参数资料
型号: LX1676-CLQTR
厂商: MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP
元件分类: 稳压器
英文描述: 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PQCC38
封装: PLASTIC, MLPQ-38
文件页数: 2/16页
文件大小: 387K
代理商: LX1676-CLQTR
LX1676
PRELIMINARY DATA SHEET
Microsemi
Integrated Products Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 10
WWW
.Microse
m
i
.CO
M
Mobile AMD Athlon
VRM Controller
I N T E GR A T ED
PRODUCT S
Copyright
2000
Revision: 0.4b, 9/14/2004
TH EORY OF O PERATION (CONTINUED)
OVER-CURRENT PROTECTION (PHASE 3)
The hysteretic phase has its own current limit protection
because with it’s very fast response time with a 100 nH
inductor the upper MOSFET cannot be allowed to stay on
during an output short circuit condition. The phase 3 over-
current sensing uses the RDS(ON) of the upper MOSFET
with a resistor RSET to determine the over current limit
point. A current source draws 50uA through RSET which
determines the required drop across the MOSFET
RDS(ON) to initiate a current limit condition.
50 uA
+
_
RSET
Q2
+
_
Current Limit
Comparator
Q1
Vin
RDS(ON)
Vout
400nS Delay
ILIM3
VS3
Figure 4 – Phase 3 Current Limit
Phase 3 RSET is calculated by:
uA
50
RDSon
ILimit
Rset
=
OVER VOLTAGE PROTECTION
An over voltage protection circuit monitors the output
voltage and will latch all three phases off if an over voltage
condition (greater than 2.35 V) is detected.
Both
MOSFETs for phase 3 will be held off and the lower
MOSFETs for phase 1 and 2 will be held on to discharge
the output capacitor till the output voltage drops below .85
volt, at .85 volts all MOSFETs will be turned off.
FAULT LOGIC
There are a number of possible states that will cause a
fault condition that will disable the output MOSFET
drivers. A fault condition will be caused by the following:
Enable (ENA) pin being pulled low
Over-current condition on either phase 1 or phase 3
Over Voltage output > 2.35V
Under Voltage output < 0.85V
In all cases except Over Voltage all MOSFET drivers
will be latched off. For an Over Voltage fault the lower
MOSFETs for phase 1 and 2 will be held on to discharge
the bulk capacitance on the output till a lower limit of .85
volts is reached then all MOSFETS will be turned off.
To reset a fault it necessary to cycle the ENA pin low
then back high or remove and reapply the input voltage
VIN.
The Under Voltage monitor is not enabled until the
output voltage has ramped up to the level commanded by
the DACOUT pin and the PWGD output in high.
PWM FREQUENCY
An external resistor sets the PWM frequency from the
ROSC pin to ground.
The equation for ROSC is:
()
9
e
100
f
K
1
ROSC
+
=
where ROSC is in K, f is in Hz, K=105e-12
AA
PP
LL
IICC
AA
TT
IIOO
NN
SS
相关PDF资料
PDF描述
LX1676-CPWTR 1.5 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO38
LX1732CDUT 1 A SWITCHING REGULATOR, 135 kHz SWITCHING FREQ-MAX, PDSO8
LX1801CLQ SPECIALTY ANALOG CIRCUIT, PQCC16
LX1801CLQ-TR SPECIALTY ANALOG CIRCUIT, PQCC16
LY5150ALH SPECIALTY ANALOG CIRCUIT, PBGA16
相关代理商/技术参数
参数描述
LX1676CPW 功能描述:IC CTRLR PS VRM BIPHASE 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器,DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP(0.173",4.40mm 宽) 供应商设备封装:30-TSSOP 包装:带卷 (TR)
LX1676-CPW 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Mobile AMD AthlonTM VRM Controller
LX1677 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:AMD64 Processor VRM Controller
LX1677 EVAL KIT 制造商:Microsemi Corporation 功能描述:PWM CONTROLLERS - Bulk
LX1677CLQ 功能描述:IC CTRLR VRM PS 2PHASE 38MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源,ICERA E400,E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA,WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR)