参数资料
型号: LUPXA255A0C200
厂商: INTEL CORP
元件分类: 微控制器/微处理器
英文描述: 32-BIT, 200 MHz, MICROPROCESSOR, PBGA256
封装: 17 X 17 MM, 1.75 MM HEIGHT, LEAD FREE, PLASTIC, BGA-256
文件页数: 10/46页
文件大小: 1302K
代理商: LUPXA255A0C200
Package Information
18
Intel PXA255 Processor Electrical, Mechanical, and Thermal Specification
Table 4. Pin Description Notes
Note
Description
[1]
GPIO reset operation: Configured as GPIO inputs by default after any reset. The input buffers for these pins are
disabled to prevent current drain and the pins are pulled high with 10K to 60K internal resistors. The input paths
must be enabled and the pullups turned off by clearing the read-disable-hold (RDH) bit described in
Section 3.5.7, “Power Manager Sleep Status Register (PSSR)” on page 3-27 in the Intel PXA255 Processor
Developers Manual. Even though sleep mode sets the RDH bit, the pull-up resistors are not re-enabled by sleep
mode.
[2]
Crystal oscillator pins: These pins connect the external crystals to the on-chip oscillators. Refer to Section 3.3.1,
“32.768 kHz Oscillator” on page 3-4 in the Intel PXA255 Processor Developers Manual and Section 3.3.2,
“3.6864 MHz Oscillator” on page 3-4 of the Intel PXA255 Processor Developers Manual for details on sleep-
mode operation.
[3]
GPIO sleep operation: The state of these pins is determined by the corresponding PGSRn during the transition
into sleep mode. See Section 3.5.9, “Power Manager GPIO Sleep State Registers (PGSR0, PGSR1, PGSR2)”
and Section 4.1.3.2, “GPIO Pin Direction Registers (GPDR0, GPDR1, GPDR2)” on page 4-8 in the Intel
PXA255 Processor Developers Manual. If selected as an input, this pin does not drive during sleep. If selected
as an output, the value contained in the sleep-state register is driven out onto the pin and held there while the
PXA255 processor is in sleep mode.
GPIOs configured as inputs after exiting sleep mode cannot be used until PSSR[RDH] is cleared.
[4]
Static memory control pins: During sleep mode, these pins can be programmed to either drive the value in the
sleep-state register or be placed in Hi-Z. To select the Hi-Z state, software must set the FS bit in the power-
manager general-configuration register. If PCFR[FS] is not set, then during the transition to sleep these pins
function as described in [3], above. For nWE, nOE, and nCS[0], if PCFR[FS] is not set, they are driven high by
the memory controller before entering sleep. If PCFR[FS] is set, these pins are placed in Hi-Z.
[5]
PCMCIA control pins: During sleep mode: can be programmed either to drive the value in the sleep-state
register or be placed in Hi-Z. To select the Hi-Z state, software must set PCFR[FP]. If it is not set, then during the
transition to sleep these pins function as described in [3], above.
[6]
During sleep, this supply may be driven low. This supply must never be high impedance.
[7]
Remains powered in sleep mode.
相关PDF资料
PDF描述
LUPXA255A0C300 32-BIT, 300 MHz, MICROPROCESSOR, PBGA256
LV100 Voltage Transducer LV 100
LV200-AW Voltage Transducer LV 200-AW/2
LV25-1000 Voltage Transducer LV 25-1000
LV310N0010 SNAP ACTING/LIMIT SWITCH, SPDT, MOMENTARY, 2.45mm, PANEL MOUNT
相关代理商/技术参数
参数描述
LUPXA255A0C300 功能描述:IC MICRO PROCESSOR 300MHZ 256BGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:- 标准包装:2 系列:MPC8xx 处理器类型:32-位 MPC8xx PowerQUICC 特点:- 速度:133MHz 电压:3.3V 安装类型:表面贴装 封装/外壳:357-BBGA 供应商设备封装:357-PBGA(25x25) 包装:托盘
LUPXA255A0C400 功能描述:IC MICRO PROCESSOR 400MHZ 256BGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:- 标准包装:2 系列:MPC8xx 处理器类型:32-位 MPC8xx PowerQUICC 特点:- 速度:133MHz 电压:3.3V 安装类型:表面贴装 封装/外壳:357-BBGA 供应商设备封装:357-PBGA(25x25) 包装:托盘
LUPXA255A0E300 功能描述:IC MICRO PROCESSOR 300MHZ 256BGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:- 标准包装:2 系列:MPC8xx 处理器类型:32-位 MPC8xx PowerQUICC 特点:- 速度:133MHz 电压:3.3V 安装类型:表面贴装 封装/外壳:357-BBGA 供应商设备封装:357-PBGA(25x25) 包装:托盘
LUPXA255A0E400 功能描述:IC MICRO PROCESSOR 400MHZ 256BGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:- 标准包装:2 系列:MPC8xx 处理器类型:32-位 MPC8xx PowerQUICC 特点:- 速度:133MHz 电压:3.3V 安装类型:表面贴装 封装/外壳:357-BBGA 供应商设备封装:357-PBGA(25x25) 包装:托盘
LUR 110A 制造商:Crouzet 功能描述:Relay;E-Mech;Control;SPDT;Cur-Rtg 10A;Ctrl-V 110AC;Vol-Rtg 250AC;Plug-in;11 Pin