- 您现在的位置：买卖IC网 > PDF目录61639 > LX1681CDM-TR (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | LX1681CDM-TR |
| 厂商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | ROHS COMPLIANT, PLASTIC, SOIC-8 |
| 文件页数： | 4/9页 |
| 文件大小： | 199K |
| 代理商： | LX1681CDM-TR |
Microsemi
Linfinity Microelectronics Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 4
Copyright
2000
Rev. 1.1b,2005-03-09
WWW
.Microse
m
i
.CO
M
LX1681/1682
Voltage-Mode PWM Controllers
PRODUCTION DATA SHEET
TM
TH EORY OF O PERAT ION
GENERAL DESCRIPTION
The LX1681/82 are voltage-mode pulse-width modulation
controller integrated circuits. The internal oscillator and ramp
generator frequency is fixed at 200kHz. The devices have internal
compensation, so that no external compensation is required.
POWER UP and INITIALIZATION
At power up, the LX1681/82 monitors the supply voltage to
both the +5V and the +12V pins (there is no special requirement
for the sequence of the two supplies). Before both supplies reach
their under-voltage lock-out (UVLO) thresholds, the soft-start (SS)
pin is held low to prevent soft-start from beginning; the oscillator
control is disabled and the top MOSFET is kept OFF.
SOFT-START
Once the supplies are above the UVLO threshold, the soft-start
capacitor begins to be charged up by the reference through a 20k
internal resistor. The capacitor voltage at the SS pin rises as a
simple RC circuit. The SS pin is connected to the amplifier's non-
inverting input that controls the output voltage. The output voltage
will follow the SS pin voltage if sufficient charging current is
provided to the output capacitor. The simple RC soft-start allows
the output to rise faster at the beginning and slower at the end of
the soft-start interval. Thus, the required charging current into the
output capacitor is less at the end of the soft-start interval so
decreasing the possibility of an over-current. A comparator
monitors the SS pin voltage and indicates the end of soft-start
when SS pin voltage reaches 95% of VREF.
OVER-CURRENT PROTECTION (OCP) and HICCUP
The LX1681/1682 family uses the RDS(ON) of the upper
MOSFET, together with a resistor (RSET) to set the actual current
limit point. The comparator senses the current 1s after the top
MOSFET is switched on. Experiments have shown that the
MOSFET drain voltage will ring for 200-500ns after the gate is
turned on. In order to reduce inaccuracies due to ringing, a 1s
delay after gate turn-on is built into the current sense comparator.
The comparator draws a current (ISET), whose magnitude is 45A.
The set resistor is selected to set the current limit for the
application. When the sensed voltage across the RDS(ON) plus the
set resistor exceeds the 400mV V TRIP threshold, the OCP
comparator outputs a signal to reset the PWM latch and to start
hiccup mode. The soft-start capacitor (CSS) is discharged slowly
(10 times slower than when being charged up by RSS). When the
voltage on the SS/ENABLE pin reaches a 0.3V threshold, hiccup
finishes and the circuit soft-starts again. During hiccup, the top
MOSFET is OFF and the bottom MOSFET remains ON. Hiccup is
disabled during the soft-start interval, allowing the circuit to start
up with the maximum current. If the rise speed of the output
voltage is too fast, the required charging current to the output
capacitor may be higher than the limit-current. In this case, the
peak MOSFET current is regulated to the limit-current by the
current-sense comparator. If the MOSFET current still reaches its
limit after the soft-start finishes, the hiccup is triggered again. The
hiccup ensures the average heat generation on both MOSFET’s and
the average current to be much less than that in normal operation,
if the output has a short circuit. Over-current protection can also be
implemented using a sense resistor, instead of using the RDS(ON) of
the upper MOSFET, for greater set-point accuracy. See
Application Information section.
OSCILLATOR FREQUENCY
An internal oscillator sets the switching frequency at 200 kHz.
DD
EE
SS
CC
RR
IIPP
TT
IIOO
NN
相关PDF资料 |
PDF描述 |
|---|---|
| LX1734-CLM | 0.7 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO6 |
| LX7001CDM-TR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| LX7001ILP-TR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBCY3 |
| LXM1598-01 | SPECIALTY ANALOG CIRCUIT, DMA10 |
| LXM1612-12-01 | SPECIALTY ANALOG CIRCUIT, XMA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LX1681IDM | 功能描述:IC REG CTRLR DIVIDER PWM 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| LX1682 | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:VOLTAGE - MODE PWM CONTROLLERS |
| LX1682CDM | 功能描述:IC REG CTRLR DIVIDER PWM 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| LX1682CDMT | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Voltage-Mode SMPS Controller |
| LX1682CDM-TR | 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Voltage-Mode PWM Controllers |
发布紧急采购，3分钟左右您将得到回复。