- 您现在的位置：买卖IC网 > PDF目录39437 > LV4985VH (SANYO SEMICONDUCTOR CO LTD) 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO14 PDF资料下载
参数资料
| 型号： | LV4985VH |
| 厂商： | SANYO SEMICONDUCTOR CO LTD |
| 元件分类： | 音频／视频放大 |
| 英文描述： | 1.2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO14 |
| 封装： | 0.225 INCH, HSSOP-14 |
| 文件页数： | 2/15页 |
| 文件大小： | 471K |
| 代理商： | LV4985VH |
LV4985VH
9. Electronic volume control (pin 10 control)
By changing voltage applied to the pin 10, the voltage gain of the built-in VCA(variable control amplifier) is varied.
Since the ripple component of applied voltage is generated, a stabilized power source must be used.
When controlling the amplifier using the PWM signal from the CPU, use a resistor and capacitor for DC conversion as
shown in Figure 4 and adjust the voltage gain by changing the pulse width of PWM signal. In this case, the frequency
of PWM signal used must be higher than audio frequency band.
PWM output
PWM signal
Discharge resistor
LV4985VH
VOL
CPU
R7
C8
R8
10
Fig. 4
10. Thermal protection circuit
The IC has a built-in thermal protection circuit that can reduce the risk of breakdown or degradation when the IC
becomes abnormally hot for some reason. When the internal chip junction temperature Tj rises to approximately 170
°C,
this protective circuit operates to cut off the power supply to the power amplifier block and stop signal output.
Operation recovers automatically when the chip temperature drops to approximately 130
°C.
Note that this circuit cannot always prevent breakdown or degradation, so sufficient care should be taken for using the
IC. When the chip becomes abnormally hot, immediately turn off the power and determine the cause.
11. Short-circuit between pins
Turning on the power supply with the short-circuit between terminals leads to the deterioration and destruction of IC.
When fixing the IC to the substrate, please check that the solder is not short-circuited between the terminals before
turning on the power.
12. Load Short-circuit
Leaving the IC in the load short-circuit for many hours leads to the deterioration and destruction of the IC.
The load must not be short-circuited absolutely.
13. Maximum rating
When the rated value used is just below to the absolute maximum ratings value, there is a possibility to exceed the
maximum rating value with slight extrusion variable. Also, it can be a destructive accident.
Please use within the absolute maximum ratings with sufficient variation margin of supply voltage.
In addition, the package of this IC has low thermal radiation characteristics, so secure sufficient thermal radiation by
providing a copper foil land on the printed circuit board near the heat sink.
No.A1568-10/15
相关PDF资料 |
PDF描述 |
|---|---|
| LV5072M | SWITCHING REGULATOR, PDSO12 |
| LV5072M | SWITCHING REGULATOR, PDSO12 |
| LV51131T | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LV51135T | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LV51137T | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LV4985VH_0912 | 制造商:SANYO 制造商全称:Sanyo Semicon Device 功能描述:For Portable Electronic Device Use 1.2W x 2ch BTL Power Amplifier |
| LV4985VH-TLM-H | 功能描述:功率放大器 BTL POWER AMPLIFIER RoHS:否 制造商:TriQuint Semiconductor 封装 / 箱体: 工作电源电压:28 V 电源电流:2.5 A 工作温度范围: 封装: |
| LV49-9000 | 制造商:FLOWLINE 功能描述:Sensor Accessory; Cable Hanger |
| LV4991M | 制造商:SANYO 制造商全称:Sanyo Semicon Device 功能描述:Monaural BTL Power Amplifier |
| LV4991M-TLM-H | 功能描述:功率放大器 BTL POWER AMPLIFIER RoHS:否 制造商:TriQuint Semiconductor 封装 / 箱体: 工作电源电压:28 V 电源电流:2.5 A 工作温度范围: 封装: |
发布紧急采购，3分钟左右您将得到回复。