- 您现在的位置：买卖IC网 > PDF目录80495 > M30622MHP-XXXGP 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP100 PDF资料下载
参数资料
| 型号： | M30622MHP-XXXGP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP100 |
| 封装： | 14 X 14 MM, 0.50 MM PITCH, PLASTIC, LQFP-100 |
| 文件页数： | 47/104页 |
| 文件大小： | 1313K |
| 代理商： | M30622MHP-XXXGP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页当前第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页
5. Electrical Characteristics
Rev.2.41
Jan 10, 2006
Page 45 of 96
REJ03B0001-0241
NOTES:
1.
Referenced to VCC1=4.5 to 5.5V, 3.0 to 3.6V at Topr = 0 to 60
°C (D3, D5, U3, U5) unless otherwise specified.
2.
n denotes the number of block erases.
3.
Program and Erase Endurance refers to the number of times a block erase can be performed.
If the program and erase endurance is n (n=100, 1,000, or 10,000), each block can be erased n times.
For example, if a 4 Kbytes block A is erased after writing 1 word data 2,048 times, each to a different address, this counts as
one program and erase endurance. Data cannot be written to the same address more than once without erasing the block.
(Rewrite prohibited)
4.
Maximum number of E/W cycles for which operation is guaranteed.
5.
Topr = -40 to 85
°C (D3, D7, U3, U7) / -20 to 85 °C (D5, D9, U5, U9).
6.
Referenced to VCC1 = 4.5 to 5.5V, 3.0 to 3.6V at Topr = -40 to 85
°C (D7, U7) / -20 to 85 °C (D9, U9) unless otherwise specified.
7.
Table 5.7 applies for block A or block 1 program and erase endurance > 1,000. Otherwise, use Table 5.6.
8.
To reduce the number of program and erase endurance when working with systems requiring numerous rewrites, write to
unused word addresses within the block instead of rewrite. Erase block only after all possible addresses are used. For
example, an 8-word program can be written 256 times maximum before erase becomes necessary.
Maintaining an equal number of erasure between block A and block 1 will also improve efficiency. It is important to track the
total number of times erasure is used.
9.
Should erase error occur during block erase, attempt to execute clear status register command, then block erase command
at least three times until erase error disappears.
10. Set the PM17 bit in the PM1 register to “1” (wait state) when executing more than 100 times rewrites (D7, D9, U7 and U9).
11. Customers desiring E/W failure rate information should contact their Renesas technical support representative.
Table 5.6
Flash Memory Version Electrical Characteristics (1) for 100 cycle products (D3, D5, U3,
U5)
Symbol
Parameter
Standard
Unit
Min.
Typ.
Max.
Program and Erase Endurance (3)
100
cycle
Word Program Time (VCC1=5.0V
)
25
200
s
Lock Bit Program Time
25
200
s
Block Erase Time
(VCC1=5.0V
)
4-Kbyte block
0.3
4
s
8-Kbyte block
0.3
4
s
32-Kbyte block
0.5
4
s
64-Kbyte block
0.8
4
s
Erase All Unlocked Blocks Time (2)
4×n
s
tPS
Flash Memory Circuit Stabilization Wait Time
15
s
Data Hold Time (5)
10
year
Table 5.7
Flash Memory Version Electrical Characteristics (6) for 10,000 cycle products (D7, D9,
U7, U9) (Block A and Block 1 (7))
Symbol
Parameter
Standard
Unit
Min.
Typ.
Max.
Program and Erase Endurance (3, 8, 9)
10,000 (4)
cycle
Word Program Time (VCC1=5.0V
)
25
s
Lock Bit Program Time
25
s
Block Erase Time
(VCC1=5.0V
)
4-Kbyte block
0.3
s
tPS
Flash Memory Circuit Stabilization Wait Time
15
s
Data Hold Time (5)
10
year
Table 5.8
Flash Memory Version Program / Erase Voltage and Read Operation Voltage
Characteristics (at Topr = 0 to 60
°C(D3, D5, U3, U5), Topr = -40 to 85 °C(D7, U7) / Topr =
-20 to 85
°C(D9, U9))
Flash Program, Erase Voltage
Flash Read Operation Voltage
VCC1 = 3.3 V ± 0.3 V or 5.0 V ± 0.5 V
VCC1=2.7 to 5.5 V
相关PDF资料 |
PDF描述 |
|---|---|
| M30624MHP-XXXGP | 16-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP100 |
| M30626FHPFP-D5 | 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP100 |
| M30626FHPFP | 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP100 |
| M30627FHPGP-U5 | 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP128 |
| M30875MH-XXXGP | 32-BIT, MROM, 32 MHz, MICROCONTROLLER, PQFP144 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M30622MWP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30622MWP-XXXFP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30622MWP-XXXGP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER |
| M30622S4-XXXFP | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY |
| M30622S4-XXXFS | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY |
发布紧急采购，3分钟左右您将得到回复。