- 您现在的位置：买卖IC网 > PDF目录9471 > LTC6908CDCB-1#TRPBF (Linear Technology)IC OSC SILICON 10MHZ 6-DFN PDF资料下载
参数资料
| 型号： | LTC6908CDCB-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/16页 |
| 文件大小： | 0K |
| 描述： | IC OSC SILICON 10MHZ 6-DFN |
| 标准包装： | 2,500 |
| 类型： | 振荡器 - 硅 |
| 频率： | 50kHz ~ 10MHz |
| 电源电压： | 2.7 V ~ 5.5 V |
| 电流 - 电源： | 1.25mA |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 6-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 6-DFN-EP（2x3） |
| 安装类型： | 表面贴装 |
LTC6908-1/LTC6908-2
8
690812fa
OPERATIO
U
in conducted EMI results due to the reduced levels of input
and output ripple currents. The LTC6908-1 is ideal for use
with two single output switching regulators. The quadrature
outputs of the LTC6908-2, together with two dual output
switching regulators, provide the 0°, 90°, 180° and 270°
phased shifted clocks for four-phase control.
The rise and fall times are typically 6ns with a 5V supply
and 11ns with a 3V supply. An internal counter mutes
the outputs for the rst 64 clock cycles after power-up,
ensuring that the rst clock cycle is close to the desired
operating frequency.
Spread Spectrum Frequency Modulation
The LTC6908 provides the additional feature of spread
spectrum frequency modulation (SSFM). The oscillator’s
frequency is modulated by a pseudorandom noise (PRN)
signal to spread the oscillator’s energy over a wide fre-
quency band. This spreading decreases the peak electro-
magnetic radiation levels and improves electromagnetic
compatibility (EMC) performance.
The amount of frequency spreading is xed at 20% (±10%),
where frequency spreading is dened as:
Frequency Spreading (in %) = 100 ( fMAX – fMIN)/fOUT
The IMASTER current is a dynamic signal generated by a
multiplyingdigitaltoanalogconverter(MDAC)referencedto
ISETandlowpassltered.IMASTERvariesinapseudorandom
noise-like manner between 0.9 ISET and 1.1 ISET. This
causes the output frequency to vary in a pseudorandom
noise-like manner between 0.9 fOUT and 1.1 fOUT.
To disable the SSFM, connect one of the outputs to the
MOD pin. An AC detector circuit shuts down the modula-
tion circuitry if a frequency in the vicinity of the output
frequency is detected at the MOD pin.
As stated previously, the modulating waveform is a pseu-
dorandom noise-like waveform. The pseudorandom signal
is generated by a linear feedback shift register that is 15
bits long. The pseudorandom sequence will repeat every
(215 – 1) N clock cycles. This guarantees a repetition
rate below 20Hz for output frequencies up to 10MHz.
Seven bits of the shift register are sent in parallel to the
MDAC which produces the modulating current waveform.
Being a digitally generated signal, the output of the MDAC
is not a perfectly smooth waveform, but consists of (27)
discrete steps that change every shift register clock cycle.
Note that the shift register clock is the output frequency,
fOUT, divided by N, where N is the modulation rate divider
setting, which is determined by the state of the MOD pin.
The MOD pin should be tied to ground for the N = 16 set-
ting. Floating the MOD pin selects N = 32. The MOD pin
should be tied to V+ for the N = 64 setting.
The output of the MDAC is then ltered by a lowpass lter
with a corner frequency set to the modulation rate (fOUT/N).
This limits the frequency change rate and softens corners
of the waveform, but allows the waveform to fully settle at
each frequency step. The rise and fall times of this single
pole lter are approximately 0.35/fCORNER.Thisisbenecial
when the LTC6908 is used to clock switching regulators
as will be discussed in the Applications Information sec-
tion. Figure 4 illustrates how the output frequency varies
over time.
Figure 4
tREPEAT = ((2
15 – 1) N)/f
OUT
tSTEP = N/fOUT
fOUT + 10%
128 STEPS
tREPEAT
tSTEP
fOUT – 10%
TIME
FREQUENCY
690812 F04
相关PDF资料 |
PDF描述 |
|---|---|
| LTC6908CDCB-1#TRMPBF | IC OSC SILICON 10MHZ 6-DFN |
| AD9272BSVZRL-40 | IC ADC ASD OCTAL 40MSPS 100-TQFP |
| V28A15M200BF2 | CONVERTER MOD DC/DC 15V 200W |
| D38999/26WG16HN | CONN PLUG 16POS STRAIGHT W/PINS |
| MS27656T13B4SB | CONN RCPT 4POS WALL MNT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC6908CDCB-2 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Resistor Set SOT-23 Oscillator with Spread Spectrum Modulation |
| LTC6908CDCB-2#TRMPBF | 功能描述:IC OSC SILICON 10MHZ 6-DFN RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 可编程计时器和振荡器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:45 系列:- 类型:温度 - 补偿晶体振荡器（TCXO） 计数:- 频率:25MHz 电源电压:3.135 V ~ 3.465 V 电流 - 电源:1.5mA 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 包装:管件 供应商设备封装:16-SOIC W 安装类型:表面贴装 |
| LTC6908CDCB-2#TRPBF | 功能描述:IC OSC SILICON 10MHZ 6-DFN RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 可编程计时器和振荡器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:45 系列:- 类型:温度 - 补偿晶体振荡器（TCXO） 计数:- 频率:25MHz 电源电压:3.135 V ~ 3.465 V 电流 - 电源:1.5mA 工作温度:-40°C ~ 85°C 封装/外壳:16-SOIC（0.295"，7.50mm 宽） 包装:管件 供应商设备封装:16-SOIC W 安装类型:表面贴装 |
| LTC6908CS6-1 | 制造商:Linear Technology 功能描述:RESISTOR SET SOT-23 OSCILLATOR WITH SPREAD SPECTRUM MODULATION |
| LTC6908CS6-1#PBF | 制造商:Linear Technology 功能描述:Silicon Oscillator 6-Pin TSOT-23 制造商:Linear Technology 功能描述:OSCILLATOR 10MHZ 5.5V TSOT- 制造商:Linear Technology 功能描述:OSCILLATOR, 10MHZ, 5.5V, TSOT-23-6; Operating Mode:-; Frequency:10MHz; Supply Voltage Min:2.7V; Supply Voltage Max:5.5V; Digital IC Case Style:TSOT-23; No. of Pins:6; Clock External Input:Yes; Operating Temperature Min:0C ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。