-TQFN-EP（5x5） 包装:托盘 |
发布紧急采购，3分钟左右您将得到回复。