参数资料
型号: M37477M8TXXXFP
元件分类: 微控制器/微处理器
英文描述: 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDSO32
封装: PLASTIC, SOP-32
文件页数: 21/50页
文件大小: 693K
代理商: M37477M8TXXXFP
25
MITSUBISHI MICROCOMPUTERS
7477/ 7478 GROUP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
Fig. 18 Timing diagram at reset
Fig. 16 Example of reset circuit
Fig. 17 Internal state of microcomputer at reset
(1) Port P0 direction register
(C116) …
(2) Port P1 direction register
(C316) …
(3) Port P4 direction register
(C916) …
(4) P0 pull-up control register
(D016) …
(5) P1–P5 pull-up control register (Note 1) (D116) …
(6) Edge selection register (EG)
(D416) …
(7) A-D control register
(D916) …
(8) Serial I/O status register
(E116) …
(9) Serial I/O control register
(E216) …
(10) UART control register
(E316) …
(11) Timer 12 mode register (T12M)
(F816) …
(12) Timer 34 mode register (T34M)
(F916) …
(13) Timer mode register 2 (TM2)
(FA16) …
(14) CPU mode register (CM)
(FB16) …
(15) Interrupt request register 1
(FC16) …
(16) Interrupt request register 2
(FD16) …
(17) Interrupt control register 1
(FE16) …
(18) Interrupt control register 2
(FF16) …
(19) Program counter
(PCH) …
(PCL) …
(20) Processor status register
(PS) …
0016
00 0 0
00
0 0
00 0 0 0 0
01 0 0 0
0 0 00 00 0
00 0 0
00
0 0
00 0 0
00 0
00
0 00 0
00 0
00
0 00 0
00 0
1
0016
Contents of address FFFF16
Contents of address FFFE16
Notes 1 : This address is allocated P1–P4 pull-up control register for the
7477 group. Bit 6 is not used.
2 : Since the contents of both registers other than those listed
above (including timers and the transmit/receive buffer register)
are undefined at reset, it is necessary to set initial values.
Address
RESET CIRCUIT
The 7477/7478 group is reset according to the sequence shown in
Figure 18. It starts the program from the address formed by using
the content of address FFFF16 as the high order address and the
content of the address FFFE16 as the low order address, when the
RESET pin is held at “L” level for no less than 2
s while the power
voltage is in the recommended operating condition and then re-
turned to “H” level.
The internal initializations following reset are shown in Figure 17.
Example of reset circuit is Figure 16. Immediately after reset, timer
3 and timer 4 are connected, and counts the f(XIN) divided by 16.
At this time, FF16 is set to timer 3, and 0716 is set to timer 4. The
reset is cleared when timer 4 overflows.
RESET
VCC
7477/7478 group
00, S
00, S-1
00, S-2
FFFE16
FFFF16
ADH,L
PCH
PCL
PS
ADL
ADH
XIN
φ
RESET
Internal
Address
Data
SYNC
32768 counts of f(XIN)
Reset address from
the vector table
Notes 1 : Frequency relation of X IN and
φ is f(XIN)=2φ.
2 : The mark “?” means that the address is changeable depending
upon the previous state.
RESET
?
相关PDF资料
PDF描述
M38203M2LXXXGP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP80
M37481M8-XXXSP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PDIP42
MPC8321ECZQAFDCA 32-BIT, 333 MHz, RISC PROCESSOR, PBGA516
MB96F348YWAPMC-GE2 16-BIT, FLASH, 56 MHz, MICROCONTROLLER, PQFP100
MB96F356ASAPMC1-GSE2 16-BIT, FLASH, 56 MHz, MICROCONTROLLER, PQFP64
相关代理商/技术参数
参数描述
M37477M8TXXXSP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER 740 FAMILY / 7470 SERIES
M37477M8TXXXSP/FP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37477M8-XXXFP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER 740 FAMILY / 7470 SERIES
M37477M8-XXXSP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER 740 FAMILY / 7470 SERIES
M37477M8-XXXSP/FP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER