参数资料
型号: M37221EAFP
元件分类: 微控制器/微处理器
英文描述: 8-BIT, OTPROM, 8.1 MHz, MICROCONTROLLER, PDSO42
封装: 0.450 INCH, 0.80 MM PITCH, PLASTIC, SSOP-42
文件页数: 45/112页
文件大小: 1207K
代理商: M37221EAFP
38
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
M37221M4H/M6H/M8H/MAH–XXXSP/FP
M37221EASP/FP
MITSUBISHI MICROCOMPUTERS
Rev. 1.0
(8) Bit 7: Communication mode specification bit
(master/slave specification bit: MST)
This bit is used for master/slave specification in data communica-
tions. When this bit is “0,” the slave is specified, so that a START
condition and a STOP condition generated by the master are received,
and data communication is performed in synchronization with the
clock generated by the master. When this bit is “1,” the master is
specified and a START condition and a STOP condition are gener-
ated, and also the clocks required for data communication are gen-
erated on the SCL.
The MST bit is cleared to “0” in any of the following conditions.
Immediately after completion of 1-byte data transmission when
arbitration lost is detected
When a STOP condition is detected.
When occurence of a START condition is disabled by the START
condition duplication prevention function (Note).
At reset
Fig. 8.6.7 I2C Status Register
b7 b6 b5 b4 b3 b2 b1 b0
I2C status register (S1) [Address 00D916]
I2C Status Register
0
3
4
5
6, 7
b7 b6
0
0 : Slave recieve mode
0
1 : Slave transmit mode
1
0 : Master recieve mode
1
1 : Master transmit mode
1
2
0
1
0
B
Name
Functions
After reset R W
Communication mode
specification bits
(TRX, MST)
0 : Bus free
1 : Bus busy
Bus busy flag (BB)
0 : Interrupt request issued
1 : No interrupt request issued
I2C-BUS interface interrupt
request bit (PIN)
0 : Not detected
1 : Detected
Arbitration lost detecting flag
(AL) (See note)
0 : Address mismatch
1 : Address match
Slave address comparison
flag (AAS) (See note)
0 : No general call detected
1 : General call detected
General call detecting flag
(AD0) (See note)
0 : Last bit = “0 ”
1 : Last bit = “1 ”
Last receive bit (LRB)
(See note)
Note : These bits and flags can be read out, but cannnot be written.
Indeterminate R —
R —
RW
R W
0
R W
(See note)
Fig. 8.6.8 Interrupt Request Signal Generation Timing
SCL
PIN
IICIRQ
Note: The START condition duplication prevention function disables the START
condition generation, bit counter reset, and SCL output, when the follow-
ing condition is satisfied:
a START condition is set by another master device.
相关PDF资料
PDF描述
MSP430F1101AIDWR 16-BIT, FLASH, 8 MHz, RISC MICROCONTROLLER, PDSO20
MB89538ACPFV 8-BIT, MROM, 12.5 MHz, MICROCONTROLLER, PQFP64
M37221MAH-XXXFP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDSO42
M37221MAH-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP42
MC68EN360ZP25VL 4 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PBGA357
相关代理商/技术参数
参数描述
M37221EASP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221EF 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221EFSP 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221FP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER
M37221M4H 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER