参数资料
型号: M37534E8FP
元件分类: 微控制器/微处理器
英文描述: 8-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO36
封装: 0.450 INCH, PLASTIC, SSOP-36
文件页数: 14/53页
文件大小: 680K
代理商: M37534E8FP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
7534 Group
MITSUBISHI MICROCOMPUTERS
21
Fig. 22 Block diagram of UART serial I/O
Fig. 23 Operation of UART serial I/O function
Serial I/O
qSerial I/O1
Asynchronous serial I/O (UART) mode
Serial I/O1 can be used as an asynchronous (UART) serial I/O. A
dedicated timer (baud rate generator) is also provided for baud rate
generation when serial I/O1 is in operation.
Eight serial data transfer formats can be selected, and the transfer
formats to be used by a transmitter and a receiver must be identi-
cal.
Each of the transmit and receive shift registers has a buffer register
(the same address on memory). Since the shift register cannot be
written to or read from directly, transmit data is written to the trans-
mit buffer, and receive data is read from the respective buffer regis-
ters. These buffer registers can also hold the next data to be trans-
mitted and receive 2-byte receive data in succession.
By selecting “1” for continuous transmit valid bit (bit 2 of SIO1CON),
continuous transmission of the same data is made possible.
This can be used as a simplified PWM.
OE
PE FE
1/16
XIN
1/4
1/16
Data bus
Receive Buffer Register
Address
(001816)
Receive Shift Register
Receive buffer full flag (RBF)
Receive interrupt request (RI)
ST Detector
SP Detector
UART Control Register
Address (001A16)
Character length selection bit
7-bit
8-bit
Address (001B16)
Clock Control Circuit
Baud Rate Generator
Division ratio 1/(n+1)
Address (001C16)
BRG count source selection bit
Transmit Buffer Register
Data bus
Transmit Shift Register
Address
(001816)
Transmit shift register shift
completion flag (TSC)
Transmit buffer empty flag (TBE)
Transmit interrupt request (TI)
Address (001916)
Character length selection bit
Transmit interrupt source selection bit
Continuous transmit valid bit
Serial I/O1 control register
P10/RXD
P11/TXD
Serial I/O1 status register
ST/SP/PA Generator
TSC=0
TBE=1
RBF=0
TBE=0
RBF=1
ST
D0
D1
SP
D0
D1
ST
SP
TBE=1
TSC=1*
ST
D0
D1
SP
D0
D1
ST
SP
1 : Error flag detection occurs at the same time that the RBF flag becomes “1” (at 1st stop bit, during reception).
2 : The transmit interrupt (TI) can be selected to occur when either the TBE or TSC flag becomes “1”, depending on the setting of the transmit
interrupt source selection bit (TIC) of the serial I/O1 control register.
3 : The receive interrupt (RI) is set when the RBF flag becomes “1”.
4 : After data is written to the transmit buffer when TSC = 1, 0.5 to 1.5 cycles of the data shift cycle is necessary until changing to TSC = 0.
Notes
Transmit/Receive Clock
Transmit Buffer Register
Write Signal
Serial Output TXD
Receive Buffer Register
Read Signal
Serial Input RXD
* Generated at second bit in 2-stop -bit
mode
1 Start Bit
7 or 8 Data Bit
1 or 0 Parity Bit
1 or 2 Stop Bit
相关PDF资料
PDF描述
M38224M6HXXXFP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
M38227ECFP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP80
M38227MCHXXXFP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
M38227MCHXXXHP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
MC68HC11N4VFN3 8-BIT, MROM, 3 MHz, MICROCONTROLLER, PQCC84
相关代理商/技术参数
参数描述
M37534E8SP 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37534M4 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37534M4-XXXFP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37534M4-XXXGP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M37534M4-XXXSP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER