- 您现在的位置：买卖IC网 > PDF目录44999 > LTH2911HTS8-5#TRPBF (LINEAR TECHNOLOGY CORP) POWER SUPPLY SUPPORT CKT, PDSO8 PDF资料下载
参数资料
| 型号： | LTH2911HTS8-5#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 电源管理 |
| 英文描述： | POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封装： | LEAD FREE, PLASTIC, MO-193, TSOT-23, 8 PIN |
| 文件页数： | 7/20页 |
| 文件大小： | 245K |
| 代理商： | LTH2911HTS8-5#TRPBF |
LTC2911
15
2911f
Output Pin Characteristics
The DC characteristics of the RST and PFO pull-down
strength are shown in the Typical Performance Character-
istics. The circuits that drive the pull-down of the output
pins are powered by the internal VCC (the greater voltage
of V1 or V2). During power-up, a VCC of at least 0.5V en-
sures a low output state. The VOL voltage depends on the
current sunk by RST and PFO as shown in the Figure 8.
The open-drain nature of the RST and PFO pins allows for
wire-ORed connections. For example, multiple LTC2911s
maybewire-ORedtomonitoradditionalsupplies,oropen-
drain logic can be connected to allow other conditions to
issue the reset and/or power-fail signals.
Output Pin Rise and Fall Time
The open-drain output pins (RST and PFO) contain weak
pull-up circuitry to V1. Use an external pull-up resistor
when the outputs need to pull beyond V1 and/or require
a faster rise time. Use external pull-up resistor values of
100k or less.
Whenoutputpinsareexternallypulleduptovoltageshigher
than V1, an internal network automatically protects the
weak pull-up circuitry from reverse currents. For a given
external load capacitance or CLOAD, the rise and fall times
can be estimated using Figure 9. The output pins have very
strongpull-downcapability.Witha150pFloadcapacitance
the reset line can pull down in about 30ns.
During power-up, with a capacitor connected to the TMR
pin, the part remains in the reset latch mode described
above until the 2.2A flowing out of the TMR pin charges
the capacitor beyond the VTMR(LATCH) threshold. For this
reason,largecapacitorswillextendtheRSTtimeoutduring
power-up. For example, if CTMR = 1F, the LTC2911 leaves
the reset latch mode 90ms after power-up and the RST
pin goes high after a 9 second timeout.
Figures 7a and 7b show how the TMR pin can be driven
low to latch the state of the RST pin or floated or driven
high for external and internal reset timing, respectively.
TMR
2911 F07a
SYSTEM
LOGIC
TMR
V1
2911 F07b
SYSTEM
LOGIC
Figure 7a. Open-Drain (or Three-State Buffer) Output.
Grounds TMR to Latch the State of RST. Floats TMR for
External Reset Timing
Figure 7b. V1 Powered Inverter. Grounds TMR
to Latch the State of RST. Drives TMR High for
Internal Reset Timing
APPLICATIONS INFORMATION
ISINK (A)
0
VOLTAGE
OUTPUT
LOW
(mV)
1200
1600
2000
80
2911 F08
800
400
0
20
10
40
30
60 70
90
50
100
VCC = 0.5V
Figure 8. Voltage Output Low vs ISINK at VCC = 0.5V
CLOAD (F)
10n
t F
ALL
OR
t RISE
(s)
1
100
100n
10
1m
10m
100p
1n
10n
2911 F09
1n
10p
tRISE LTC2911-1
tFALL LTC2911-1
Figure 9. tRISE and tFALL vs CLOAD
相关PDF资料 |
PDF描述 |
|---|---|
| LTI2911ITS8-1#TR | POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTI2911ITS8-5#TR | POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC2911CDDB-3#TR | POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTC2911CDDB-4#TRM | POWER SUPPLY SUPPORT CKT, PDSO8 |
| LTH2911HDDB-1#TRM | POWER SUPPLY SUPPORT CKT, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTH-301-05 | 功能描述:光学开关（透射型，光电晶体管输出） Photointerrupter Phototransistor RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装: |
| LTH-301-07 | 功能描述:光学开关（透射型，光电晶体管输出） Photointerrupter Phototransistor RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装: |
| LTH301-07 | 制造商:Lite-On Semiconductor Corporation 功能描述: |
| LTH-301-07P1 | 制造商:LITEON 制造商全称:Lite-On Technology Corporation 功能描述:Property of LITE-ON Only |
| LTH-301-07P2 | 制造商:LITEON 制造商全称:Lite-On Technology Corporation 功能描述:Property of LITE-ON Only |
发布紧急采购，3分钟左右您将得到回复。